Allfyll S1 User manual

1
RO Water Purifier
Series S
Instruction Manual
Introduction 2
Specification 3
Components 4
Cartridge and Filters 5
Parts of main body 6
Display 7
Tubing connection 8
Installation 9
Cartridges replacement 10
RO membrane replacement 11
Operation steps 12
FAQ 14
Spare parts 15
PRODUCT OF
THAILAND
All For Your Long Life

2
Introduction
Water purifier with Reverse Osmosis (RO) Series S is for production of pure drinking
water by Reverse Osmosis technology. It consists of 5-7 hight quality filters and a RO
membrane which can removes particles down to 0.0001 micron up to 95%, ions, heavy
metals, organic compounds and bacterias up to 99%.
●Includes high pressure booster pump with maximum pressure rating to 100 psi. This
helps continueous water production where or when the water input pressure is low.
●Includes manual flushing valve for cleaning of the RO membrane to prolong the life
time and prevent baterias growing up.
●Includes housing frame that can be installed on the floor under sink, needs no drilling
the wall.
●Includes standard accessories and instruction manual.
●Each unit is already tested for the leakage and performance from factory and ready
to use.
What is Reverse Osmosis?
Reverse Osmosis (RO) is the best technology for drinking water purification. The raw
water with the pressure is filtered by RO membrane (maded of Thin Film Composit
with
pore size of 0.0001 micron). Only water molecules can pass through this membrane
while
others impurities which partilcle size is bigger than 0.0001 micron are removed, including
ions, heavy metals, salts, dissolved solids, organic compounds, bacterias and viruses.
Pressure
Membrane

3
Specification Model
S1 S2 SA SL SAL
Number of stages for water purification 5 5 6 6 7
Flowarte (gallons per day) 100 50 100 100 100
Booster pump pressure 100 psi
PP 5 micron cartridge (long life) ••••
PP 5 micron cartridger •
CTO cartridge (long life) ••••
CTO cartridge •
Resin cartridge (long life) ••••
Resin cartridge •
RO membrane 100GPD ••••
RO membrane 50GPD •
Post carbon inline filter (long life) ••••
Post carbon inline filter •
Alkaline inline filter ••
UV lamp ••
Water tank volume 3.2 gallons or 12 Liters
Operating pressure 5-80 psi
Power 220 V, 50Htz
Feed water tap water, ground water
Dimensions 20 (W) x 37 (D) x 48 (H) cm - system
28 (W) x 28 (D) x 35 (H) cm - tank
Weight 9 kg - system
4 kg - tank
Specification

4
Components
A
C
B
D
F
G
E
Standard accessories Part No
A Faucet AF-4004
B 3.2G water storage tank AF-4002
C Housing wrench 10” AF-4005
D Deliver-valve AF-4006
E Water supply connector AF-4007
F Tank ball shut-off valve AF-4008
G Tubing, 3m AF-4009

5
Cartridges and Filters Part No. Model
S1 S2 SA SL SAL
PP 5micron inline filter
for removing of dirts, rusts and sand particles down to 5 microns
Allfyll®, Thailand
Life time > 6 months AF-3101 •
GE PURTREX®, U.S.A.
Life time > 12 months (long life) AF-3001 ••••
CTO inline filter
For removing of chlorine, taste and odor and organic chemicals
Allfyll®, Thailand
Life time > 6 months AF-3102 •
KX®, U.S.A.
Life time >12 months (long life) AF-3002 ••••
Resin inline filter
For removing of the mineral salts to produce deionized water with soft taste
Allfyll®, Thailand
Life time > 6 months AF-3103 •
Jacobi®, Sweden
Life time > 12 months (long life) AF-3003 ••••
RO membrane
For removing of contaminants down to 0.0001 micron
Pentek®, U.S.A.
Capacity 50 GPD
Life time 3-4 years AF-3104 •
HYDROTEK®, U.S.A.
Capacity 100 GPD
Life time 3-4 years AF-3004 ••••
Post carbon inline filter
For removing of chlorine, taste and odors
Allfyll®, Thailand
Life time > 1 year AF-3105 •
Omnipure®, U.S.A.
Life time 3-4 years AF-3005 ••••
Alkaline inline filter
for perfectly pH-balanced drinking water
Kenbushi®, Korea
Life time > 1 year AF-3006 ••
UV lamp
For removing of bacterias and viruses for better health and beauty
Allfyll®, Thailand
Life time 8,000 hours AF-4001 ••

6
Parts of main body
Post carbon Inline Filter
Display
3rd Housing (with Resin Cartridge)
2nd Housing (with CTO Cartridge)
1st Housing (with PP Cartridge)
RO Housing (with RO membrane)
Post carbon Inline Filter
Display
Pressure Gage
Pressure Gage
Flush valve

7
Display
POWER Bulb is lightening as connecting power.
WATER The system starts to function 20 seconds after plugging in.
WORKING The system begins to produce water.
FULL Pump stops when tank is full of pure water.
POWER WATER FULLWORKING

8
Tubing connection
A. Connect the A tubing to the water supply connector.
B. Connect the B tubing to the sink top faucet.
C. Connect the C tubing to the drain saddle.
D. Connect the D tubing to the storage tank.
Faucet
Tank
Drain
Input water
A
B
C
D
Faucet
Tank Input water
Drain

9
Installation
Input water :
To RO system
Deliver
valve
To
water
source
pipe
To
faucet
Install water tank :
Hand tighten
plastic shut-off
valve to tank.
Then connect
color tubing.
Install European ceramic
faucet :
Install drain saddle :
Mount drain
saddle
aligning holes.
Drill a 1/4”
hole into the
drain pipe.
Assemble membrane :
1.Remove the membrane
housing cap.
2.Replace the membrane.

10
12
4
6
7
3
5
Cartridges replacement
Prepare a
housing wrench. Turn off water
source. Switch off water
tank.
To RO system
Unplug electricity. Open housings clockwise
with a wrench.
Put the replacement filters in the
housings and double O’ ring.
Be sure tighten
with O-ring to
prevent from
leaking.
Drain out 1 Gallon of water
to purify replacement filters.

11
PRO
RE
NG WATER SYSTEM
45
6
7
123
Unplug electricity. Turn off water
source. Switch off water tank.
To RO system
Loose the Joco fitting
anticlockwise. Remove the membrane
housing cap anticlockwise.
Remove the membrane
by a pincer. Install the membrane by
carefully pushing the spigot
end into the socket at the
far end of the housing until
completely in.
RO membrane replacement

12
Operation guide
1. With everything connected, turn on the water, check for leaks.
2. Make sure the storage tank shut-off valve is “OFF”. Open the sink top faucet.
3. Within a few minutes (up to 15) the water will start to run from the faucet slowly.
4 Let the water run for at least 30 minutes.This flushes the carbon filters on the first time
use.
5 After initial flushing, open the shut-off valve on the tank and close the sink top faucet.
6. Tank will now full of water (usually 2 to 3 hours) after the tank has filled. Open the sink
top faucet and drain all water until the storage tank is empty and there is only a small
flow from the sink top faucet. *** DO NOT USE FIRST TANK OF WATER.***
7. Close the sink top faucet. The system is now ready for use.
8. Weekly clean the RO membrane by turning on the flush valve and turning off the shut-
off valve of water tank for 30 minutes.
9. Change filters and RO mebrane regularly (see page 5 for the life time of filters and RO
membrane) or when the total disolve solid (TDS) of output water is over 100 mg/L.
1. Do not use hot water (over 45 oC)!
2. Do not freeze the machine!
3. Switch off electricity and water source if away for more than 5 days, and drain out
pure water.
Caution

13
FUL
5
12
3
6
4
POWER WATER FULLWORKING
Operation guide
Plug into power. Turn on water source.
To RO system
Switch on water tank. Display signals are on.
Pump starts to
function. Let the water run for at least
30 minutes. This flushes the
carbon filters on first time
use.

14
FAQ
Q: What is the guarantee on the Allfyll water purifier?
The Allfyll water purifier (excluding cartrifges and filters) is guaranteed for 1 year for
material and workmanship.All defective parts will be replaced free within the first year
under normal breakdown. The membrane has one year pro-rated guarantee.
Q: What factors affect the quantity and the quality of the water production?
There are four major variables to consider:
1. Pressure -The greater the water pressure, the better water quantity and quality it
produced. Water pressure of 60 PSI is ideal.
2. Temperature -76 oF is the ideal water temperature for RO. 40 oF water will cause
the production of RO water to fall to half of that at 76 oF. The maximum water
tem
perature recommended is 85 oF.
3. Total Dissolved Solids (TDS) -The higher the amount of dissolved contaminants
in the water, the lower the quantity of water produced. A high level of TOTAL
DISSOLVED
SOLIDS can be overcome with additional water pressure.
4. Membrane -Different membranes have different characteristics. Some produce
more water than others; some have better contaminant rejection capabilities; some
have greater resistance to chemical abrasion for longer life. Allfyll water purifiers use
The Thin Film Composite (TFC) membrane that combines the best of these characteristics
and are considered the best performance.
Q: Can the Allfyll water purifier be connected to an extra faucet?
It only takes a 1/4” tee and tubing to run the water to a refrigerator or a extra faucet.
Some families run Allfyll water purifier to all of their bathrooms.
Q: What does the Allfyll water purifier drinking water taste like?
The taste of the water depends on the amount of contaminants in the tap water. If
95% of dissolved minerals and chemicals are removed, the water produced may taste
like distilled water (no minerals), bottled water (low mineral), or natural spring water
(moderate mineral content).
Q: How will the Allfyll water puifier water affects mixed beverages?
Because reverse osmosis removes soluble contaminants that mask flavor, it allows
the natural taste of your beverages to come through. You will be able to use less coffee
and still get the full flavor. Concentrated beverages like orange juice will taste tangier.
You will probably be drinking a lot more water as well, since many people drink soda,
Kool-Aid, concentrated juices, and beer as an alternative to bad-tasting tap water.
Also, Allfyll water purifier eliminates most of the lime build up on drip coffee makers,
pre
venting the need for frequent cleaning. No longer will you find the white scum on
the inside of pans after boiling water.

15
Spare Parts Part #
PURTREX®5 micron PP Cartridge, 10” AF-3001
Allfyll®5 micron PP Cartridge, 10” AF-3101
KX®CTO Cartridge, 10”, Long life AF-3002
Allfyll®CTO Inline Filter, 10” AF-3102
Jarcobi®Resin Cartridge, 10”, Long life AF-3003
Allfyll®Resin Inline Filter, 10” AF-3103
Hidrotek®RO Membrane 100GPD AF-3004
PENTEX®RO Membrane 50GPD AF-3104
Omnipure®Post Carbon Inline Filter, 10” Long life AF-3005
Allfyll®Post Carbon Inline Filter, 10” AF-3105
Kenbisui®Alkaline Inline filter, 10” AF-3006
Ultraviolet light (UV) lamp AF-4036
RO Pump 100GPD 1/4” EZ 24VDC AF-4014
Solinoid valve 1/4”, EZ, 24VDC AF-4015
High Pressure Switch, 1/4”, EZ AF-4016
Low Pressure Switch, 1/4”, EZ AF-4017
Flow Restrictor, 300ml/min, EZ AF-4024
Plastic Ball valve, 1/4”, EZ AF-4018
Wrench 10” AF-4005
Chromed Ball valve 3/8” AF-4006
T-WAY CONNECTOR 1/2”, side port 1/4” AF-4007
PE Tubing 1/4”, White, 3m AF-4009
Spare parts

16
Allfyll (Thailand) Co., Ltd.
8 Thaiyanon 12, Nonthaburi 46, Muang-Nonthaburi, Nonthaburi 11000
Tel: [phone]
Fax: [phone]
Email: [email protected]
Website: www.allfyll.com
Allfyll® Instruction manual, Series S © 2013 Allfyll (Thailand) Co., Ltd. Printed in Thailand, 11/2013
All For Your Long Life
Date PP
Cartridge CTO Cartridge Resin Cartridge RO Membrane
Post Carbon
Inline Filte rAlkaline Inline Filter UV lamp
Maintenance time table