Airpura UV600 Use and care manual

Operating
& Filter Replacement
Directions
Thank You for choosing an
Airpura High Efficiency Air Purifier
To bring you the benefits of clean indoor air
To Begin Using Your Airpura...
Inspect the exterior of your Airpura to verify there is no
damage from shipping. If any damage is noted please
follow the instructions in the Airpura returns policy.
Wipe the unit with a damp cloth to remove any dust from
packaging
Plug the unit into a regular grounded 110 volt outlet
Turn on the unit to MAX and allow it to run for a few minutes
Set the variable speed control to the level you wish
The most efficient way to use your Airpura for regular air
quality maintenance is to run it at a low speed 24 hours a
day 7 days a week
Feel the difference breathing clean air makes
to your health
Replace the
4 screws and
tighten
Turn the
Airpura
back onto
it's casters
Replace the
gasket
To close the filter chamber
Position the
indentation
in the cover
into the center of
the HEPA filter
UV600
Replacing the UV Bulb
Open the filter chamber following the instructions on page 2
Snip off the plastic retainer (for shipping only:
doesnot need to be replaced)
Pull the bulb upward out of the connector
Push the replacement bulb firmly into the connector
Close the filter chamber following instructions on page 3
Airpura limited warranty
5 years on parts and 10 years labor
Register on line at www.airpura.com

To vacuum the pre-filter
Filter Maintenance and Replacement
The HEPA Filter
Use the brush attachment on your vacuum cleaner
Vacuum slowly around the mesh surface of the filter chamber
The Pre-Filter
The Activated Carbon Filter
Can be vacuumed from the exterior of the unit
once a month or more often.
Should be replaced at least after 12 months of use
Should be replaced at least every 3 to 5 years of normal
use
Turn over
the Airpura Remove the
4 retaining
screws
Take off
the cover
To open the filter chamber
Remove the
gasket
Unfold the filter slider
(Supplied with replacement
filters or on request
Part#6F 001)
Roll it into a spiral
Insert the tube into
the filter chamber
inside the pre-filter
Let the spiral open
to fill the opening Open the top of the spiral to make
a slight funnel
Insert the carbon
canister into the
funnel and hold it
straight
Let the canister
slidedown the
filter slider
Pull the filter slider up
out of the cavity using
both hands and let the
canister slide to the
bottom of the cavity
Remove the filter
slider and fold it
for further use
Place a felt gasket
at the bottom of the
filter chamber
Position the pre-filter
inside the filter chamber
See over for
closing the
filter chamber
Slide in the
Hepa filter
Should be changed as needed in heavy applications and
at least every 24 months in normal use.