Airgain AirgainConnect AC-HPUE User manual

1
Sierra Wireless MG90
Cradlepoint IBR900
LAN WAN
Ethernet WAN Ethernet WAN
4. Connect the HPUE USB and power cable to the Ethernet Injector.
5. Connect the cigarette lighter connector to the vehicle lighter port. Note that if your
vehicle leaves this power port operational when the ignition is off, remove this
connector to power off the AC-HPUE.
Laptop docking station
AirgainConnect®AC-HPUE™Quick Start Guide
1. Connect the Ethernet Cable to the Router or laptop WAN port on one end and to
the Ethernet Injector LAN port on the other end. If your model of AirgainConnect
has coaxial cables for Wi-Fi and GNSS/GPS, connect those cables to the
appropriate SMA ports on your router.
2. Connect the AC-HPUE AC adapter to a power source. Airgain can recommends a
high quality power inverter for this purpose.
3. Connect the power cable 4-pin connector to the Ethernet Injector PWR IN port.
Ethernet WAN
Ethernet Injector
Power
Cable
3
1
2
4
5

2
6. When power is applied, it takes at least 60 seconds for the device to initialize and connect.
When activating a new SIM, allow 5 minutes.
7. A solid green LED indication means it is connected and ready.
8. Make sure you are in range of cellular service.
9. Most routers and laptops are configured for DHCP to get an IP address from the network.
10. If the ethernet port on your device is set to PPPOE or static IP address, change it to DHCP.
11. Refer to the installation guide if you need more information.
https://airgain.com/wp-content/uploads/2022/09/AirgainConnect_InstalIationGuide.pdf
LED Status Indicator
AirgainConnect®AC-HPUE™Quick Start Guide
State Indicator Color Description
Power off & sleeping Off The LED is off when the power is off or the device is
sleeping
Booting up Blue Solid blue while booting up
No SIM card Red Solid red after bootup when there is no valid SIM card
No signal Red/Green/Blue
Blinking red after bootup when there is no cellular
coverage signal, followed by blinking green, followed
by reboot solid blue
No USB connection Red Blinking red after bootup when there is no connection
to the antenna-modem
Connecting Green blink Blinking green while connecting to the cellular
network
Connected Green Solid green when connected to the cellular network
Installation Guide