Akurat lighting W-DMX User manual

Wireless Transmission of DMX
VERTE
Akurat W-DMX Modules
User Guide
powered by
W-DMX

Description of the operating elements:
1. DMX input/output (XLRs)
2. RX/TX DIRECTION switch
3. POWER indicator (green)
4. STATUS indicator (blue)
5. MODE/SIGNAL indicator (red)
6. LINK BUTTON
7. AERIAL
8. DC INPUT
9. ON-OFF SWITCH
www.akurat.lighting e-mail: [email protected] tel/fax: [phone]
User Guide
AWTRX-1 G5
W-DMX Transceiver TX/RX
Configuration in TX mode
1. Set RX/TX DIRECTION switch (2) to TX (ON)
2. Connect the DMX signal to DMX Input (1)
3. Connect the power source to DC INPUT (7)
4. Set ON-OFF switch (8) to ON
WARNING!
In TX mode transceiver transfer the DMX signal only to previously paired receivers.
See below the instruction of pairing transmitter and receivers.
Configuration in RX mode
1. Set RX/TX DIRECTION switch (2) to RX (OFF)
2. Connect the fixture/fixtures to DMX Output (1) using DMX cable
3. Connect the power source to DC INPUT (8)
4. Set ON-OFF switch (9) to ON
WARNING!
In RX mode transceiver accepts the DMX signal only from previously paired W-DMX TX transmiter.
See below the instruction of pairing transmitter and receivers.
1
2
34
5
67
8,9
User Guide
AWRX-1 G5
W-DMX Receiver RX
1. Connect the USB plug to USB socket in DMX terminal of fixture.
2. Be sure that the ON-OFF switch is set to ON position.
3. Remove the liners from Velcro tapes and stick the receiver to the housing of fixture.
The state of receiver indicated by blue STATUS LED (4) - see above
The red MODE/SIGNAL LED (5) shining steadly indicates that RF signal is O.K.
If it starts to flash the RF signal may be to low.
WARNING!
Reciver accepts the DMX signal only from previously paired W-DMX TX transmitter.
Continuously On = DMX present
On 100ms / Off 100ms = linking receivers
On 500ms / Off 500ms = unlinking all receivers
The status of transceiver in RX mode or status of receiver (4)
Continuously Off = not assigned to a transmitter
On 900ms/Off 100ms = no DMX present
On 900ms/Off 100ms = assigned to a transmitter, but no DMX present
Continuously On = assigned to a transmitter and DMX present
On 100ms / Off 100ms = link to transmitter lost or linking to transmitter
Instruction of pairing transmitter and receivers
PAIRING - press the LINK button (6) on transceiver for 1 to 2 seconds to pair in all of unassigned receivers.
UNPAIRING receiver - press the UNLINK button (12) in receiver for more than 3 seconds to unpair it.
UNPAIRING all - press and hold more than 3 seconds the LINK button (6) on transceiver and then release it to unlink all paired receivers.
The status of transceiver in TX mode - blue STATUS LED (4)
Description ... (continuation):
3,4,5,7 -see the description above
10. USB cable - DC Input/DMX Output
11. ON-OFF SWITCH
12. UNLINK button
3
4
57
10
11
12
WARNING!
Before pair in the receivers have to be in a status „not assigned to a transmitter” (blue STATUS LED continuously Off).
W-DMX