airquee 14M Hemisphere Operating instructions

Version 1.0 13/07/17
Page 1of 5
14M Hemisphere
IMPORTANT
AS OWNER/OPERATOR IT IS YOUR RESPONSIBILITY TO WRITE AND CARRY OUT
YOUR OWN RISK ASSESSMENT BEFORE ATTEMPTING TO USE THIS PRODUCT.
Site survey:
1. Carry out a survey of the area where the 14M Hemisphere will be located, and
check for any overhead/underground cables. It’s important that this is carried out
to avoid ground anchors penetrating underground services, and the 14M
Hemisphere coming into contact with overhead cables when inflated. Please take
in consideration the height of approximately 8 meters of the unit.
2. You should provide an adequate power supply to the fan, this should adhere to
your local power regulations.
3. Check wind speed: The industry recommends a maximum wind speed of Force 5
on the Beaufort scale of 28 - 38 kmph (19-24 mph). Force 5 is a fresh breeze when
small trees in leaf begin to sway.

Page 2of 5
Included with your 14M Hemisphere:
Extra equipment needed in addition what is supplied with your inflatable:
•Suitable 240v Power Supply to operate the fan
Extra equipment you could consider for your new inflatable:
•Ground sheet to protect the underside of your inflatable
•Sandbag covers to anchor your inflatable indoors
•Sack truck to move your inflatable safely
•RCD to attach to your extension lead
•Crash Mats
Intended use of the product:
The Bed
in its bag
The Top Part
in its bag
Anchor Pegs
Land Operation
Manual
Pipes
Soft Plays
Carabiners
Intended user height and number:
User Height: UP to
1M
1.25M
1.5M
1.8M+
Number of Users
40
40
35
30
Dimensions:
Length
Width
Height
Inflated
Unit
16.35m
(53.62ft)
14.15m
(46.41ft)
7.5m
(24.6ft)
Weight:
Bed Part
Top Part
Inclusions
Total
283 KG
412 KG
135 KG
830 KG
X14
X2
X12
Repair Kit

Page 3of 5
5X
Please see below the ground and high-
level anchor points:
This inflatable can be set up and packed away by 5 persons who have
had proper manual handling training and use the correct equipment to
move the inflatable.
PLASTIC PIPE
BED FILLER PIPE
TOP PART FILLER PIPE
TOP PART
46 GROUND ANCHOR
POINTS IN TOTAL
6 HIGH LEVEL ANCHOR
POINTS IN TOTAL

Page 4of 5
Set up:
- Unfold the Top Part of the unit and inflate it. Please note the Top Part requires 2 fans.
- Roll the unfolded Bed inside the inflated Top structure.
- Insert the 2 plastic pipes into their specific place.
- Unfold the bed and pull the 2 filler pipes through the plastic pipes.
CARABINER WEBBING
CONNECTION POINTS
BED

Page 5of 5
- Connect the webbing loops with the carabiners.
- Connect the sandwich Velcro flaps all around the bed STARTING FROM THE LEFT or
RIGHT SIDE OF ONE OF THE STEPS. This way you will be able to match the Velcro
connection exactly, without being too short or too long when you reach the other end of it.
- You may start inflating the bed.
Please note the bed requires only 1
fan.
- Add a door to the unit with the help of the Velcro connections.
IMPORTANT: FOR SAFETY REASONS PLEASE ALWAYS LEAVE 1 DOOR
OPEN/UNVELCROED AND HAVE AT LEAST 2 SUPERVISORS INSIDE
THE UNIT!
All the pictures and drawings are for illustration purposes only.
ENJOY AND HAVE FUN!