
PAIRING YOUR REMOTE & FOUNTAIN
Step 1 Ensure that you have new batteries in your remote and that the light set
you wish to pair is within the 200’ working range of the remote control.
Depending on conditions, you may have to decrease the distance
between the lights and the remote during the re-paring process.
Step 2 Choose which zone you want to assign the lights (1 to 4).
Step 3 Switch o the main power supply of the lights in the selected zone with
the main switch or pull the plug from the socket. For digital timers, turn
to MANUAL OFF.
Step 4 Switch the lights on again and within 3 seconds, TAP Zone On button
three times on the remote control.
Step 5 When the link operation is successful, the lights will ash GREEN two
times then reset to RED.
BASIC CONTROL FUNCTIONS
• Press and Hold Master ON or ZONE ON for several seconds to turn all
lights to white mode.
• Touch the color ring to adjust lights to any color.
•While in white or solid color mode, use the speed buttons to change the tone
from cool to warm white or vibrant to pastel colors.
• Change the brightness by using the brightness slider.
• Adjust flash/fade speed for any preset program using the speed buttons.
Preset Programs/Modes
Press the “M” Mode button to scroll through the pre-programmed light settings.
Program 1 - Color Flash & Freeze multiple flash and freeze sequences of all colors.
Program 2 - Color Fades red, orange, yellow, green, blue, pink, one after the other.
Program 3 - Color Fades green, blue, pink, one after the other.
Program 4 - Color Fades green, blue, purple, pink, one after the other.
Program 5 - Color Fades red, orange, yellow, green, pink, blue, one after the other.
Program 6 - Color Fades red, white, blue, one after the other.
Program 7 - Color Fades white, pink blue, one after the other.
Program 8 - Color Fades white, green, blue, red, one after the other.
Program 9 - Color Fades blue, green, yellow, pink, red, purple, one after the other.
3
contactus@airmaxeco.com