Alcohawk PT500 User manual

Calibration Log
Date First Used Recalibration Date Notes

THIS DEVICE IS INTENDED TO MEASURE ALCOHOL IN THE HUMAN BREATH.
To toggle through available menu options, press the SELECT button. See manual for details on the menu options.
DO NOT DRINK AND DRIVE.
SEE OWNER’S MANUAL FOR RE-CALIBRATION INSTRUCTIONS THAT MUST BE ROUTINELY PERFORMED.
AlcoHAWK® PT500 Quick Guide
Be sure to read the entire owner’s manual and follow procedures
carefully to obtain optimal results.
Operating Instructions
BREATH OUT
DO NOT COVER
WHILE TESTING
BREATH PIPE IN
DISPLAY
ON/OFF POWER BUTTON
ENTER BUTTON
SELECT BUTTON
Wait 20 minutes after the test subject smokes, eats or drinks
before testing. Failure to wait 20 minutes can give inaccurate BAC
readings and damage the sensor.
Step 1) Press and hold the ON/OFF power button for 1 second until
you hear a BEEP. The unit reads “Initializing...” as it prepares
for use.
Step 2) The screen displays “Test” and “Options”. To start a “Test”,
press the ENTER button . The unit displays “Blow Now”.
Take a deep breath, wrap your lips around the new mouthpiece
and blow steadily for five (5) seconds. The unit beeps when the
test subject starts blowing and beeps again after obtaining the
sample. Do not cover the BREATH OUT hole.
Step 3) The unit displays “Processing” while analyzing the sample.
After about three (3) seconds, the unit then displays the
estimated BAC.
Step 4) The unit shows the test result for 90 seconds before beeping
twice and shutting off.
Step 5) To turn off the unit, press and hold the ON/OFF power button
for 1 second.