Amart Furniture ORWELL 64930 User manual

Imported by Amart Furniture Pty Ltd, Qld, Brisbane Australia.
For any assistance with assembly or for missing parts please phone
Amart Furniture, Customer Service Free call 1800 351 084
ASSEMBLY INSTRUCTION
ORWELL 3 SEATER CHAISE
ITEM CODE 64930
Imported by Amart Furniture Pty Ltd, Qld, Brisbane Australia.
For any assistance with assembly or for missing parts please phone
Amart Furniture, Customer Service Free call 1800 351 084
64930
PAGE OF 71
75cm
Depth: 98cm / 168cm

PRE-ASSEMBLY PREPARATION
Before you start:
1. Choose aclean, level, spacious assembly area.Avoid hard surfaces that may
damage the product
2. Take care when lifting.Product should be assembled as near as possible to
the point of use
3. Ensure that you have all required contents for complete assembly
4. Always read the assembly instructions carefully before beginning assembly.
5. Keep all hardware parts and packaging out of reach of small children.
6. Do not over tighten the screws and bolts as this may damage the threads
64930
PAGE OF 72

PARTS LIST
PAGE 3 OF 764930
PLEASE TAKE NOTE:
PIECES REQUIRE FOR ASSEMBLY ARE LOCATED INSIDE THE DUST
COVER UNDERNEATH SOFA
PART Ⅰ
PART Ⅱ
PART ⅠPART Ⅱ
Hardware

Step 1
Step 2 PART ⅠASSEMBLY COMPLETED
PART Ⅰ
64930
PAGE 4 OF 7
With 2 people carefully turn sofa onto its front on a piece of cardboard or sheet to protect
fabric.
DETAILS (1) -Align base plate of each foot (A) with the pre-threaded holes in the undersides
of the sofa as shown in the below diagram.
Insert Bolt (B) and tighten by turning clockwise using Allen key (C).
DETAILS (2) –Insert the thread of the support leg (D) into the corresponding support leg
hole.
A
A
AA
A
D
D
B
B
A

PART Ⅱ
Step 3
Step 4 PART ⅡASSEMBLY COMPLETED
64930
PAGE 5 OF 7
With 2 people carefully turn sofa onto its front on a piece of cardboard or sheet to protect
fabric.
DETAILS (1) -Align base plate of each foot (A) with the pre-threaded holes in the undersides
of the sofa as shown in the below diagram.
Insert Bolt (B) and tighten by turning clockwise using Allen key (C).
DETAILS (2) –Insert the thread of the support leg (D) into the corresponding support leg
hole.
DD
B
B
A
B
B
A
A
A
A
A
D

Step 5 ASSEMBLY COMPLETED
PART ⅡPART Ⅰ
PART ⅡPART Ⅰ
64930
PAGE 6 OF 7
IMPORTANT:
PLEASE ENSURE FEET ARE TIGHTENED SECURELY BEFORE USE!

CARE LABEL
64930
PAGE OF 77