Therian Kuranda Product information sheet

Easy Assembly Instructions For Kuranda Suite Beds
Comments or Questions? Call Therian on 1800 251 766
1. Assemble bed using Kuranda aluminum bed assembly
instructions except as follows:
2. The cross pipe used for the headboard end is slightly
shorter than the other cross pipe.
This was done so that if there is a variance in the
headboard width it will still fit in the bed. The difference is
no more than 4 mm and is not noticeable. The shorter pipe
is distinguished by a piece of tape.
3. To attach the headboard use 2 sets of bottom corner
brackets with the long pan head screws as shown in the
photo below.
4. Drop in headboard. Fully insert the headboard legs into
the corner before tightening screws.

KURANDA DOG BED GUARANTEES
HOW ARE THE DOG BEDS CHEWPROOF?
Any place the fabric is in aposition to be chewed, it is protected by apoly-resin sleeve.There are no
corner gaps to bite.Once in awhile adog will bite through aleg or side piece but it is quite rare.This
image shows how the fabric fits into the frame of the bed so your dog cannot reach the fabric.Caution:
Fabrics are vulnerable to tearing by persistently scratching or digging dogs.
KURANDA DOG BEDS ARE GUARANTEED CHEWPROOF FOR ONE FULL YEAR!
Kuranda guarantees the structural integrity of the frames and fabrics of their dog beds against chewing
by adog for aperiod of one year from date of purchase.Accordingly, Kuranda will replace frame parts
and fabric damaged by dogs chewing the bed only to the point of not being useable at no charge during
this period.This warranty excludes damage caused by dogs scratching the fabric.This warranty
includes chewing of corner fittings and legs.Fabrics covered under this guarantee by chewing only are
40 oz solid vinyl and Ballistic nylon.Multiple fabric replacements for the same bed will be handled on a
case by case basis.
Product Advisory (on PVC corners only)
Please be aware that we have found that over tightening the screws on the corners of the beds (even
by just one or two full threads) can cause enough added stress that the corner pieces may fail. To
maximize the life of the corner fittings, the screw should be flush with or slightly inside the nylon locking
material in the nut.
Please call us if you have any questions in Australia on 1800-251-766
Figure 1.
Correctly tightened.
Screw is flush with nylon
locking material
Figure 2.
Incorrect -too tight.
Screw extends beyond
edge of nut.
Unit 4, 26 Commercial Drive,
Ashmore QLD 4214
Tel: [phone]
Fax: [phone]
[e-mail]
www.therian.com.au
Easy Assembly Instructions For Kuranda Suite Beds