Amart Furniture Addison 53854 User manual

ASSEMBLY INSTRUCTION
ADDISON JUMBO SINGLE BED
ITEM CODE - 53854
Imported by Amart Furniture Pty Ltd,Qld, Brisbane Australia.
For any assistance with assembly or for missing parts please phone
Amart Furniture, Customer Service Freecall 1800 351 084.
Imported by Amart Furniture Pty Ltd,Qld, Brisbane Australia. For any assistance
with assembly or for missing parts please phone Amart Furniture, Customer
Service Freecall 1800 351 084.
153854
1225mm
1158mm
2272mm
Furniture

PRE-ASSEMBLY PREPARATION
BEFORE YOU START....
1. Choose a clean, level, spacious assembly area. Avoid hard surfaces that may
damage the product.
2. Check and ensure that you have all required contents for complete assembly.
3. Always read the assembly instructions carefully before beginning assembly.
4. The packaging and contents can be a choking hazard, therefore keep out of reach
of small children at all items.
5. Do not over tighten the bolts as this may damage the thread.
ALLOW 45 MINUTES 2 PEOPLE REQUIRED
2
ADDITIONAL TOOLS REQUIRED
53854

3
HEAD BOARD1
2
3
4
SIDE RAIL
WOOD SLAT
PARTS LIST
FOOT BOARD
M8- Allen key
A-12 Pcs
M8x20mm
C-1 Pc
Chipboard screw
B-8 Pcs
#4 x 30 mm
1
2
3
4
53854
- 18mm x 59mm x 1065mm
1 pc
1 pc
2 pcs
14 pcs

4
STEP 1 : Fix bolts 'A' into position on wood post as shown. Important note : Do not tighten the bolts yet!
STEP 2 : Hook the side rail to the bolt and fix center bolts 'A ' as shown and tighten all bolts.
1A
2
3
A
53854

5
ASSEMBLY COMPLETE
STEP 3 : Put wood slats to the side rail support and fix screw 'B' at hole as shown.
B
53854

653854
Product Care for Hi-Gloss Items
Hi-gloss lacquered furniture is more sensitive to marks and scratching then some other furniture
products. It is important to exercise caution and care to maximise the life and beauty of
this product.
Following the below simple guidelines when using your hi-gloss product will protect your
investment for years to come.
.Dust frequently with a clean damp lint-free cloth. This will help remove
abrasive build up which can damage a finish over time.
.Do not place hot objects on any furniture surface. Always use a hot plate or
placement. Laminate and lacquer finishes on table tops provide added scratch
and heat resistance to our furniture, but they can still be damaged without
proper care.
.Avoid exposing your furniture to strong sunlight, heat outlet, open windows or
dampness. Prolonged exposure to direct sunlight can fade the finish of your
furniture, while extreme temperature and humidity changes can cause
cracking or splitting.
.Do not expose your furniture to any liquids. Never allow water to sit on your
furniture. Alcohol, nail polish and perfume are also dangerous as they will
dissolve the lacquer finish on contact and may require professional repairs.
.Do not allow plastic to come in direct contact with your furniture. Chemicals in
the plastic of placements etc may soften and mark the finish if left in contact
with the furniture for a period of time.
.Avoid placing sharp or rough objects on the surface of your furniture. These
may scratch the surface of the product.
.When moving your furniture, do not drag it across the floor. This may damage
the product. Instead use two (2) people to lift carefully from either end.