Amcrest SmartHome Corner Kit User manual

Thank you for purchasing an
Amcrest Corner Kit!
We wanted to personally reach out and thank you for
purchasing from our Amazon store. Selling on Amazon is
what we do to support our family, and product reviews are
the lifeblood of our business. It would mean the world to
us if you could take one minute of your time to help share
the love by leaving us an honest review using the link
below:
www.amazon.com/ryp
Thank you again for being one of our amazing
customers!
Sincerely,
Amcrest Team
Corner Kit
Installation Guide
SmartHome
Compatible
with AD110 2

Place the kit onto the installation
surface. Use a marker to mark the
installation holes.
A For Wood, Drywall or Soft Surfaces:
Align the installation slots with the marked
installation holes and secure the screws to
the surface using a Phillips head
screwdriver.
BFor Concrete, Stucco or Brick:
Using your previously marked holes as a
guide, drill holes into the mounting surface
using a 15/64” masonry drill bit. Then, insert
wall anchors and secure the kit to the
mounting surface. If using multiple layers
use the included ST4 35mm (long screw) to
secure the kit.
Step 2: Installing the Corner Kit
Step 1: Mark the Installation Holes
Introduction
The corner kit allows you to angle your Amcrest doorbell at either a
15°, 30°, or 45° angle. The kit is typically used to angle your Amcrest
doorbell away from a wall which helps to improve motion detection
and get a better view of visitors approaching the door.
What’s Included:
The corner kit comes with 3 stackable layers, 3 ST4 35mm (longer
screws), 3 ST4 25mm screws, and 3 wall anchors. A marker, a drill
with a 15/64” bit, and Phillips head screwdriver may be required to
install the kit.
Adding Stackable Layers
The corner kit comes in 3 stackable layers. Using one layer provides
a 15° angle, adding a second layer achieves a 30° angle, using all
three layers will angle your Amcrest doorbell 45°. Use the longer
screws to secure the corner kit to the mounting surface if multiple
layers are being used. Use the smaller screws if using a single layer.
NOTE The 15/64” masonry drill bit may be
required if installing on concrete stucco or brick. 3 4

Place the mounting bracket of the
Amcrest doorbell on the kit aligning
the installation holes of the bracket
to the installation holes on the kit.
Use a Phillips head screwdriver to
secure the doorbell’s mounting
bracket to the kit.
A Connect the doorbell
wiring through the back of
the kit and mounting plate
then secure the wires to the
doorbell terminals.
BPlace the doorbell flush
onto the mounting bracket
then secure the doorbell to
the bracket using the security
screw.
Step 3: Attach the Mounting Bracket
© 2020 Amcrest Industries LLC
All rights reserved.
Designed by Amcrest.
Assembled in China.
5