Aiwa CA-DW635 User manual

aiu/a
COMPAQ DISC CARRY COMPONENT SYSTEM
SISTEMA DE COMPONENTS DE DISCOS COMPACTOS PORTATIL
MINICHAINE PORTABLE A LECtEUR OECD
CA-DW635
OPERATING INSTRUCTIONS
See page 2.
MANUAL DE INSTRUCCIONES
Ver la pagina 18.
MODE D'EMPLOI
Voir page 34,
8Z-CT4-905-01
981205AAO-I-S
fflnglB
DIGITAL AUDIO

Adirati
HelVanta1355

Macrovision® copyright protection notice
System Tour
Front panel
Rear panel
System Features
Performance
Multimedia
Connectivity
System peripherals
Mouse(PS/2 or USB, manufacturing option)
Keyboard(PS/2 or USB, manufacturing option)
Speakers
System upgrade
Open the computer
Set up new components
Setting up your computer 7
Necessary to know before Setup 7
Select location 7
Open package 7
Connecting the peripherals 8
Starting your computer 8
Shutting down your computer 8
Troubleshooting 9
Taking Care of your computer 11
Important tips 11
Cleaning and servicing 11
To clean your computer and keyboard 11
To clean your pointing device 12
To clean your optical mouse 12
To clean your monitor 12
When to contact a service technician 12
Asking for technical assistance 12
Energy Star Guidelines Compliance 13
FCC notice 13
Notice: Canadian users 14
Declaration of Conformity for EU countries 14
Modem notices 14
Notice for USA 14
Contents

Chapter 1: Whafs in This User Guide?
Chapter 2: Wi-Fi Phone Panels
Chapter 3: Installing and Using the Wi-Fi Phone
Inserting the Battery into the Wi-Fi Phone
Powering on the Wi-Fi Phone
Navigating the Wi-Fi Phone
Setting up the Wi-Fi Phone
Using the Wi-Fi Phone
Chapter 4: Configuring the Wi-Fi Phone
Instructions for Configuring the Wi-Fi Phone
Status Information
Howto Access the Web-based Utility
Settings of the Wi-Fi Phone
Chapter 5: For Administrators Only
Administrator Settings of the Wi-Fi Phone
Accessing the Web-based Utility
Protecting Administrator Access
Appendix A: Frequently Asked Questions
Appendix B: Glossary
Appendix C: FAQ

2 INSTALLATION
MOUNTING
UPRIGHT

Contents vii

MY INFORMATION
SWITCH
You can timer-activate the radio for a daily radio
program. The unit turns on and off in Radio mode
at the preset time automatically.
Setting the timer
2,4,7 3,6,8
5 1,9
1 W ith the unit off, press and hold MY
INFO for more than 2 seconds.
The “PO” indication flashes in the display
window.
2 P ress SEL.
Timer indication flashes.
3 Set the time you wish the unit to turn on
in Radio mode.
Press TUNE A to set the minute.
4 Press SEL.
Radio indication flashes.
IT i
Band indicator
5
6
7 P ress SEL.
Timer indication flashes.
8 Set the time you wish the unit to turn
off.
Press TUNE Y to set the hour.
Press TUNE A to set the minute.
9 Press and hold MY INFO for more than
2 seconds.
Your setting is stored in memory and the unit
turns off.
7
Press BAND to select the band.
Tune in the station that you wish to
preset with TUNE T or TUNE A.

Compaq ProLiant ML330 G2 Service Overview

27. VOLUME DOWN (-) or UP (+)
Press to decrease or increase the volume of the wired headphones. Pn
The settings are available after the picture select button is pressed.
28. DVD Mode Select Button
29. M UTE
Press this button to mute the audio for wireless FMM, IR headphones and wired headphones.

RECIPES
WHITE BREAD, 3-lb. loaf
2 cups water (80 to 90°F)
1. Measure ingredients into bread pan in the order listed.
3. Select White setting and appropriate loaf size (3-lb.) and desired color.
4. Press Start/Stop (I/O) button.
6. Using pot holders remove bread top from the unit and carefully remove
% cup potato cooking water (80 to 90°F)*
3 tbsp. dry skim milk powder
2 tbsp. potato starch
4. Press Start/Stop (I/O) button.

aigo atom A205 Digital Audio Player
USER MANUAL
The Main Menu
The Main Menu is the default menu that appears in the OLED screen when the Player has been
The Main Menu options include the following “modes”:
0 Music
0 Record
0 Voice (Replay)
0 FM
0 EBook
1. Use the NEXT and PREY buttons to scroll through the “mode” options until you reach the
2. Press the MODE button
remainder of this Manual.
Music Mode
Use the Music mode in order to play tracks/files that are on the Player.
Entering the Music Mode
In the Main Menu, use the NEXT and PREV buttons to scroll through the “mode” options until
you reach the Music mode.
1. Press the MODE button briefly once to confirm your selection and enter the Music mode.
An example of the OLED screen in Music mode is shown below.
Wl.l.l.lffi ffM
im am ass
Deppei andDep
03:03 00:03
Once in the Music mode, you can begin to play tracks/files, as well as enter the File and Play
The File and Play menus are explained in greater detail below.
File Menu (accessed when not playing a track or voice file)
After entering the Music or Voice mode, but without playing a track/file, press the MODE button
Page 12

General
views

6. R EMOTE PROVISIONING AND
DIAGNOSTICS
Control Protocol
is accomplished using ADTRAN Digital System 6
Message protocol, defined in Control and Diagnostic
Procedures Practice, Section 6032991-6. Digital
System 6 is supported by the TPI 108/109 and 105
portable test set and is supported by Hekimian React
2001 Release 1.900 remote test system. The IDSL
OCU-R network element complies with ANSI
Tl.107-1995, “Digital Hierarchy Format
provisioning, querying, and performance monitoring
via inband control of network elements.
NOTE
The REACT 2001 GUI software Release 1.900
supports ANSI Tl.107-1995.
Remote access is accomplished using a defined set of
inband DS0 byte sequences similar to the latching
loopback sequence. Commands issued through the
test system are recognized by the individual channel
unit, which responds with the appropriate byte
sequences. These inband commands may be used to
verify options via dialogs with REACT 2001 and TPI
108/109 test sets. Unit CLEI, serial number,
provisioning, and performance information can be
retrieved remotely using the Digital System 6
Provisioning and Status
All configuration options can be remotely viewed or
provisioned. The front panel AP LED indicator
ON after the IDSL OCU-R has been remotely
provisioned.
If the IDSL OCU-R has been remotely provisioned,
the operator can alternate between remote
configuration and manual switch settings by pressing
the momentary LBK button located on the front panel
for 5 seconds. If the IDSL OCU-R is removed from
the system, the unit retains previous provisioning
information in nonvolatile RAM.
The AP LED remains ON when the IDSL OCU-R is
operating based on Remote Provisioning, and is OFF
when operating on manual switches. See Table 5 for
LED indication.
7. MAINTENANCE
The T200 IDSL OCU-R does not require routine
maintenance for normal operation.
8. DEPLOYMENT GUIDELINES
The IDSL OCU-R allows a standard U-interface to be
used to provide DDS over a single pair. Listed below
are the loop design guidelines for deployment of DDS
over IDSL.
• Actual Measured Loss (AML) should not exceed
40 dB at 40 kHz (135 £2 termination), the Nyquist
frequency of a U-interface.
• Total bridged tap length should not exceed 2 kft.
NOTE
If any of the above Deployment Guideline criteria
Total Reach DDS, with the exception of the first
bullet.
9. W ARRANTY AND CUSTOMER SERVICE
ADTRAN will replace or repair this product within 10
years from the date of shipment if it does not meet its
publisned specifications or fails while in service (see
ADTRAN Carrier Networks Equipment Warranty,
Repair, and Return Policy and Procedure, document
60000087-10).
Contact Customer and Product Service (CAPS) prior
to returning equipment to ADTRAN.
61220010L2-5,1 61220010L2-5C

Acer
SERVICE GUIDE
Page: 17/62
Language :English
Date : 2016-02-29
7.Disassemble & Assemble
7.1 Tools
1) PIN Tool
2) Plastic Bar
3) Cross Screwdriver
4) Tweezers
7.2 Disassembly Steps
1) Remove the SIM 1 tray and SIM 2/SIM SD tray by PIN tool
Page 17/66

11
Touchpad
The built-in touchpad is a pointing device that senses movement on its surface.
This means the cursor responds as you move your finger across the surface of
the touchpad. The central location on the palmrest provides optimum comfort
and support.
Touchpad basics
The following items show you how to use the touchpad:
Move your finger across the touchpad (2) to move the cursor.
Press the left (1) and right (4) buttons located beneath the touchpad to
perform selection and execution functions. These two buttons are similar
to the left and right buttons on a mouse. Tapping on the touchpad is the
same as clicking the left button.
Use the 4-way scroll (3) button to scroll up or down and move left
or right a page. This button mimics your cursor pressing on the
right scroll bar of Windows applications.

H I 1 , I 1 ,
“M
Figure B-2: Exte Passive Bus Configuratic