Allied Telesis WebSmart AT-FS750/16 How to use

PN 613-001276 Rev B 1
AT-S80 Version 2.3.1 (1.1.1.92)
Management Software for the
AT-FS750/16, AT-FS750/24 Fast Ethernet
Smart Switches Software Release Notes
Please read this document before you begin to use the management software.
Supported Platforms
This release of the AT-S80 Management Software is supported on the following switches:
AT-FS750/16 Fast Ethernet Smart Switch
AT-FS750/24 Fast Ethernet Smart Switch
The AT-FS750/16 and AT-FS750/24 Fast Ethernet Smart Switch supports the following ATI SFP
modules:
100 MB SFPs
AT-SPFX/2
AT-SPFX/15
1000 MB SFP
AT-SPSX
AT-SPLX10
AT-SPLX40
AT-SPZX80
Product Documentation
For hardware installation and management instructions, refer to the following guides on the Allied
Telesis web site at www.alliedtelesis.com/software/:
AT-S80 Management Software User’s Guide Installation Guide
AT-FS750/16 and AT-FS750/24 Fast Ethernet Smart Switches Installation Guide
See “Where to Find Management Software Updates and Product Information” on page 6 for
instructions to navigate to these documents

AT-S80 Version 2.3.1 Software Release Notes
PN 613-001276 Rev B 2 Allied Telesis, Inc.
Operational Issues
Boot Time. AT-S80 software takes the following amount of time to boot depending on the
version of firmware you have loaded onto your switch:
Table 1: Approximate Boot Time
What’s New in Version 2.3.1
Resolved Issues
None
Known Issues
None
Operational Notes
The length of the RADIUS shared key is currently limited to 19 characters.
When setting the Bandwidth Control Ingress Limit Rate, you must select a threshold level of
L/M/H for all ports. These levels approximately correspond to the following data rates based
on a packet length of 1518 bytes:
— High: 3000 packet/s
— Medium: 500 packet/s
— Low: 100 packet/s
New Feature
The maximum 802.1x/Radius user name length has been increased to 64 characters.
REVISION HISTORY
Version 2.3.0
See Software Feature History
Version 2.2.0
Hardware Features
None
Version Approximate Boot Time
1.0.0.49 48 seconds
2.0.0 113 seconds
2.1.0 210 seconds
2.2.0 50 seconds
2.3.0 50 seconds

AT-S80 Version 2.3.1 Software Release Notes
PN 613-001276 Rev B 3 Allied Telesis, Inc.
Known Issues
The following issue was found in this release:
802.1x Guest VLAN - When 802.1x is used to authenticate a port and the guest VLAN
function is enabled, the port becomes a member of the guest VLAN permanently, even after a
reboot.
Resolved Issues
Default VLAN - Access to the Management port is now restricted to the default VLAN only as
is stated in the manual.
Fiber Combo Port -The fiber side of the combo port can now be changed between 1000 Mbps
and 100 Mbps on the Physical interface page and the Front Panel page. Previously, the
option on the Front Panel page didn’t work.
Combo Port Link State - The combo port link state is now properly displayed on the Front
Panel page when linked via 100FX.
Front Panel LED Display - The Front Panel page is now properly displayed the 100FX link on
each port.
Applying PVID via Web - Applying the certain PVID’s to a port when using the web interface
now succeeds and will result not in an error message.
Port Mirroring - Port Mirroring is now working properly.
Version 2.1.0
Hardware Features
None
Known Issues
The following issues were found in this release:
Default VLAN. The Management port can be accessed from any VLAN and is not restricted
to the default VLAN as is stated in the manual. This issue will be fixed in a future release.
Setting the Fiber Combo Port Type. On the web interface, the fiber side of a combo port (port
25 or port 26) can only be changed between 100FX and 1000X on the Physical Interface
page. If you try to change this parameter by selecting the Front Panel page by double clicking
on one of the fiber ports and attempting to change the Port Type, it only allows 1000X to be
selected.
Combo Port Link State. On the Front Panel web page, the combo port link state does not
display when linked via 100FX. See Figure 1, “Front Panel Web Page w/ 100FX Link” below.

AT-S80 Version 2.3.1 Software Release Notes
PN 613-001276 Rev B 4 Allied Telesis, Inc.
Port Display Color. On the Front Panel web page, all ports are displayed with an orange color
(regardless of their link state) whenever the switch is actively linked via one of the 100FX
fiber ports. See Figure 1, “Front Panel Web Page w/ 100FX Link” below.
Figure 1. Front Panel Web Page w/ 100FX Link
Resolved Issues
802.1x Authentication fails and console displays an error message. The local 802.1x
authentication method is now compatible with the Odyssey Access Client (EAP-MD5) and
with the RADIUS server authentication (remote). (7351 and 7352)
Retention of the 802.1x Dynamic VLAN password. When using the Firefox browser you may
now modify the 802.1x password without getting an error message. (7073)
Features History
Version 2.3.0
Management access can now be restricted to the default VLAN (VLAN 1). This feature is
activated when you select ENABLE for the Management VLAN field on the VLAN
Configuration web page. If this field is set to DISABLED, the management access is available
on any VLAN.
Version 2.2.0
You can now display a list of entries in the Forwarding database.
Version 2.1.0
None
Version 2.0.0
The following features have been added to AT-S80 version 2.0.0 software:
Rapid Spanning Tree Protocol (RSTP)
Simple Network Management Protocol (SNMP) V1, V2c
IP Access List
Password protection
Multi-Administration Accounts
Ingress and Egress Port Mirroring

AT-S80 Version 2.3.1 Software Release Notes
PN 613-001276 Rev B 5 Allied Telesis, Inc.
Static Multicast Address Table
IGMP Snooping
Bandwidth Control (Ingress/Egress) Rate Limiting
Port-Based VLAN
Destination MAC Filter
Firmware Upgrade via HTTP
100FX SFP Support
Statistics Charts in the Web interface
802.1X MAC Base
802.1X Local Dial-In User Table

AT-S80 Version 2.3.1 Software Release Notes
PN 613-001276 Rev B 6 Allied Telesis, Inc.
Contacting Allied Telesis
This section provides Allied Telesis contact information for technical support as well as sales and
corporate information.
Online Support
You can request technical support online by accessing the Allied Telesis Knowledge Base:
www.alliedtelesis.com/support. You can use the Knowledge Base to submit questions to our
technical support staff and review answers to previously asked questions.
Email and Telephone Support
For Technical Support via email or telephone, refer to the Support & Services section of the
Allied Telesis web site: www.alliedtelesis.com. Select your country from the list displayed on
the website. Then select the appropriate menu tab.
Returning Products
Products for return or repair must first be assigned a return materials authorization (RMA)
number. A product sent to Allied Telesis without an RMA number will be returned to the sender at
the sender’s expense. To obtain an RMA number, contact the Allied Telesis Technical Support
group at our web site: www.alliedtelesis.com/support/rma.Select your country from the list
displayed on the website. Then select the appropriate menu tab.
Sales or Corporate Information
You can contact Allied Telesis for sales or corporate information through our web site:
www.alliedtelesis.com. Select your country from the list displayed on the website. Then select
the appropriate menu tab.
Where to Find Management Software Updates and Product Information
Management software updates are on the Allied Telesis web site. In addition, the installation and
user guides are available for all Allied Telesis products in portable document format (PDF) on our
web site. Go to http://www.alliedtelesis.com/support/software/.
Enter your hardware product model in the Search by Product Name field; for example, enter AT-
FS750/16 or AT-FS750/24. You can view the documents online or download them onto your local
workstation or server.
Copyright © 2010, Allied Telesis, Inc.
All rights reserved. No part of this publication may be reproduced without prior written permission from Allied Tele-
sis, Inc.
Allied Telesis and the Allied Telesis logo are trademarks of Allied Telesis, Incorporated. All other product names,
company names, logos or other designations mentioned herein are trademarks or registered trademarks of their
respective owners.
Allied Telesis, Inc. reserves the right to make changes in specifications and other information contained in this
document without prior written notice. The information provided herein is subject to change without notice.