AllPetSolutions 6 Meal Automatic Pet Feeder User manual



User Guide

2
Thank you for purchasing the All Pet Solutions 6 Meal
Automatic Pet Feeder®.
This User Guide is intended to provide you with guidelines to
ensure that operation of this product is safe and does not pose
risk to the user.
Any use that does not conform to the guidelines described in
this User Guide may void the limited warranty.
Please read all directions before using the product and retain
this guide for reference. This product is intended for household
use only.
This product is covered by a limited one-year warranty.

3

Top Lid
Storage Tray
Control Panel
Base
Non Slip Feet
Battery Compartment
On/O Button
USB Port
Micro USB
Low Battery Indicator
Time
Feeding Schedules
Increase Value
Set
Decrease Value
NO.: ① ② ③ ④ ⑤

4

• Do NOT use this device for puppies and kittens under 7
months.
• Do NOT immerse control panel in water. The base of the unit
should NOT be submerged in water at anytime, as this may
damage electronic components.
• Do NOT place anything on top of the pet feeder.
• Dispose of all packaging materials properly. Some items may
be packed in polybags; these bags could cause suocation;
keep away from children and pets.
• To reduce the risk of injury, close supervision is necessary
when an appliance is used by or near children.
• Intended for use with dogs or cats only.
• Do NOT use outdoors. FOR INDOOR HOUSEHOLD USE ONLY.
• Pet feeder should be placed on a level surface.
• Before leaving for extended time, always replace batteries
with new batteries.
• Do NOT disassemble the pet feeder other than components
as instructed in this operating guide.
• Do NOT unplug by pulling on power cord. To unplug, grasp
the plug, not the power cord.
• Do NOT operate if it has a damaged power cord or plug.
• Do NOT place or store the feeder where it can fall or be
pulled into a tub or sink.
• Examine the pet feeder before installation. Do NOT plug in if
there is water on the power cord or plug.
• To avoid tripping, always position power cord out of the way.

5
Caution
• Do NOT allow pets to chew on or swallow any parts.
• Do NOT attempt repairs on the pet feeder yourself.
• Do NOT install or store pet feeder where it will be exposed to
weather or temperatures below 5°C.
• Do NOT lift pet feeder by lid. Lift and carry feeder using both
hands and hopper base, while keeping unit in upright position.

6
Before using the automatic feed dispenser:
Plug in the Micro-USB cable or insert 3 C size batteries.
Press on the lid of the device with both hands and turn it in the
direction of the arrow on the lower part. When the arrows on
the bottom and top parts meet, you can lift the lid o.

O On
To remove the food tray simply align the arrows and lift it up.
Reassemble the unit. Switch on the main switch at the bottom
and press and hold the “up“ button for 1 second to check the
food tray rotates properly.
Fill in the desired number of portions and lock the lid by
turning it again.

7
Unlocking the screen
Press and hold the “up” and “down” buttons at the same time
for 1 second to unlock the screen, then follow the on screen
instructions to change the settings.
Please note that after 30 seconds of inactivity the screen will
enter standby mode.
Setting the current time
1. Press “set” button and the hour digit will ash.
2. Press the “up” and “down” arrow keys to change to the
current hour and press “set” to save.
3. Once the hour is set the minutes will ash, use the arrow
keys to set the time to the current minute and press “set” to
save.
Programming the feeding times
1. Once the current time is set, the hour digits and “1” will ash,
use the “up” and “down” arrows to set the time for the rst
meal. Press “set” to save the rst meal time.

8
Please note: The feeder won’t rotate when your pet’s
paws are inside the food tray in order to prevent injuries.
The screen will show [E1:30] error and will return to
normal after 30 seconds’ countdown.
2. Once the rst meal time is saved, the “2” will ash to indicate
that the second meal time is now being set, repeat the step
above to continue scheduling meal times.
3. Alternatively if you do not want to set all feeding times
(minimum 1 scheduled meal), press and hold “set” button to
save the feeding times set so far and return to the time display.
Please note: Up to 5 meal times can be scheduled
Manual feeding
Press the upward arrow for 1 second. A single portion will be
dispensed. If the food tray doesn’t rotate, please press “up”
and “down” arrows at the same time to unlock the control
panel.
Factory reset
1. Press “set” so that the hour digits ash.
2. Hold “up” and “set” buttons at the same time for 3 seconds to
clear all programmed meal times and settings.

9
1. Be sure the unit is turned o and power is disconnected
before attempting to clean.
2. Remove lid and feed container as described above.
3. Wipe with a soft cloth dipped in a small amount of soapy
water. Do not use a fully soaked cloth.
4. Food tray can be removed for cleaning and is dishwasher
safe.
5. Never submerge the base of this unit in water as it contains
vital electronics and may short circuit.
6. Ensure that all parts are clean and fully dry before
attempting to operate or re-ll the food compartment.


All Pet Solutions Ltd, 203 Riverside Way,
Uxbridge, UB8 2YF, United Kingdom
www.allpetsolutions.co.uk