Amart Furniture SETTLER 63444 User manual

Imported by Amart Furniture Pty Ltd, Qld, Brisbane Australia.
For any assistance with assembly or for missing parts please phone
Amart Furniture, Customer Service Free call 1800 351 084
ASSEMBLY INSTRUCTION
SETTLER 4 DRAWER OFFICE DESK
ITEM CODE 63444
Imported by Amart Furniture Pty Ltd, Qld, Brisbane Australia.
For any assistance with assembly or for missing parts please phone
Amart Furniture, Customer Service Free call 1800 351 084
163444

PRE-ASSEMBLY PREPARATION
Before you start:
1. Choose a clean, level, spacious assembly area. Avoid hard surfaces that may
damage the product
2. Take care when lifting. Product should be assembled as near as possible to
the point of use
3. Ensure that you have all required contents for complete assembly
4. Always read the assembly instructions carefully before beginning assembly.
5. Keep all hardware parts and packaging out of reach of small children.
6. Do not over tighten the screws and bolts as this may damage the threads
263444
20
2

PARTS LIST
363444

STEP 1:Flip the desk top① upside down on the carton carefully.
Put 1 pc wooden dowel onto pedestal② right top.Put another 1
pc wooden dowel onto gable④ top.Remove the first drawer
from the right hand side pedestal②.
STEP 2: Carefully lift the pedestal② upside down on the desk
top① and ensure the dowels sit firmly over the holes.
463444

STEP 3:Put furniture connector on both side of the front
rail,Fasten the front rail ③to the pedestal② with the allen
bolt(b).
STEP 4: Flip the gable④ upside down on the desk top ①
carefully. Fasten the gable ④ to the front rail③ with allen bolt
(b). Put furniture connector on both side of the back rail,Fasten
the back rail⑤ to the pedestal② and the gable④ with the allen
bolts(b).
563444

STEP 5: Mount the gable and the front rail with holes. Fasten
down screws(a) with screwdriver.
ASSEMBLY IS COMPLETE
663444

763444
SAFETY BRACKETS INSTRUCTIONS
NOTE- This product must be fixed to a wall. It is important to ensure the correct wall fixings
are used. Failure to do so may result in personal injury or property damage caused by the
item toppling over. As wall materials vary greatly, the fastener required to fix this product to
a wall is not included. If unsure, consult your local hardware store for advise on wall fixings
suitable for your situation.

863444
CARE AND MAINTENANCE
Timber
As our timber is supplied from sustainable forests there will be natural variations in surface
texture and grain like knots, mineral streaks
and sap runs that may affect the finish. These differences in character are not defects, but
distinctions that make each piece of
furniture unique
Our furniture is built to last. Following these steps for basic care should protect your
investment for years to come
•Dust frequently with a clean damp lint-free cloth. This will help remove abrasive build up
which can damage a finish over time
•Do not place hot objects on any furniture surface. Always use a hot plate or placemat.
Laminate and lacquer finishes on table tops
•provide added scratch and heat resistance to our furniture, but they can still be damaged
without proper care
•Avoid exposing your furniture to strong sunlight, heat outlet, open windows or dampness.
Prolonged exposure to direct sunlight can
•fade the finish of your furniture, while extreme temperature and humidity changes can
cause cracking or splitting
•Do not expose your furniture to any liquids. Never allow water to sit on your furniture.
Alcohol, nail polish and perfume are also
•dangerous as they will dissolve the lacquer finish on contact and may require professional
repairs
•Do not allow plastic to come in direct contact with your furniture. Chemicals in the plastic
of placemats etc. may soften and mark the finish if left in contact with the furniture for a
period of time