American Standard Colony 2740.102 User manual

COLONY™ 5’ X 30” w/INTEGRAL APRON
WHIRLPOOL AND BATHING POOL
HIGH GLOSS ACRYLIC
COLONY 5’ x 30” WHIRLPOOL AND BATHING
POOL with INTEGRAL APRON
❏2740.118 Whirlpool, Right Hand Outlet
❏2740.218 Whirlpool, Left Hand Outlet
Product Features:
• High Gloss Acrylic with fiberglass
reinforcement
• Integral apron with removable access panel
• Integral three-sided, tiling/water retention
flange
• Integral lumbar support
• Molded-in arm rests with elbow supports
• Safety textured tub bottom pattern
Factory installed and tested whirlpool system
featuring:
• Rigid P.V.C. piping
• 1 H.P. self-draining pump/motor with Dry Run
seal
• Six multi-direction jets
• One air volume control
• Anti-vortex suction fitting
• Deck mounted air switch On/Off control
• U.L.® Listed entire whirlpool system
❏2740.102 Bath only, Right Hand Outlet
❏2740.202 Bath only, Left Hand Outlet
• Same as above without whirlpool system
Nominal Dimensions:
(59-7/8” x 29-7/8” x 19-1/4")
1521 x 759 x 489mm
© 1999 American Standard Inc. BV-018B
12/99
SPS 2740
To Be Specified - :
❏Color:
❏Bath/Shower Faucet*:
❏Faucet Finish:
❏Bath Drain: 1553.270
❏002 Chrome ❏099 Polished Brass
* See faucet section for models available
NOTE: Roughing-in dimensions and product specifica-
tions shown on reverse side of page.
Compliance Certifications -
Meets or Exceeds the Following Specifications:
• Underwriters Laboratories - Hydromassage
Bathtubs UL 1795
• ASME A112.19.7M for Whirlpool Appliances
• ANSI Z124.1 for Plastic Bathtubs
• ASTM E162 for Flammability
• NFPA 258 for Smoke Density

COLONY™ 5’ X 30” w/INTEGRAL APRON
WHIRLPOOL AND BATHING POOL
HIGH GLOSS ACRYLIC
© 1999 American Standard Inc.
NOTES:
BATH TO BE INSTALLED ABOVE FLOOR LINE AS A RECESS INSTALLATION.
■ REFER TO INSTALLATION INSTRUCTIONS SUPPLIED WITH WHIRLPOOL FOR ADDITIONAL INFORMATION.
BATH TO BE INSTALLED ABOVE FLOOR LINE AS A RECESS INSTALLATION.
LEFT HAND OUTLET SHOWN, RIGHT HAND REVERSE DIMENSIONS (2740.118).
FITTINGS NOT INCLUDED AND MUST BE ORDERED SEPARATELY.
PROVIDE SUITABLE REINFORCEMENT FOR ALL SUPPORTS.
IMPORTANT: Dimensions of fixtures are nominal and may vary within the range of tolerances established by
ANSI Standards Z124.1 and A112.19.7. These measurements are subject to change or cancellation. No
responsibility is assumed for use of superseded or voided pages.
19
(483mm)
7/8 WATER
RETENTION
FLANGE
(3 SIDES)
19-1/4
(489mm)
BATH SUPPORT
MATERIAL
■ LEVELING STRINGER
NOT FOR SUPPORT
ROUGH
FLOOR
FINISHED
WALL
TOP OF
DECK
59-7/8
(1521mm)
29-7/8
(759mm)
WATER
RETENTION
FLANGE
(3 SIDES)
6-1/4
(159mm)
C/L OF DRAIN
1-1/2 (38mm) (6) JETS
3
(76mm)
3-3/4
(95mm)
PUMP
FINISHED
WALL
12
(305mm)
OPT.
OPTIONAL TO
FINISHED FLOOR
USUALLY BETWEEN
65 & 78
(1651 & 1981mm) C/L OF
OVERFLOW 4
(102mm)
C/L OF
SPOUT
C/L OF
VALVES
C/L OF
SHOWER ARM
2-1/2
(64mm)
3/4
(19mm)
C/L OF
SUPPLIES
HORIZONTAL TAILPIECE
ABOVE FLOOR OUTLET
1-1/2 O.D.
TAILPIECE
SEE FITTING
SPECS FOR
DIMENSIONS
(1) AIR VALVE
ON/OFF
SWITCH
ACCESS TO PUMP/MOTOR
THROUGH REMOVABLE
FRONT ACCESS PANEL
UNDERSIDE
OF DECK
14-1/8
(359mm)
BATH SUPPORT
MATERIAL
19
(483mm)
7/8 WATER
RETENTION
FLANGE
(3 SIDES)
19-1/4
(489mm)
■ LEVELING STRINGER
NOT FOR SUPPORT
ROUGH
FLOOR
FINISHED
WALL
TOP OF
DECK
59-7/8
(1521mm)
29-7/8
(759mm)
WATER
RETENTION
FLANGE
(3 SIDES)
6-1/4
(159mm)
C/L OF DRAIN
1-1/2 (38mm)
3
(76mm)
3-3/4
(95mm)
FINISHED
WALL
12
(305mm)
OPT.
OPTIONAL TO
FINISHED FLOOR
USUALLY BETWEEN
65 & 78
(1651 & 1981mm) C/L OF
OVERFLOW 4
(102mm)
C/L OF
SPOUT
C/L OF
VALVES
C/L OF
SHOWER ARM
2-1/2
(64mm)
3/4
(19mm)
C/L OF
SUPPLIES
HORIZONTAL TAILPIECE
ABOVE FLOOR OUTLET
1-1/2 O.D.
TAILPIECE
SEE FITTING
SPECS FOR
DIMENSIONS
UNDERSIDE
OF DECK
14-1/8
(359mm)
GENERAL SPECIFICATIONS FOR 2740 WHIRLPOOL
WHIRLPOOL ELECTRICAL SPECIFICATIONS
SYSTEM I PUMP 1 HP, 9.9 AMPS,120V.
59-7/8 x 29-7/8 x 19-1/4 (1521 x 759 x 489mm)
105 Lbs. (47 Kgs.)
480 Lbs. (216 Kgs.)
45 Gal. (171 L)
38 Gal. (144 L)
20 x 46 (508 x 1168mm )
25-1/2 x 55-1/2(648 x 1410mm )
11-1/2 (292mm)
39 Lbs./Sq.Ft. (188 Kgs./Sq.m)
16.7
33.0
INSTALLED SIZE
WEIGHT
WEIGHT w/WATER
GAL. TO OVERFLOW
WHIRLPOOL MIN. OPERATING VOL.
BATHING WELL AT SUMP
BATHING WELL AT RIM
WATER DEPTH TO OVERFLOW
FLOOR LOADING
(PROJECTED AREA)
PTS.
CUBE (FT3)
GENERAL SPECIFICATIONS FOR 2740 BATHING POOL
59-7/8 x 30 x 19-1/4 (1521 x 762 x 489mm)
70 Lbs. (32 Kgs.)
462 Lbs. (208 Kgs.)
47 Gal. (178 L)
20 x 46 (508 x 1168mm )
25-1/2 x 55-1/2(648 x 1410mm )
11-1/2 (292mm)
37 Lbs./Sq.Ft. (179 Kgs./Sq.m)
16.7
33.0
INSTALLED SIZE
WEIGHT
WEIGHT w/WATER
GAL. TO OVERFLOW
BATHING WELL AT SUMP
BATHING WELL AT RIM
WATER DEPTH TO OVERFLOW
FLOOR LOADING
(PROJECTED AREA)
PTS.
CUBE (FT3)