9600-0306. Installation and User Instructions for S813
Readers, Issue 1.0x1 22nd May 2003. AMAG
Technology, 2003.
Bioscrypt is a registered
trademark of Bioscrypt Inc.
FCC Notice: This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired operation.
Any unauthorized modification to this device may void the
authority of the user to operate it.
All trademarks acknowledged. Philips and MIFARE are
registered trademarks of Philips Electronics, N.V. MV1200
is a trademark of Bioscrypt Inc.
©
4Using the Reader
3Reader Connections
Connect screen at controller
end only (attach to case).
S813 Reader TB1
Specifications
Input voltage: 9-14V.
Input current: 100mA.
Operating temperature: 32 to 122 F (0 to 50 C).
Operating humidity: 15 to 90%, non-condensing.
Maximum read range: 1" (25mm).
Approvals: EN50133, R&TTE, IP605.
For internal use only.
°°
Present the proximity card face-on close to the reader until you hear a "bleep".
After presenting your card, you may be prompted to enter a PIN and/or place your finger on the
finger pad. You may also be prompted to place a second finger on the finger pad. Follow the on-
screen instructions.
The system can be set up to generate a "duress" transaction if the pre-defined duress finger is
placed on the pad. In two-finger mode, the duress finger must be placed first.
0V
RX+
RX-
TX+
TX-
12V
Controller connections
(20mA current loop)
0V
TX+
TX-
I/0
SCR (not used)
RX+
RX-
+12V
The I/O terminal is for connection to a
RIM - see the Installation Instructions for
S660 Remote Interface Module (RIM).
On completion, re-secure the reader to the backplate.
Twisted pairs (use
Belden 9503 cable)
2
