ALZA ID151 User manual

Smart HRM Bracelet
USER MANUAL

2
The user manual contains product features, instructions for use, and the operating
procedure. Read the user manual carefully to get the best experience and avoid
unnecessary damage. Keep this manual for future reference.
Setting Up Your Device
Use the VeryFitPro app on an iOS or an Android smart phone to set up the wristband.
Note: hardware and system of devices should meet the requirements.
iOs 8.0 & above Android 4.4 & above Bluetooth support (4.2 &
above)
1. Download VeryFitPro
Search and Download
Search and download the “VeryFitPro“ from the Apple Store or the Android App Store.
Scan the QR Code and Download
Your device may have problems with opening the link directly through scan tools such
as WeChat. Please copy the link and open it through your browser.
2. Product Activation and Installation
The product must be activated by charging before initual use. After first use, charge the
product to ensure a normal power supply. The hand ring will automatically power on.
To take out the battery, pull open the strap and take out the bracelet body.

3
Charging the battery: Insert the chip-mounted end of the bracelet body into the USB
interface to activate the product by charging (be cautious to not reverse the polarity, and
comply with the required voltage and current: 5V / 500mA)
Installation: Mount the bracelet body into the slot of the wrist strap.
Wearing: Adjust the length of the wrist strap until it is appropriate to wear it on the wrist.
3. Touch Key
To change the interface, press the touch key once.
To confirm, press and hold the touch key.
4. Using the VeryFitPro App
Make sure that your smartphone has Bluetooth enabled!
When selecting the right band from the search list,
please slide the screen of the wristband to wake up the
device and then complete the connecting process.

4
Know Your Device
1. Wearing Method
Wear the device on your wrist horizontally, about 2cm to your carpal, the same as
wearing a watch.
2. Heart Rate Monitoring
To monitor your heart rate more accurately, please wear the device on your upper wrist
while it is fit a bit tighter than usual when you are exercising.
3. Heart Rate Monitoring Automation
Automatic heart rate monitoring is ON by default, monitoring your heart rate all day
automatically.
4. Interface
Press the touch key to display the functions below successively.
Time
Data Mode
Heart Rate
Mode
Sports
Mode
Stopwatch
Alarm
Clock
Mode
Function Introduction
1.1 Time Mode
Instructions
Time dial can be switched as follows: App Devices Mode > More [press the
touch key] to enter the next mode: Data Mode (you can customize the
shortcut through the app)
1.2 Data Mode
Press the touch key to enter the next mode: Data Mode (you can customize
the shortcut through the app)

5
1.2.1 Data Reading Sub-Mode
Press the touch key to enter the next sub-mode.
Note: To go back to the Data Reading Mode by pressing the
touch key on the final interface of the Data Reading Sub-
Mode
1.3 Heart Rate Mode
On the
hand
Off the
hand
Before Data
Is Displayed
After Data Is
Displayed
Note: If you stay at the Heart Rate interface for 1s, start monitoring the heart rate, and a
figure such as is displayed, the correct data is still not being monitored. Give the
device a bit of time. Once the device starts displaying the correct BPM, the figure
will be replaced with a number. Press the touch key to enter into the next mode.
1.4 Sports Mode
Press and hold the touch key for 2s to enter the Sports Starting Mode.
Press the touch key to enter the next sports mode.
Note: Types of sports can be selected in the App (the app can handle 3 types
of track recording sports and 11 types of other activities)
1.4.1 Sports Starting Mode
After the countdown interface of 3-2-1-GO finishes, the
Sports Underway Mode starts up.

6
1.4.2 Sports Underway Mode
Sports Main
Interface
Steps/Calories
Distance/Pace
Real-Time Heart
Rate
Press the touch key to enter the next sub-mode.
Press and hold the touch key for 2s to exit the sports mode.
Note: The speed and distance of riding can be displayed, but the app needs to be
connected and the riding app needs to be on at the same time.
1.4.3 Sports Pause Mode
Press and hold the touch key for 2s to go to the Sports Ongoing Mode.
Note: This function can only be launched through the app, which can realize
the pause/starting/exit functions while the watch can only control the exit
function.
1.4.4 Exit Sports Ongoing Mode
1) If the activity lasts less than 1 minute, the user will be reminded of not
saving the data.
Press the touch key to enter the main interface of the Sports Mode (the data
reading interface of sports data display mode not displayed)
2) If the activity lasts more than 1 minute, the Sports End Reminder will be
displayed.
Press the touch key to enter the sports data display mode.

7
1.4.5 Data Display After Sports Mode
Steps/Calories
Distance/Average Pace
Average Heart
Rate/Duration
Press the touch key to enter the next Sports Data Display Mode. A single press while on
the final interface will send you back to the first interface of the Sports Mode
1.4.6 Reminders in Sports Mode
1) Reminder of exiting from Sports Mode upon a period of no activity.
Press the touch key to remove the reminder of automatic shutdown from
Sports Mode
Note:
1. If there is not activity in within a period of 15 minutes, a reminder will be displayed
for 15 seconds before shutting down.
2. New activities will remove the reminder of automatic shutdown from the Sports
Mode.
3. If there are no new operations before the end of the countdown of automatic
shutdown from the Sports Mode, it will exit from the Sports Mode.
2) Reminder of Full-Ram Force Quit
Press the touch key to confirm the Full-Ram Force Quit.
Note: When the memory of the wrist strap is full of activity data, the user will
be reminded of exiting from the Sports Mode.

8
3) Reminder of Force Quit for Low-Battery
Press the touch key to accept the force quit from the Sports Mode.
Note: During the sports activities, when the power is too low, the sport mode
will pause and remind the user to force quit from the sports mode.
4) Reminder of Inaccesible Sport Mode for Low Battery
Press the touch key to accept the inaccesibble sports mode for a low battery.
Note: The reminder will pop up when a user tries to starts the Sports Mode
with the battery of the device being close to depleted.
5) Abnormal Operation During Sports
This remainder will be available soon.
Press the touch key to quit the reminder waiting mode.

9
1.5 Stopwatch Mode
Press the touch key:
If setting in the app and synchronizing the alarm clock, the device will enter
the Alarm Clock Mode. Otherwise, it will enter Time Mode.
Press and hold the touch key foor 2s:
Enter stopwatch timekeeping.
1.5.1 Stopwatch Timekeeping Ready Mode
Press the touch key to enter the Stopwatch Timekeeping Mode.
Press and hold the touch key for 2s to return to Stopwatch Mode.
1.5.2 Stopwatch Timekeeping Mode
Press the touch key to enter the Stopwatch Timekeeping Pause Mode.
Press and hold the touch key for 2s to return to Stopwatch Mode.
1.5.3 Stopwatch Timekeeping Pause Mode
Press the touch key to enter the Stopwatch Timekeeping Pause Mode.
Press and hold the touch key for 2s to return to Stopwatch Mode.
1.6 Alarm Clock
Press the touch key to return to Time Mode.
Press and hold the touch key for 2s to start/close the alarm clock.
Note: Alarm Clock functions should be turned on in the app for
the alarm clock to be displayed.
Start Close

10
2. More Modes of Reminders
1) Call Reminder
Press the touch key to remove the call reminder.
Press and hold the touch key to hang up the call.
Note: The call reminder in the app needs to be set to open.
2) Message Reminder
In case of multiple page messages, press the touch key to read the remaining
ones.
Note: The relevant settings need to be enabled in the app.
3) Alarm Clock
Meeting
Wake Up
Party
Appointment
Sleeping
Exercise
Medicine
Taking
Alarm Clock Mode: The relevant settings need to be enabled in the app.
4) Long Sitting Reminder
Long Sitting Reminder: The relevant settings need to be
enabled in the app.
Pressing the touch key will remove the reminder.
5) Target Completion Reminder
When some of your goals are achieved, shake the wrist strap to get the
interface of target completion displayed. Press the touch key to remove the
reminder.

11
6) Low Battery Reminder
Press the touch key to remove the reminder.
7) Ultra-Low Battery Reminder
The device will stay at this page, unable to enter other modes.
8) Device Error Notification
Note: When the device detects an abnormality, the interface herein will be
displayed each time the device is opened.
Status Codes:
-01: Abnormality of acceleration sensor.
-02: Abnormality of heart rate sensor.
-03: Abnormality of touch key IC.
-04: Abnormality of flash.

12
Basic Specifications
Model No.: ID152
Battery Capacity: 90mAh
Working Voltage: 3.7V
Host Weight: about 23.5g
Sync: Bluetooth 4.2
Working Temperature: -20°C – 40°C
Waterproofing: IP68
Working Time: 7 days
Product Frequency Band: 2402-2480MHz
Maximum Transmit Power: 0dBm
Wearing and Maintenance
Our products are designed wear throughout the day. Please follow instructions while
wearing and maintaining your device. To keep your wristband clean and your skin
comfortable, please follow the following tips:
•Regularly clean your wrist and the smart wristband, especially after sweating from
exercising or exposure to substances such as soap or detergent, which may attach
on the internal side of the wristband.
•Do not wash the wristband with household cleanser. Please use soapless detergent,
rinse thoroughly and wipe with a piece of soft towel or napkin.
•For spots or stains that are not easy to remove, scrub with alcohol and then follow
the above steps.

13
NOTICE
By using this product, you agree that the measurements are indicative, cannot be taken
into account and do not in any way replace a doctor’s evaluation (or other therapies)!
Therefore, do not evaluate the measured values yourself and do not determine the
therapy yourself according to them. Follow your doctor's instructions and trust his
diagnosis. Take your medicine as instructed by your doctor and never change the dose.
The measured values determined by you can only be used for your information - they
do not replace a medical examination! Discuss your measured values with your doctor,
definitely do not make any medical decisions based on them (for example, the use of
drugs and their dosage)!
The importer is not liable for the measured values.
Do not use the watch in extreme temperatures (below -10 ° C and above 40 ° C).
Reassembling or modifying the product impairs its safety. All modifications and repairs
to the equipment or accessories must be carried out by a specialist. Never open or
repair the product yourself! Handle the product carefully. It can be damaged by blows,
falling from a height, etc.
Technical specifications are subject to change without notice. Never heat the battery
above 50°C and do not dispose of in fire, risk of explosion / fire! Do not short-circuit the
battery. Do not subject the battery to mechanical stress. Avoid dropping, bumping,
bending, twisting or cutting the battery. If the battery overheats, stop charging
immediately. A battery that overheats or deforms during charging is defective and
should not be used. Never discharge the battery completely, as this will shorten its
lifespan.
Store out of direct sunlight at room temperature.
Keep the product out of the reach of small children – there is a risk of suffocation by
small parts.
Do not place the device near heat sources.
Connect to the correct power sources.

14
WARRANTY CONDITIONS
A new product purchased in the alza.cz sales network is warranted for 2 years. If you
need repair or other services during the warranty period, contact the product seller
directly, you must provide proof of purchase with the original date of purchase.
The following are considered to be a conflict with the warranty conditions, for which the
claimed claim may not be recognized:
•Use of the product for a purpose other than that for which the product is intended
or failure to follow the instructions for maintenance, operation and service of the
product.
•Damage to the product due to a natural disaster, the intervention of an
unauthorized person or mechanical damage through the fault of the buyer (eg
during transport, cleaning by inappropriate means, etc.).
•Natural wear and aging of consumables or components during use (such as
batteries, etc.).
•Exposure to adverse external influences, such as sunlight and other radiation or
electromagnetic fields, ingress of fluid, intrusion of objects, mains overvoltage,
electrostatic discharge voltage (including lightning), faulty supply or input voltage and
inappropriate polarity of this voltage, chemical processes, eg used power supplies,
etc.
•If modifications, alterations, design changes, or alterations have been made to
anyone to change or extend the product's features over the purchase or use of non-
genuine components.
FAQs
Failed to find the device when pairing.
1. Make sure that your smartphone has Bluetooth enabled, and your device has the OS
Android 4.4 & above, or iOs 8.0 & above
2. Make sure the distance between your device and smartphone is within 0.5 meters,
and that the device is within the normal Bluetooth communication distange range
(within 7 meters) after the pairing is finished.
3. Make sure the device isn’t running low on power. If there is still a problem after fully
charging the device, please contact us.
Failed to connect with Bluetooth occasionally.
1. Caused by the abnormality of Bluetooth service when it is restarted on the phone.
2. Reboot your mobile phone or restart the Bluetooth service, after that the device
should work normally.
How to restore factory defaults.
Make sure the device is connected with a smart phone. Go to the app, enter “Device“,
“Systsm Settings“ and choose “Reboot Device“.

15
EU DECLARATION OF CONFORMITY
Identification data of the manufacturer's / importer's authorized representative:
Importer: Alza.cz a.s.
Registered office: Jankovcova 1522/53, Holešovice, 170 00 Prague 7
IČO: 27082440
Subject of the declaration:
Title: Smart HRM Bracelet
Model : ID151
The above product has been tested in accordance with the standard (s) used for
demonstrationin accordance with the essential requirements laid down in the Directive
(s):
Directive No. 2014/53 /EU
Directive No. 2011/65/EU as amended by 2015/863/EU
Reference to harmonized standards:
EN 62479:2010
EN 60950-1:2006 + A11:2009 + A1:2010 + A12:2011 + A2:2013
EN 301 489-1 V2.1.1
Draft EN 301 489-17 V3.2.0
EN 300 328 V2.1.1
Prague, 7/23/2020
WEEE
This product must not be disposed of as normal household waste in accordance with
the EU Directive on Waste Electrical and Electronic Equipment (WEEE - 2012/19 / EU).
Instead it shall be returned to the place of purchase or handed over to a public
collection point for the recyclable waste. By ensuring this product is disposed of
correctly, you will help prevent potential negative consequences for the environment
and human health, which could otherwise be caused by inappropriate waste handling of
this product. Contact your local authority or the nearest collection point for further
details. Improper disposal of this type of waste may result in fines in accordance with
national regulations.
All rights reserved. ©2020 alza.cz