Amart Furniture Verdana 62908 User manual

Imported by Amart Furniture Pty Ltd, Qld, Brisbane Australia.
For any assistance with assembly or for missing parts please
phone Amart Furniture Ewing Road, Customer Service Free call 1800 351 084
ASSEMBLY INSTRUCTION
Imported by Amart Furniture Pty Ltd, Qld, Brisbane Australia.
For any assistance with assembly or for missing parts please phone
Amart Furniture Ewing Road, Customer Service Free call 1800 351 084
Verdana Office Chair
ITEM CODE:62908
1-7 62908
99-109CM
59.5CM
60CM

PRE-ASSEMBLY PREPARATION
ALLOW 20 MINUTES 1 PEOPLE REQUITED
2-7 62908
Before you start:
1.Choose a clean,level,spacious assembly area.Avoid hard surfaces that
may damage the product.
2.Take care when lifting.Product should be assembled as near as possible to
the point of use.
3.Ensure that you have all required contents for complete assembly.
4.Always read the assembly instructions carefully before beginning assembly .
5.Keep all hardware parts and packaging out of reach of small children.
6.Do not over tighten the screws and bolts as this may damage the threads.

PARTS LIST
1 BACK
2 ARMREST (L)&(R)
3 SEAT
4 MECHANISM
5 GAS LIFT
6 GAS LIFT COVER
7 BASE
8 CASTOR
4xPCS
M6x16mm
bolt bolt bolt
AB
M6x25mm 4xPCS
C
3-7
rubber plug
8XPCS
Φ15mm
62908
DEM8x45 4xPCS
□□
Allen key 1PCS
2
3
6
7
8
1
5
4

STEP 1:
STEP 2:
4-7 62908
STEP 1:
8
7
Insert castor 8 to base 7 .
Put gas lift 5 into base 7 as instruction shown, then put gas lift
cover 6 on gas lift 5 .Remove gas lift cover before assembly.
5
6

5-7 62908
STEP 3:
Attach mechanism 4 to seat 3 using bolt A. Fasten by allen key.
STEP 4:
Attach back ①to seat ③and mechanism ④using bolt B.Fasten by allen
key.
A
4
3
4
3
1
B

STEP 5:
Attach armrest to seat ③ and back ① using bolt C. Fasten by allen key.
Then put rubber plug D into the armrest bolt holes.
STEP 6:
Put chair body into armrest ⑤.
6-7 62908
C
D3
2
1

7-7
CARE AND MAINTENANCE
DO NOT STAND ON THIS CHAIR-DO NOT USE THIS CHAIR AS STEP LADDER.
USE THIS PRODUCT ONLY FOR SEATING ONE PERSON AT A TIME.
DO NOT USE THIS CHAIR UNLESS ALL BOLTS, SCREWS AND KNOBS ARE
FIRMLY SECURED.
AT LEAST EVERY 4 MONTHS, CHECK ALL BOLTS, SCREWS AND KNOBS TO
BE SURE THEY ARE TIGHT.
IF PARTS ARE MISSING, BROKEN, DAMAGED OR WORN, STOP USE THE
PRODUCT UNTIL REPAIRS ARE MADE. USING FACTORY AUTHORIZED PARTS.
FAILURE TO FOLLOW THESE WARNINGS COULD RESULT IN SERIOUS INJURY.
OFFICE CHAIR
DO NOT REMOVE THIS LABEL
62908
STEP 7:
Assembly is complete.