American Standard Hampton Integral Apron Whirlpool 2425.118W User manual

HAMPTON™5’INTEGRAL APRON
WHIRLPOOL
HIGH GLOSS ACRYLIC
HAMPTON™5’INTEGRAL APRON WHIRLPOOL
❏2425.218W Whirlpool featuring System I
Left Hand Drain Outlet
❏2425.118W Whirlpool featuring System I
Right Hand Drain Outlet
•Acrylic with fiberglass reinforcement
•Integral apron with removable access panel
•Integral three-sided, tiling / water retention
flange
•Form-fitted backrest
•1.5 HP single speed, self-draining pump/motor
with dry run seal
•Factory-installed power cord with plug
•Eight multi-directional and flow-adjustable jets
including:
- Two Ideal-flow jets
- Four body massage jets
- Two recessed back-rest jets
•Deck-mounted air switch On/Off
•Two silent air volume controls
•Quick Connect Safe-T-Heater connection
system
•Factory installed and tested whirlpool system
StayClean™Whirlpool Massage featuring System I
❏2425.218WC Whirlpool featuring System I
Left Hand Drain Outlet
❏2425.118WC Whirlpool featuring System I
Right Hand Drain Outlet
•Same as above except with the StayClean™
whirlpool system featuring Antimicrobial
AlphaSan®
Nominal Dimensions:
60”x 32”x 21-1/2”(1524 x 813 x 546mm)
© 2003 American Standard Inc. BV-19
3/03
Compliance Certifications -
Meets or Exceeds the Following Specifications:
•Underwriters Laboratories - Hydromassage
Bathtubs UL 1795
•ASME A112.19.7M for Whirlpool Appliances
•ANSI Z124.1 for Plastic Bathtubs
•ASTM E162 for Flammability
•NFPA 258 for Smoke Density
NOTE: Roughing-in dimensions and product
specifications shown on reverse side of page.
To Be Specified - Required:
❏Color:
❏Bath Faucet: (specify finish)
❏Bath Drain: 1583.470 (specify finish)
To Be Specified - Optional:
❏Safe-T-Heater*: 9075.120
❏Bath Caddie: 9533.100 (in Chrome only)
❏Jet Trim Ring Kit: 9860.200-two per kit (specify finish)
For color/finish availability and other faucet choices,
please see the Product Selector and Pricing Guide.
* NOTE: the Safe-T-Heater is designed to maintain water
temperature during operation. It will not heat cold water to
desired bathing temperature.

HAMPTON™5’INTEGRAL APRON
WHIRLPOOL
HIGH GLOSS ACRYLIC
© 2003 American Standard Inc.
NOTES:
BATH CAN BE INSTALLED EITHER ABOVE OR BELOW FLOOR LINE AS PIER, ISLAND, OR PENINSULA TYPE
INSTALLATION. SUPPORT OF BATH BY SUMP BEDDING. SUPPORT AND ENCLOSING MATERIAL BY OTHERS.
REFER TO INSTALLATION INSTRUCTIONS SUPPLIED WITH WHIRLPOOL FOR ADDITIONAL INFORMATION.
FITTINGS NOT INCLUDED AND MUST BE ORDERED SEPARATELY.
PROVIDE SUITABLE REINFORCEMENT FOR ALL SUPPORTS.
IMPORTANT:
Dimensions of fixtures are nominal and may vary within the range of tolerances established by ANSI Standard Z124.1
These measurements are subject to change or cancellation. No responsibility is assumed for use of superseded or
voided leaflet.
21-1/4
(540mm)
REF.
DIM
1" WATER
RETENTION
FLANGE
(3 SIDES)
21-1/2
(546mm)
1-1/2 O.D.TAILPIECE
BATH
SUPPORT
MATERIAL
LEVELING STRINGER
NOT FOR SUPPORT
ROUGH
FLOOR
FINISHED
WALL
TOP OF
DECK
60
(1524mm)
32
(813mm)
WATER
RETENTION
FLANGE
(3 SIDES)
10-1/4
(260mm)
12
(305mm)
3
(76mm)
(8) JETS
3-1/2
(89mm)
CUTOUT IN FLOOR FOR DRAIN
PUMP
FINISHED
WALL
12
(305mm)
OPT.
OPTIONAL TO
FINISHED FLOOR
USUALLY BETWEEN
65 & 78
(1651 & 1981mm)
C/L OF
OVERFLOW 4
(102 mm)
C/L OF
SPOUT
TILING
FLANGE
C/L OF
VALVES
C/L OF
SHOWER ARM
2-3/4
(70mm) 4-5/8
(117mm)
1-1/2 N.P.T.M.
THREADS
3/4
(19mm)
9
(229 mm)
C/L OF
SUPPLIES
C/L OF DRAIN
SEE FITTING
SPECS FOR
DIMENSIONS
(2) AIR VALVES
ON/OFF
SWITCH
ACCESS TO PUMP/MOTOR
THROUGH REMOVABLE
FRONT ACCESS PANEL
UNDERSIDE
OF DECK
16
(406mm)
SAFE-T-HEATER
REMOVABLE
BLANK
60 X 32 X 21-1/2In.(1524 X 813 X 546mm)
115 Lbs. (52 Kg.)
574 Lbs. (258 Kg.)
55 Gal. (208 L.)
45 Gal. (171 L.)
16-1/4 X 38-1/4 In. (413 X 972mm)
26-1/4 X 52-1/2 In. (667 X 1334mm)
15 In. (381mm)
43 Lbs./Sq. Ft. (208 Kgs/Sq. m.)
15.6
35.3
GENERAL SPECIFICATIONS FOR 2425 WHIRLPOOL
INSTALLED SIZE
WEIGHT
WEIGHT w/WATER
GAL. TO OVERFLOW
MIN. OPERATING GAL.
BATHING WELL AT SUMP
BATHING WELL AT RIM
WATER DEPTH TO OVERFLOW
FLOOR LOADING
(PROJECTED AREA)
PTS.
CUBE (FT3)
WHIRLPOOL ELECTRICAL SPECIFICATIONS
1.6 HP, 9.7 AMPS, 120V.SYSTEM I PUMP