airquee Kick N Stick Dual Upright Operating instructions

Version 1.3 31/05/17
Page 1of 4
Kick ‘N’ Stick Dual Upright
IMPORTANT
AS OWNER/OPERATOR IT IS YOUR RESPONSIBILITY TO WRITE AND CARRY OUT
YOUR OWN RISK ASSESSMENT BEFORE ATTEMPTING TO USE THIS PRODUCT.
Site survey:
1. Carry out a surveyof the area where the ‘Kick ‘N’ Stick Dual Upright’will be located,
and check for any overhead/underground cables. It’s important that this is carried
out to avoid ground anchors penetrating underground services, and the ‘Kick ‘N’
Stick Dual Upright’coming into contact with overhead cables when inflated.
2. You should provide an adequate power supply to the fan, this should adhere to
your local power regulations.
3. Check wind speed:The industry recommends a maximum wind speed of Force 5
on the Beaufort scale of 28 - 38 kmph (19-24 mph). Force 5 is a fresh breeze when
small trees in leaf begin to sway.

Page 2of 4
2X
3X
Included with your Kick ‘N’ Stick Dual Upright:
Extra equipment needed in addition what is supplied with your inflatable:
•Suitable 240v Power Supply to operate the fan
Extra equipment you could consider for your new inflatable:
•Ground sheet to protect the underside of your inflatable
•Sandbag covers to anchor your inflatable indoors
•Sack truck to move your inflatable safely
•RCD to attach to your extension lead
•Crash Mats
This inflatable can be set up and packed away by 2 persons who have
had proper manual handling training and use the correct equipment to
move the inflatable.
The unit comes with an Airquee Velcro Target Sheet.
When ordering, you may choose these two Velcro sheets too:
The inflatable in
its bag
Anchor Pegs
Land Operation
Manual
Repair Kit
Velcro Footballs
Collecting Stick
Handpump
Ropes
Blank Sheet

Page 3of 4
Set up:
- Unfold and flatten the inflatable.
- Install the desired Velcro sheet on the uninflated game.
The blank sheet supplied is for the back of the unit (if only one side is used). Normally it should be
already installed on the unit.
If you wish to use the Penalty Shoot Out Target Sheet you may notice that both sides of the unit
have a missing Velcro part on the bottom, where the ball can fall out.
IMPORTANT:
Please do not over inflate the balls to avoid damage on the Velcro cover!
Players must be minimum 15 metres away from the target, otherwise the ball will not
stick.
Dartboard Target
Penalty Shoot Out Target

Page 4of 4
Assembly of the Collecting Stick:
Parts of the collecting stick:
1. Attach the Head part to the Middle part by pressing
down the two metal buttons and inserting it until
they pop out in the two holes of the Middle part.
2. Connect the Middle part with the End part by
twisting the black handle.
3. Connect the Middle part to the End part by pressing
the two metal buttons and inserting it until they pop
into the two holes of the End part.
All the pictures and drawings are for illustration purposes only.
ENJOY AND HAVE FUN!
Head part
Middle part
End part