American Standard Cambridge 2460.002 User manual

H109
© 2008 AS America Inc.
CAMBRIDGE™ 5'
WHIRLPOOL AND BATHING POOL
AMERICAST® BRAND ENGINEERED MATERIAL
To Be Specied - Required:
❏ Color:
❏ Bath Filler: (specify nish)
❏ Bath Drain: 1583.470 (specify nish)
To Be Specied - Optional:
❏ Safe-T-Heater*: 9075.120
❏ Jet Trim Ring Kit: 9860.200-one per kit (specify color)
for Body Massage Jets only
❏ Universal Tile Bead Kit: 751755-100
MEETS THE AMERICANS WITH DISABILITIES ACT GUIDELINES
AND ANSI A117.1 REQUIREMENTS FOR ACCESSIBLE AND
USEABLE BUILDING FACILITIES-CHECK LOCAL CODES.
INSTALL WITH SEAT AT HEAD END.
Bathing Pool:
❏ 2461.002 Bathing Pool Right Hand Drain Outlet
❏ 2460.002 Bathing Pool Left Hand Drain Outlet
Bathing Pool with Grab Bar Drilling:
❏ 2461.102 Bathing Pool Right Hand Drain Outlet
❏ 2460.102 Bathing Pool Left Hand Drain Outlet
Nominal Dimensions:
1524 x 813 x 451mm (60" x 32" x 17-3/4")
Bathing Well Dimensions:
1372 x 660 x 432mm (54" x 26" x 17")
Revised 2/08
Americast® brand engineered material is a composition of porcelain bonded to
enameling grade metal, bonded to a patented structural composite.
BARRIER FREE
CAMBRIDGE™ 5’ WHIRLPOOL AND
BATHING POOL
❏ 2461.028W Whirlpool Featuring System I
Right Hand Drain Outlet
❏ 2460.028W Whirlpool Featuring System I
Left Hand Drain Outlet
• Americast® brand engineered material
• Acid-resistant porcelain nish
• Integral apron with integral 3-sided tile/water
retention ange
• Integral lumbar support with beveled headrest
• Full slip-resistant coverage
• 1.6 HP single speed, self-draining pump/motor
• Factory installed power cord and plug
• Six multi-directional and ow-adjustable jets
• Deck-mounted air switch On/Off
• Two silent air volume controls
• Quick Connect Safe-T-Heater
connection system
• Factory installed and tested whirlpool system
Whirlpool featuring System I
❏ 2461.128W Whirlpool Featuring System I
Right Hand Drain Outlet with Grab Bar Drilling
❏ 2460.128W Whirlpool Featuring System I
Left Hand Drain Outlet with Grab Bar Drilling
• Same as above except with grab bar drilling
(grab bar must be ordered separately)
EverClean® Whirlpool featuring System I
❏ 2461.028WC Whirlpool Featuring System I
Right Hand Drain Outlet
❏ 2460.028WC Whirlpool Featuring System I
Left Hand Drain Outlet
• Same as 2460/2461.028W except with the
EverClean® System
EverClean Whirlpool featuring
System I and Grab Bar Drilling
❏ 2461.128WC Whirlpool Featuring System I
Right Hand Drain Outlet with Grab Bar Drilling
❏ 2460.128WC Whirlpool Featuring System I
Left Hand Drain Outlet with Grab Bar Drilling
• Same as 2460/2461.028W except with the
EverClean whirlpool system and grab bar
drilling (grab bar must be ordered separately)
Compliance Certications -
Meets or Exceeds the Following Specications:
• Underwriters Laboratories - Hydromassage
Bathtubs UL 1795
• ASME A112.19.7M for Whirlpool Appliances
• ASME A112.19.4M for Americast Fixtures
• ASTM F-462 for Slip-resistant Bathing Facilities
• ASTM E162 for Flammability
• NFPA 258 for Smoke Density
For color/nish availability and other faucet choices, please
see the Product Selector and Pricing Guide.
* NOTE: the Safe-T-Heater is designed to maintain water
temperature during operation. It will not heat cold water to
desired bathing temperature.
SEE REVERSE FOR PRODUCT DIMENSIONS
AND SPECIFICATIONS

H110
© 2008 AS America Inc.
BARRIER FREE
CAMBRIDGE™ 5'
WHIRLPOOL AND BATHING POOL
AMERICAST® BRAND ENGINEERED MATERIAL
NOTES:
■ REFER TO INSTALLATION INSTRUCTIONS SUPPLIED
WITH WHIRLPOOL FOR ADDITIONAL INFORMATION.
SHOWN WITH 8620. SERIES AMARILIS BATH/SHOWER
FITTING AND POP-UP C.D. & O.
LEFT HAND OUTLET SHOWN, RIGHT HAND REVERSE
DIMENSIONS (2461).
CONCEALED PIPING NOT FURNISHED.
FITTINGS NOT INCLUDED AND MUST BE
ORDERED SEPARATELY.
PROVIDE SUITABLE REINFORCEMENT FOR ALL
WALL SUPPORTS.
1-1/2 N.P.T. THREADS
1-1/2 O.D. TAILPIECE
441mm
(17-3/8)
70mm
(2-3/4)
117mm
(4-5/8)
ROUGH
FLOOR
102mm
(4)
451mm
(17-3/4)
24mm
(15/16)
406mm
(16)
OPTIONAL
TO FLOOR
USUALLY
BETWEEN
1651 & 1981mm
(65 & 78)
711mm
(28)
C/L OF CURTAIN ROD
USUALLY 1930mm(76) FROM
FINISHED FLOOR
C/L OF
VALVES
102mm
(4)
102mm
(4)
SPOUT-
1/2 N.P.T.
FINISHED
WALL
SHOWER ARM- 1/2 N.P.T.
32mm(1-1/4) DIA. HOLE
SEE
NOTE
76mm
(3)
813mm
(32)
1524mm
(60)
19mm
(3/4)
70mm
(2-3/4)
203mm
(8) FINISHED
WALL
102mm
(4)
102mm
(4)
C/L OF 1/2
SUPPLIES
AS REQ'D
C/L OF
DRAIN
229mm x 305mm
(9 x 12)
FLOOR
CUTOUT
PUMP
406mm
(16)
PROVIDE ACCESS TO PUMP FOR SERVICING ON ALL INSTALLATIONS
ON / OFF
SWITCH
64mm
(2-1/2)
25mm
(1)
(2) 54mm(2-1/8)
DIA. HOLES
60mm 13mm
+
(2-3/8) (1/2)
+
SAFE-T-HEATER
REMOVABLE BLANK
GENERAL SPECIFICATIONS FOR 2460/2461 WHIRLPOOL
WHIRLPOOL ELECTRICAL SPECIFICATIONS
SYSTEM I PUMP 1.6 HP, 9.7 AMPS,120V.
60 x 32 x 17-3/4 In. (1524 x 813 x 451mm)
190 Lbs. (86 Kg.)
607 Lbs. (273 Kg.)
50 Gal. (190 L)
39 Gal. (148 L)
41 x 20 In. (1041 x 508mm)
54 x 26 In. (1372 x 660mm)
14 In. (356mm)
46 Lbs./Sq.Ft. (220 Kgs./Sq.m)
13.9
30.9
INSTALLED SIZE
WEIGHT
WEIGHT w/WATER
GAL. TO OVERFLOW
WHIRLPOOL MIN. OPERATING VOL.
BATHING WELL AT SUMP
BATHING WELL AT RIM
WATER DEPTH TO OVERFLOW
FLOOR LOADING
(PROJECTED AREA)
PTS.
CUBE (FT3)
C/L OF 1/2
SUPPLIES
AS REQ'D
(2) 54mm(2-1/8)
DIA. HOLES
60mm 13mm
+
(2-3/8) (1/2)
+
1-1/2 N.P.T. THREADS
1-1/2 O.D. TAILPIECE
441mm
(17-3/8)
70mm
(2-3/4)
117mm
(4-5/8)
ROUGH
FLOOR
102mm
(4)
451mm
(17-3/4)
24mm
(15/16)
406mm
(16)
OPTIONAL
TO FLOOR
USUALLY
BETWEEN
1651 & 1981mm
(65 & 78)
711mm
(28)
C/L OF CURTAIN ROD
USUALLY 1930mm(76) FROM
FINISHED FLOOR
C/L OF
VALVES
102mm
(4)
102mm
(4)
SPOUT-
1/2 N.P.T.
FINISHED
WALL
SHOWER ARM- 1/2 N.P.T.
32mm(1-1/4) DIA. HOLE
SEE
NOTE
76mm
(3)
813mm
(32)
1524mm
(60)
19mm
(3/4)
70mm
(2-3/4)
203mm
(8) FINISHED
WALL
102mm
(4)
102mm
(4)
C/L OF
DRAIN
229mm x 305mm
(9 x 12)
FLOOR
CUTOUT
406mm
(16)
64mm
(2-1/2)
25mm
(1)
GENERAL SPECIFICATIONS FOR 2460/2461 BATHING POOL
60 x 32 x 17-3/4 In. (1524 x 813 x 451mm)
161 Lbs. (72 Kg.)
578 Lbs. (260 Kg.)
50 Gal. (190 L)
41 x 20 In. (1041 x 508mm)
54 x 26 In. (1372 x 660mm)
14 In. (356mm)
43 Lbs./Sq.Ft. (208 Kgs./Sq.m)
13.9
30.9
INSTALLED SIZE
WEIGHT
WEIGHT w/WATER
GAL. TO OVERFLOW
BATHING WELL AT SUMP
BATHING WELL AT RIM
WATER DEPTH TO OVERFLOW
FLOOR LOADING
(PROJECTED AREA)
PTS.
CUBE (FT3)
IMPORTANT: Dimensions of xtures are nominal and may vary within the
range of tolerances established by ANSI Standard A112.19.4
These measurements are subject to change or cancellation.
No responsibility is assumed for use of superseded or voided leaet.
Revised 2/08
American Standard whirlpools and air baths with
EverClean® incorporate a patented silver-ion
additive right into the circulation piping to protect
the pipes from mold, mildew, algae and fungus that
could cause deterioration or staining of the pipes.