Amart Furniture Albion 62891 User manual

Imported by Amart Furniture Pty Ltd, Qld, Brisbane Australia.
For any assistance with assembly or for missing parts please
phone Amart Furniture Ewing Road, Customer Service Free call 1800 351 084
ASSEMBLY INSTRUCTION
Imported by Amart Furniture Pty Ltd, Qld, Brisbane Australia.
For any assistance with assembly or for missing parts please phone
Amart Furniture Ewing Road, Customer Service Free call 1800 351 084
Albion Office Chair
ITEM CODE:62891
1-8 62891

PRE-ASSEMBLY PREPARATION
ALLOW 20 MINUTES 1 PEOPLE REQUITED
ADDITIONAL TOOLS REQUIRED
2-8 62891
Before you start:
1.Choose a clean,level,spacious assembly area.Avoid hard surfaces that
may damage the product.
2.Take care when lifting.Product should be assembled as near as possible to
the point of use.
3.Ensure that you have all required contents for complete assembly.
4.Always read the assembly instructions carefully before beginning assembly .
5.Keep all hardware parts and packaging out of reach of small children.
6.Do not over tighten the screws and bolts as this may damage the threads.

PARTS LIST
1 BACK
2 ARMREST (L)&(R)
3 SEAT
4 MECHANISM
5 GAS LIFT
6 GAS LIFT COVER
7 BASE
8 CASTOR
M6x18mm
4xPCS
bolt bolt
AB
M6x25mm 4xPCS
C
3-8 62891
D
rubber plug
M8x55mm 4xPCS
Φ15mm 4XPCS
E
Allen key 1pc
bolt

STEP 1:
STEP 2:
4-8 62891
STEP 1:
Insert castor 8 to base 7 .
Put gas lift 5 into base 7 as instruction shown, then put gas lift
cover 6 on gas lift 5 .Remove gas lift cover before assembly.
7
8
6
5

5-8 62891
STEP 3:
Attach mechanism 4 to seat 3 using bolt A. Fasten by allen key.
STEP 4:
Turn back the seat 3 attach back 7 to seat 3 using bolt B. Fasten by
allen key.
B
11
3

STEP 5:
As shown, attach armrests 2 to back 1 and seat 3 using bolt C.
Fasten by allen key.
STEP 6:Lift back 1
As shown, insert rubber plug D into armrest 2
6-8 62891
C
11
2
11
2
3
D
22

7-8 62891
STEP 7:
As shown, put the assembly chair body into gas lift 5 .
STEP 8:
As shown, put the assembly chair body into gas lift 5 .
3
5

8-8
CARE AND MAINTENANCE
DO NOT STAND ON THIS CHAIR-DO NOT USE THIS CHAIR AS STEP LADDER.
USE THIS PRODUCT ONLY FOR SEATING ONE PERSON AT A TIME.
DO NOT USE THIS CHAIR UNLESS ALL BOLTS, SCREWS AND KNOBS ARE
FIRMLY SECURED.
AT LEAST EVERY 4 MONTHS, CHECK ALL BOLTS, SCREWS AND KNOBS TO
BE SURE THEY ARE TIGHT.
IF PARTS ARE MISSING, BROKEN, DAMAGED OR WORN, STOP USE THE
PRODUCT UNTIL REPAIRS ARE MADE. USING FACTORY AUTHORIZED PARTS.
FAILURE TO FOLLOW THESE WARNINGS COULD RESULT IN SERIOUS INJURY.
OFFICE CHAIR
DO NOT REMOVE THIS LABEL
62891
STEP 9:
Assembly is complete.