Altronix AL624TE220 User manual

AL624TE220
Power Supply / Charger
Overview:
AL624TE220 power supply/charger converts 220VAC input into 12VDC @ 1.2A of continuous supply current (see speci-
fications). This general purpose power supply has a wide range of applications for access control, security, and CCTV
system accessories that require additional power.
Specifications:
Installation Instructions:
1. Mount AL624 into power supply enclosure with nylon fasteners (Figs. 1-3, pg. 2) (four (4) supplied).
2. Mount power supply unit enclosure in the desired location.
3. Connect blue and yellow leads from transformer secondary to the terminals marked [AC].
4. Connect 220VAC power to the black and white flying leads of the transformer.
5. Unit is factory set for 12VDC output.
6. Measure output voltage before connecting devices. This helps avoiding potential damage.
7. Connect devices to be powered to the terminals marked [+ DC] and [DC - BAT], carefully observing polarity.
8. Connect battery to the terminals marked [BAT +] and [DC - BAT] (battery leads included)
Note: When batteries are not used, a loss of AC will result in a loss of output voltage.
LED Diagnostics:
Red (DC) Green (AC) Power Supply Status
ON ON Normal operating condition.
ON OFF Loss of AC, Stand-by battery supplying power.
OFF ON No DC output. Short circuit or thermal overload condition.
OFF OFF No DC output. Loss of AC. Discharged or no battery present.
Terminal Identification:
Terminal Legend Function/Description
AC/ AC Low voltage AC input (T1656220).
- DC + 12VDC @ 1.2A continuous supply current.
+ BAT - Stand-by battery connections. Maximum charge rate 300mA.
Input:
• 220VAC, 50/60Hz, 0.25A.
Output:
• 12VDC output.
• 12VDC @ 1.2A supply current.
• Filtered and electronically regulated output.
• Short circuit and thermal overload protection.
Battery Backup:
• Built-in charger for sealed lead acid or gel type batteries.
• Automatic switch over to stand-by battery when AC fails.
• Maximum charge current 0.3A.
• PTC battery protection.
Visual Indicators:
• AC input and DC output LED indicators.
Features:
• Power supply/charger with enclosure and T1656220
transformer (16.5VAC/56VA).
• Extremely compact design.
• Includes battery leads.
Enclosure Dimensions (H x W x D approx.):
8.5” x 7.5” x 3.5” (215.9mm x 190.5mm x 88.9mm).

White
Lead
Black
Lead
220VAC input
50/60Hz,
0.25A
AC AC +DC -BAT +
AC DC
FACTORY SET AT 12V
CUT J1 FOR 24V
CUT J2 FOR 6V
J1
J2
Altronix is not responsible for any typographical errors. Product specifications are subject to change without notice.
140 58th Street, Brooklyn, New York 11220 USA | phone: [phone] | fax: [phone]
website: www.altronix.com | e-mail: [email protected] | Lifetime Warranty | Made in U.S.A.
IIAL624TE220 - Rev. 081015 I25Q MEMBER
Fig. 1: AL624
Fig. 2: Enclosure
Fig. 3:
Nylon Fastener
Springlock
STEP 1: Use these holes to mount
AL624 by pushing the
nylon fasteners
(fig. 3) through the back
of the enclosure. Nylon
fasteners will snap
into place.