Alpine Rearvision tmx-r3200se User manual

OWNER’S MANUAL

Please read this manual thoroughly for proper use and store

it for later use when needed. The Company will not be

responsible for any damage due to misuse of the product.

This manual has been prepared to allow you to use the product

correctly and safely by means of illustrations to prevent any

harm by other persons or other property. Below are definitions

of the symbols used . Please carefully understand the

meanings before reading the instruction manual.

This shows the detail that could lead to death

or severe injury if ignored or through misuse

the product.

This shows the detail that could lead to death

or severe injury if ignored or through misuse

the product.

Do not disassemble or modify the product. It could

cause accident, fire or electric shock.

Keep small objects such as batteries, screws out of

the reach of children.If swallowed,

consult a doctor immediately.

Use the correct ampere rating when replacing fuses.

Failure to do so may result in fire or electric shock.

Only used in cars with 12-volt DC negative ground.

(Check with your dealer if you are unsure.)

Failure could result in a fire.

Keep all cords and wires from interference with driving

operation. Binding with Handle, Transmission Lever

or Break Paddle could cause accident

or system breakdown.

Do not operate or watch while driving.

Stop the vehicle in a safe location before operation.

Failure to do so may result in an accident.

In case of error, such as no sound or picture, foreign

objects inside, smoke or strange smells, stop using

the product immediately and contact your dealer.

This could cause accident, fire and electric shock.

Do not wipe with oil, alcohol, benzene or thinner

and do not use it with hair spray or pesticides.

Please wipe off any stains immediately.

It may be the cause of cracks, electric shock or fire.

Rear seat passenger should fasten the seat belt

to prevent accidents due to quick take off

or urgent breaking. These could cause accident

or injury.

Please correctly install as described in this manual.

Failure to do so may result in fire or an accident.

Please avoid lines between objects or edges.

It may cause electric shock or fire due to short circuit.

Do not close or block the ventilation grill.

This could cause fire or crash the system

Use only specified options and install firmly.

Failure to do so may result in fire or an accident.

Do not install in locations that obstruct the driving

operation such as front view, handles, gear lever

or place that could harm passengers.

This may lead to accidents and injuries.

Please do not connect the power from other sources

by stripping cable insulation. This may cause fire

or electric shock.

Use the correct ampere rating when replacing fuses.

Failure to do so may result in fire or electric shock.

Before installation, disconnect the battery from

negative ground to prevent injury from electric shock

or other injury.

Note : Due to continuous product improvement,

specifications are subject to change without notice.

WARNING

Do not install in a wet or dusty place, or area of

high humidity. Failure to observe this may result

in electric shock.

Insert with the correct battery polarity. When inserting

the batteries, be sure that proper polarity (+ and -)

are as instructed. Rupture and chemical leakage

from the battery may cause fire or personal injury.

Specific knowledge and experience are needed for

installation and wiring. Please contact your dealer.

Please use only in the vehicle. Failure to do so may

result in electric shock or injury.

Do not place hands, fingers or foreign objects in gaps.

Doing so may result in personal injuryor damage

to the product.

Cautions on Usage (Common)

Do not use mobile phone or other wireless device close

to this unit.

Do use only for domestic use.

Fuse replacement

In cases where the temperature in the cabin is extremely high

(parking below sunlight) or extremely cold (parking in winter),

please wait until the temperature becomes normal level

before using the device.

Since the back of the monitor is made from soft material,

do not wipe or rub it with hard materials.

This could cause noise or system malfunction. It is

recommended to use mobile phones or wireless devices at

a distance from the unit.

Remote Starter and Car Security could also cause

system malfunction.

This product is assembled carefully and with high precision

parts. Please gently install the device to maintain original

performance from the first time of use.

Do not use excessive force.

Monitor Care

Do not use at extreme temperatures.

This product is only available for domestic use.

Unavailable for foreign use.

Do not wipe or rub the surface of monitor with hard things

due to it being easily scratched.

Use soft fabric to clean the monitor when dirty.

When you are replacing the fuse, please refer to the prescribed

fuse holder amperage. If the fuse is dropped, please carefully

check all the electrical connection parts to ensure they are not

shorted. Moreover, please check the voltage of the vehicle to

ensure whether it is normal or not.

Do not place cloths soaked with water or neutral detergent

on the unit. This could cause the unit to breakdown due to

humidity emerging inside the unit.

In case of severe dirt, use a soft cloth soaked with neutral

detergent to clean the monitor.

FOR SAFE USE

CONTENTS

Picture Setting……….......................….…............... 8

Rear Vision Operation...….......……........…….…..... 12

System Setting……………………............................ 10

Installation of Silicone spacer...………….….............. 15

Overhead Monitor……………….........………........... 5

Warning.…………………………………………........... 2

Visual EQ Setting………………………………........... 8

Remote Control…………………………….......... 6

DVD, iPod, CD/MP3/WMA/ACC

and Other Operation............................................... 13

Dome Light Operation…………................…........... 7

Monitor……………...........................….…........ 6

Installation of Bracket…………………….................. 15

Turning Power ON / OFF…………………................. 6

Monitor Installation........…….................................. 16

Display Mode Setting……….................................... 9

Cautions on Use (Common)…………………............ 3

Remote Control…………………………….……......... 6

Turning Dome Light ON / OFF…………........... 7

Remote Control Battery Replacement…………...... 20

Dome Light wire Diagram.....………........................ 17

Specification……………………………...…….......... 21

Troubleshooting…………………………...…............. 20

Basic Connection Diagram....................................... 18

Accessories................…………………….……........ 14

Introduction………………………………….……........ 14

Example of System Upgrades................................... 19

RTN

MONITOR

MODE

ENTER

SETUP

MUTE

POWER

RTN

MODE

ENTER

SETUP

POWER

MUTE

SLICE SWITCH

SETTING

Display Mode Setting

Adjust color level of the screen.

Tint :

Note

The Picture Setting will not be reset while exiting

setting screen without pressing ENTER .

Contrast :

Color :

Brightness:

Picture Setting Reset :

Shapness :

Return :

Adjust contrast of the screen.

Adjust tint of the screen.

Adjust sharpness of the screen.

Adjust brightness of the screen.

Return to the previous screen.

Return : Return to the previous screen.

Run : Run to reset.

Reset Picture Setting to default value.