Amazon COVID-19 Test Collection Kit User manual
Important: Read all instructions thoroughly before you start.
Your test kit includes a biohazard bag, test tube and nasal swab. If
you run into problems with your test kit, wipe down the area and
discard kit in the waste bin at check-in station. Get a new kit.
Put on gloves. Wipe the station
with disinfecting wipes. Then use
hand sanitizer.
Remove the lid from the tube.
Place the tube in the holder.
Do not spill the fluid in the tube!
Open the swab pouch and remove
from the package. Hold at the bottom.
Do not touch the soft tip!
Lower mask below your nose.
Keep your mouth covered.
Swab first nostril.
Insert the soft end of the swab 1 inch.
Rub the swab slowly against the inside
walls of your nostril at least 4 times.
This should take about 15 seconds.
Repeat in other nostril.
Place swab into the tube. Break
at the indicator line by bending
back and forth against the tube.
Tightly recap the tube.
Then place mask to cover your
nose.
Place the tube into bag.
Remove air and seal the bag.
Wipe the station and chair
with disinfecting wipes.
Put gloves and trash in the
waste bin at your station. Keep
your sample.
Put your sample in the
collection bin as you exit.
Do not spill the fluid in the tube!
Amazon COVID-19 Collection Kit | Questions: covid19testing@amazon.com
For use under emergency use authorization only. For prescription use only. For in vitro diagnostic use. For use by individuals 18 years of age or older. This product has not been FDA cleared or approved but has been authorized for emergency
use by FDA under an EUA for use by authorized laboratories. This product has been authorized only for the detection of nucleic acid from SARS-CoV-2, not for any other viruses or pathogens. The emergency use of this product is only authorized
for the duration of the declaration that circumstances exist justifying the authorization of emergency use of in vitro diagnostics for detection and/or diagnosis of COVID-19 under Section 564(b)(1) of the Federal Food, Drug and Cosmetics Act,
21 U.S.C. § 360bbb-3(b)(1), unless the declaration is terminated or authorization is revoked sooner.
If you cannot complete the test based on the
resources available at your testing station,
request a new kit.
Questions?
Biohazard bag
Tube
with saline
Nasal
swab
Your kit includes:
For additional questions, e-mail:
There is a problem with my kit.
Do not touch or drink the fluid in the tube. If the
fluid touches your eyes or skin, rinse with water.
Wipe the station and chair with
disinfecting wipes. Then use hand
sanitizer.
Remove the lid from the tube and
place the tube in the holder.
Do not remove gloves during sample
collection.
Do not remove mask. Keep your mouth
covered while collecting sample.
Do not spill the fluid in the tube! If you
spill the fluid, clean the area, discard
your kit, and get a new kit.
Open the swab pouch from the handle
end. Remove swab from the package.
Hold by the handle.
Do not touch the soft tip! If the swab
tip touches anything other than inside
your nostril, clean the area, discard
your kit, and get a new kit.
Lower face mask below your nose.
Swab first nostril.
Insert the soft tip of the swab 1/2 - 3/4
inch. Rub the swab in a slow circular
motion against the inside walls of your
nostril at least 4 times. This should take
about 15 seconds.
Repeat in other nostril.
Place swab into the tube. Break off
the swab handle.
To break the swab handle, hold the
tube firmly. Bend the handle at the
indicator line back and forth against
the tube until it breaks. Tightly recap
the tube.
Then place face mask back to cover
your nose.
Place the tube into the bag, remove
air, and seal the bag.
Wipe the station and chair with
disinfecting wipes.
Refer to the important reminders in
the left panel to ensure you collected
your sample correctly. If you have not
collected your sample correctly your
test cannot be processed.
Remove gloves and sanitize your
hands as you exit.
Put trash in the waste bin at your
station. Keep your sample.
Put your sample in the collection
bin as you exit.
Amazon Onsite COVID-19 Test Collection Kit. For use under emergency use authorization only. For prescription use only. For in vitro diagnostic use. For use by individuals 18 years of age or older. This product has not been FDA cleared or approved but has been authorized for
emergency use by FDA under an EUA for use by authorized laboratories. This product has been authorized only for the detection of nucleic acid from SARS-CoV-2, not for any other viruses or pathogens. The emergency use of this product is only authorized for the duration
of the declaration that circumstances exist justifying the authorization of emergency use of in vitro diagnostics for detection and/or diagnosis of COVID-19 under Section 564(b)(1) of the Federal Food, Drug and Cosmetics Act, 21 U.S.C. § 360bbb-3(b)(1), unless the
declaration is terminated or authorization is revoked sooner.
Amazon On-Site COVID-19 Test
Collection Kit
Do not spill the fluid in the tube! If you
spill the fluid, clean the area, discard
your kit, and get a new kit.
Carefully read all instructions
before you start.
Important reminders
Collect a sample from both nostrils.
The nasal swab tip should not touch anything
except inside your nostril.
Do not spill any of the fluid in the tube.
Carefully follow all instructions. If you
miss any testing steps your results may be
inaccurate or result in an error.
If the swab tip touches anything other than
inside your nostril, discard your kit in the waste
bin at check-in, clean the testing area with a
disinfecting wipe, and request a new kit.
If you spill the fluid in the tube, discard your
kit in the waste bin at check-in, clean the
testing area with a disinfecting wipe, and
request a new kit.
Keep your mask on while in the testing site.
Your mask should cover your mouth at all times.
If you have questions, ask the flow
monitor for help.
If you have questions, ask the flow monitor
for help.
What’s included
Important reminders
• Sample collection takes less than 10 minutes.
• Return your sample collection kit to your worksite
within 24 hours of collecting your sample. Late
samples cannot be processed.
• You must wash (or sanitize) your hands before you
collect your sample.
• You must register your sample collection kit to
get results.
Plastic bag
Instructions
for use
Collection tube
with saline
Nasal swab
Visit amazondx.com
Confirm your test details
Make sure your name and date of
birth are correct. Enter the
collection tube ID, found on the
side of your collection tube.
Press “Register kit”
Collect your sample immediately
after registering. Sample collection
takes less than 10 minutes.
XXX XXX XXX XXX X
Register your kit online
You must register your kit to get results.
Register kit
Or, view the QR code with your
camera app.
Sign in or create an account.
Collect your sample
Carefully read all instructions before collecting your sample.
Did you register your kit? If not, go back to steps 1–3.
Do not touch the soft tip of the swab.
Do not touch or drink the fluid in the collection tube.
If you spill the fluid or the swab touches any surface other than
inside your nostrils, clean the area with your routine household
surface disinfectant. Discard your kit components.
We recommend collecting your sample while seated.
Wash and dry your hands
Wash your hands with soap and
warm water for 20 seconds. Clean
the surface of the area where you will
collect your sample.
Use hand sanitizer if there is no sink.
Open the swab pouch
Peel back the tab on the handle end to
remove the nasal swab from the pouch.
Hold by the handle, do not touch the
soft tip. Discard the swab pouch.
Do not touch the soft tip of the
swab to any surface other than
inside your nostrils.
Swab first nostril
Insert the soft tip of the swab 1/2 -
3/4 inch inside your nostril. Rub the
swab in a slow circular motion against
the inside walls of your nostril at least
4 times.
This should take about 15 seconds.
Repeat in other nostril
Repeat the previous step in your
other nostril using the same swab.
continued on back
If the fluid touches eyes or skin, rinse with water.
Watch the overview video during the register kit experience.
Rewatch the video at: amazondx.com/testing-faq
• For frequently asked questions, visit
amazondx.com/testing-faq
For frequently asked questions, visit amazondx.com/testing-faq
1/2” -
3/4”
1/2” -
3/4”
Instructions for use
Amazon COVID-19
Test Collection Kit
Put swab in collection tube
While holding the swab, open the tube.
Put the tube cap with the flat top down
on a clean surface nearby. Put the swab
soft tip down in the tube.
Do not spill the fluid in the tube!
If you spill the fluid, clean the area
and discard your kit components.
Break off the swab handle
To break off the swab handle, hold
the tube firmly. Bend the swab
handle at the indicator line back and
forth against the collection tube until
it breaks. Discard the swab handle.
Recap the tube
Make sure the cap is on tight, so that
no fluid can spill out. If the tube leaks
we cannot process your sample.
Wash your hands (or use hand sanitizer).
Put tube inside the plastic bag
Put the sealed tube inside the plastic
bag. Release excess air from the bag
and seal it shut.
Clean the surface area with a disinfectant.
Checklist before returning your bag
I registered my kit (if not, go back to
steps 1-3).
I did not spill the fluid in the tube.
I collected a sample from both nostrils.
The nasal swab only touched my nostrils.
If you have not checked all of the boxes, your
test cannot be processed. Discard your kit
components and get a new kit.
Drop off your bag at your worksite
Within 24 hours drop off your sealed bag
at your designated worksite. Once your
sample has been sent to the lab, you will
receive updates via e-mail/SMS.
24
hours
Questions?
E-mail
amazondx.com/testing-faq
Frequently asked questions
The emergency use of this product is only authorized for the duration of the
declaration that circumstances exist justifying the authorization of emergency
use of in vitro diagnostics for detection and/or diagnosis of COVID-19 under
Section 564(b)(1) of the Federal Food, Drug and Cosmetics Act, 21 U.S.C. §
360bbb-3(b)(1), unless the declaration is terminated or authorization is
revoked sooner.
410 Terry Ave N, Seattle, WA 98109
For In Vitro Diagnostic Use Only. For Emergency Use Authorization Only.
Rx Only. For Use by Individuals 18 Years or Older.
This product has not been FDA cleared or approved but has been authorized
for emergency use by FDA under an EUA for use by authorized laboratories.
This product has been authorized only for the detection of nucleic acid from
SARS-CoV-2, not for any other viruses or pathogens.
