AirPro NP-K027-001 User manual

PRODUCT INTRODUCTION OF 3 IN 1 PASTA MAKER ATTACHMENT
- 1 -
- 1 -
USER MANUAL
3 IN 1 PASTA MAKER ATTACHMENT

PRODUCT INTRODUCTION OF 3 IN 1 PASTA MAKER ATTACHMENT
- 2 -
Precaution:
Your safety and your family members safety are very important! Many
safety precautions messages had been laser-jet or printed on our products
or here. Please read carefully and obey all safety messages listed.
State of California Proposition 65 Warnings:
WARNING: This product contains one or more chemicals known to the
State of California to cause cancer.
WARNING: This product contains one or more chemicals known to the
State of California to cause birth defects or other reproductive harm.
WARNING：
1. DO NOT put your hands into any attachments when it is running.
2. DO NOT put any metal items into any attachments when it is
running.
3. DO NOT take it off the mixer before it stops completely.
4. DO NOT put any pasta roller or cutter into dish washer for cleaning.
5. DO NOT put any pasta roller or cutter into disinfection cabinet for
sanitization.
6 . Close supervision is necessary when this or any appliance is used near
children.
7 . If there are any damaged parts, please stop using immediately.
8 . Keep safe distance if you are wearing tie,scarf,long necklace, or loose
clothes. Tie up your long hair for safe.
9 . Pasta roller &cutter attachments are designed to be used with pasta
dough only. To avoid damaging your pasta roller, do not cut or roll
anything other than pasta.
WARNING:
1 . This product is not designed for little baby or disabled people. Please
take good care of them.
2 . Clean table is needed for pasta processing.
3 . Power off the machine immediately if there is any emergency happened.
4. Be sure the food processing part had been completely cleaned after use.
Ⅰ. PASTA ROLLER & CUTTER SAFETY

PRODUCT INTRODUCTION OF 3 IN 1 PASTA MAKER ATTACHMENT
- 3 -
MODEL / ROLLER CHART：
Model
Specification
Simplified Diagram
1
NP-K027-001
Pasta Roller
2
NP-K027-001
Spaghetti cutter
3
NP-K027-001
Fettuccine Cutter
Ⅱ
Ⅱ
. . P
P
R
R
O
O
D
D
U
U
C
C
TT D
D
EE SS C
C
R
R
IP
IP
TT IO
IO
N
N
：
：
NOTE：Due to the differences in product appearance, the following pictures are
for reference only. Please refer to the actual product in the box for more
information.

PRODUCT INTRODUCTION OF 3 IN 1 PASTA MAKER ATTACHMENT
- 4 -
1 . SPEED SETTINGS CHART：
Functional
Diagram
Speed
Noodle
Width
Suggested Uses
Pasta Roller
2
up to
140mm
See pasta roller
settings chart
Spaghetti cutter
7
1.6mm
Thick Noodles
Fettuccine Cutter
5
6.3mm
Egg Noodles
Fettuccine
2. PASTA ROLLER SETTINGS CHART：
Roller setting
Noodle thickness (approximate)
1
~0.3mm
2
~0.4mm
3
~0.6mm
4
~1.0mm
5
~1.3mm
6
~1.5mm
7
~1.8mm
8
~2.0mm
3 . PRECAUTIONS BEFORE USING：
Please remove the package and label before using. And clean thesurface
of the pasta roller or cutter attachments, especially for the parts which are
dealing with dough. (Refer to Ⅳ. MAINTENANCE AND CLEANING )
Ⅲ
Ⅲ
. . U
U
SS EE R
R
IN
IN
SS TT R
R
U
U
C
C
TT IO
IO
N
N
：
：

PRODUCT INTRODUCTION OF 3 IN 1 PASTA MAKER ATTACHMENT
- 5 -
4 . INSTALL INSTRUCTIONS：
①Turn off and unplug the
stand mixer.
② Flip up to open or turn the
attachment knob counterclockwise
to remove attachment hub cover
stand mixer.
○
3 Squeeze the dough by hand
to a thickness of about 1 cm and
sprinkle a small amount of flour
between the rollers. Fold dough in
half and roll again. Repeat until dough
is smooth and pliable and covers the
width of the roller. Dust pasta with
flour lightly while rolling and cutting
to aid in drying and separation.
○
4 Tighten the Stand Mixer
attachment hub knob until the
attachment is completely secured to
the Stand Mixer.

PRODUCT INTRODUCTION OF 3 IN 1 PASTA MAKER ATTACHMENT
- 6 -
5. HOW TO MAKE PASTA：
○
1 Prepare pasta dough (refer to
Ⅴ. DOUGH section). Cut dough into
sections that fit in the Pasta Roller.
○
2 Pull out the dough knob
adjustment knob and set it to setting
8. Then loosen the knob so that it is
flush with the surface shell.
○
3 、Squeeze the dough by hand to a
thickness of about 1 cm and sprinkle a
small amount of flour between the
rollers. Fold dough in half and roll again.
Repeat until dough is smooth and pliable
and covers the width of the roller. Dust
pasta with flour lightly while rolling and
cutting to aid in drying and separation.
○
4 、Gradually adjust the thickness
adjustment knob setting, and repeat
the surface pressing operation until
the desired thickness is reached. It is
recommended to use setting 5 or 4 to
make noodle thickness.
○
5 、To make noodles, exchange the
Pasta Roller for the Cutter of your
choice. Feed the flattened sheets of
dough through the cutter. See the
“Roller settings chart” to determine the
correct thickness for each type of pasta.

PRODUCT INTRODUCTION OF 3 IN 1 PASTA MAKER ATTACHMENT
- 7 -
6 . DISASSEMBLE THE PASTA ROLLER AND CUTTERS:
○
1 Turn off and unplug the
stand mixer
○
2 Remove the pasta roller or
cutter from the stand mixer.After
removing the pasta roller or
cutter from the stand mixer,
please be sure to clean the
remaining dried dough. See “Care
and Cleaning” for details
○
3 After removing the
pasta roller and cutters,
replace the hub cover and
tighten the attachment knob
on the stand mixer

PRODUCT INTRODUCTION OF 3 IN 1 PASTA MAKER ATTACHMENT
- 8 -
Please do not clean pasta roller &cutter attachments with metal
tools (knife or sharp items).
Please do not clean pasta roller & cutter in dishwasher machine.
Please do not clean the pasta roller & cutter by dish towels or any
cloth through them.
○
1
After use, keep the pasta roller or
cutter drying naturally for one hour.
Then clean the attachments by brush
or other plastic/wood/bamboo tools
for hard dough.
○
2
Clean the surface with soft towels
and let it dry naturally.
Do not clean it in the dishwasher
or sanitize it in disinfection cabinet.
Ⅳ. MAINTENANCE:
Ⅳ. MAINTENANCE:

PRODUCT INTRODUCTION OF 3 IN 1 PASTA MAKER ATTACHMENT
- 9 -
Ⅵ
Ⅵ
. . W
W
A
A
RR M
M
TT IP
IP
SS : :
Basic Pasta dough
Pasta dough (100% wheat)
Pasta dough with tomato
flour
500 g
Whole wheat flour
500 g
flour
500 g
egg
4
egg 4
egg
3
salt
2.5 ml
salt 2.5 ml
ketchup
75 g
oil
2.5 ml
oil 2.5 ml
salt
2.5 ml
water
some
water some
water
some
When there is a problem when using pasta maker attachment with
mixers, please check the following steps:
1. Is the mixer connected with power?
2. Is the fuse of mixer work properly?
If there is a breaker, be sure it is in close status.
3. Restart the mixer 10 to 15 seconds after power off. If still not work,
keep the mixer cooling for 30 minutes before use again.
4. Is the mixer’s speed setting correct?
5. Is the pasta roller or cutter placed correctly?
6. Is the operation under the guide of user manual?
7. Is the dough made according to the recipe?
Ⅴ
Ⅴ
..D
D
O
O
U
U
G
G
H
H
::PRECAUTION:

PRODUCT INTRODUCTION OF 3 IN 1 PASTA MAKER ATTACHMENT
- 1 -
ENJOY YOUR HOME MADE PASTA!