American Standard QL027 User manual

Model No. QL027
Owner’s Manual
for selecting American Standard… the benchmark of fine quality for over 100 years.
To ensure that your installation proceeds smoothly, please read these instructions carefully
before you begin.
Stainless steel
utility sink
With faucet and storage cabinet
THANK YOU

2
Table of Contents
Table of Contents ............................2
Safety Information............................2
Warranty ..................................3
One Year Limited Warranty...........................3
Warranty Claim Procedure ...........................3
Pre-Installation..............................4
Tools/Materials Required ............................4
Package Contents .................................5
Installation.................................6
Leveling Leg Installation ............................6
Door Handle Installation.............................6
Faucet Installation .................................7
Strainer Installation ................................7
Mounting the Utility Sink ............................8
Placement .......................................8
Supply Line Assembly ..............................8
Maintenance ...............................8
Cartridge Replacement .............................8
Care and Cleaning............................9
Utility Sink .......................................9
Cabinet..........................................9
Service Parts .............................. 10
Safety Information
READ AND SAVE THESE INSTRUCTIONS
1. Inspect your unit before proceeding. Once you unpack your unit,
check for chips, scratches, cracks, dents or scuff marks. If any
damage is noticed, do not install.
2. Use this unit only in the manner intended by the manufacturer. If
you have any questions, contact the manufacturer.
3. Installation work and plumbing must be done by qualied
person(s) in accordance with all applicable codes and standards.
4. Protect the entire surface during installation.
5. All holes drilled into the unit must be done from the nished
surface side with extreme care and caulked very carefully to
form a watertight barrier.
DANGER: Always wear safety goggles and gloves in order
to avoid personal injury.

3 CONGLOMKB.COM
Please contact [e-mail] or 1-855-629-3992 for further assistance.
Warranty
ONE YEAR LIMITED WARRANTY
A thorough inspection must be made before installation and any damage must be promptly reported. We will not be liable for failures or
damage that could have been discovered or avoided by proper inspection and testing prior to installation.
Conglom Kitchen & Bath warrants this product to be free from defects in materials or workmanship for one (1) year from the date of purchase.
Proof of purchase (original sales receipt) from the original consumer purchaser must be made available to Conglom Kitchen & Bath for all
warranty claims.
This warranty is non-transferable and shall be voided if the unit is removed from its initial installation or if it is not installed following the
manufacturer’s instructions. It does not apply in the event of product damage due to the use of other than genuine Conglom Kitchen &
Bath replacement parts, (Replacement parts may be obtained by e-mail at [e-mail] or by calling 1-855-629-3992
between 8:30 am - 5:00 pm EST) installation error, abuse, misuse or improper care and maintenance (whether performed by a plumber,
contractor, service provider or member of the purchaser’s household). The warranty excludes damage due to aggressive air or water
conditions, harsh or abrasive cleaners and/or materials.
Under no circumstance shall we be held liable for personal injury or property damage resulting from improper installation or use of this
product. We will not be held liable for inconvenience caused by loss of use of this product, costs incurred for labour or materials, removal
and installation of replacement units, or any other incidental or consequential damages. Costs relating to obtaining access for repair or
replacement are the responsibility of the user.
Our obligation shall be limited to the repair or replacement of a unit (at our discretion) that may prove, by our sole examination, to be defective
under normal use and service during the warranty period.
Any failure of this product that is not traceable to a defect in material or workmanship is not covered by this warranty. These non-warrantable
items include, but are not limited to:
- Improper installation not in accordance with manufacturer’s instructions.
- Dents and/or scratches incurred during shipping, handling, or installation.
- Change in colour or nish due to chemical usage.
- Damage caused by failure to follow care and cleaning guidelines, including damage caused by the use of abrasive cleaners.
- Alterations made to the unit by the purchaser or installer.
- Damage caused by accidental impact, re, ood, freezing, and normal wear.
- Bends and warping caused by forced connections, over-tightened ttings, and inadequate support during installation.
- This warranty does not extend to commercial and institutional installation or use.
WARRANTY CLAIM PROCEDURE
If a claimable defect occurs or replacement parts are needed, please contact our customer service team at [e-mail]
or 1-855-629-3992 (8:30 am - 5 pm, EST, Monday - Friday).
Before you make your call, please ensure that you have:
- Model number or description.
- Proof of sale.
- Details regarding the defect and/or part number.
- Name(s) and address(es) of the owner and/or installer.

4
Pre-Installation
TOOLS/MATERIALS REQUIRED (NOT SUPPLIED)
Adjustable
wrench
Needle nose
pliers
Phillips
screwdriver
Utility knife Pipe wrench Sealant
Carpenter’s level Hacksaw Safety gloves
Safety goggles
PARTS REQUIRED (NOT SUPPLIED)
Tail Pipe Supply Line

5 CONGLOMKB.COM
Please contact [e-mail] or 1-855-629-3992 for further assistance.
Pre-Installation (continued)
PACKAGE CONTENTS
AA
AB
D
E
CF G
H
BB
Part Description Quantity
A Cabinet 1
B Utility Sink 4
CFaucet Assembly 1
D Strainer Basket 1
EStrainer Assembly 1
F Door Handles 2
G Leveling Legs 4
H Allen Key 1
AA Door Handle Screws 4
BB Leveling Leg Screws 16

6
Installation
LEVELING LEG INSTALLATION DOOR POSITION ADJUSTMENT
If the doors need to be repositioned, the hinges can be
adjusted to ensure a precise t with the cabinet.
1. The lateral adjustment screw adjusts the door left
or right.
1
2. The horizontal adjustment screw adjusts the door
forward or backward.
2
3. The vertical adjustment screw adjusts the door up
or down.
3
A thorough inspection must be made before installation and any
damages or missing parts must be promptly reported. Do not proceed
with the installation. Do not dispose of packaging before you are
satised with your new utility sink.
1. Unpack the unit and place the sink (B) on a blanket or cardboard
to protect the surface.
2. Turn the cabinet (A) upside down onto the protective surface.
3. Gently put each leveling leg (G) onto its proper location. Using
four leveling leg screws (BB) per leveling leg, attach the leveling
legs (G) to the bottom of the cabinet (A).
4. Gently place the cabinet upright.
CAUTION: Do not place side load on the leveling legs
when righting the cabinet, as they may break.
A
G
BB
DOOR HANDLE INSTALLATION
1. Insert two door handle screws (AA) into the pre-drilled holes on
the door.
2. Attach a door handle (F) and tighten the door handle screws (AA).
3. Repeat on the other door.

7 CONGLOMKB.COM
Please contact [e-mail] or 1-855-629-3992 for further assistance.
Installation (continued)
FAUCET INSTALLATION
Sprayer head
Gooseneck pipe
Faucet body
Faucet handle
Gasket Washer
Threaded section
Retaining ring
Screws
1. Carefully remove all the parts of the faucet assembly (C).
The faucet is pre-assembled, except for the sprayer head.
2. Take the washer, gasket and retaining ring off of the faucet
body.
3. Place the faucet body carefully through the hole in the sink
(B). A second person may be required to hold the body in
place until the faucet installation is complete.
4. From underneath, slide the washer, gasket and retaining
ring over the end of the copper pipe and up to the exposed
threaded section of the faucet. Tighten the retaining ring by
hand until it is snug. Using a wrench or pliers, tighten the
assembly.
5. Gently tighten the two screws on the retaining ring. Do not
over tighten.
6. Screw the sprayer head onto the gooseneck pipe.
7. Connect the water supply lines (not supplied) to the faucet.
STRAINER INSTALLATION
1. Apply a ring of sealant to the underside of the strainer
ange.
2. Insert the strainer body into the sink.
3. Assemble the rubber gasket, friction washer and locknut
onto the strainer body from under the sink.
4. Hand tighten the locknut. Do not over tighten locknut as it
may split or deform the body of the strainer.
Basket
Strainer body
Rubber gasket
Friction washer
Locknut
Sealant

8
Installation (continued)
MOUNTING THE UTILITY SINK
B
A
Sealant
1. Carefully place a bead of sealant all around the top of the cabinet.
2. Ease the sink onto the cabinet, and ensure it is placed evenly and
centered on the cabinet. Wipe off any excess sealant. Use masking
tape to hold the unit in place until the sealant dries.
PLACEMENT
Move the assembled unit to its nal location.
If required, level the unit by adjusting the four leveling legs. Ensure that
no rocking is exhibited.
SUPPLY LINES (NOT INCLUDED)
The supply lines that attach the faucet to the household
water system, are not supplied with this unit. They need to be
purchased separately.
Follow the manufacturers instructions for proper installation of
the supply lines.
Maintenance
CARTRIDGE REPLACEMENT
Handle
body
Water temperature sign
Screw
Cap
Rings
Cartridge
Faucet body
To replace the cartridge, please follow these steps:
1. Turn off the water supply to the faucet.
2. Take off the plastic water temperature sign by hand, then use the
Allen key to take out the screw and pull out the handle body. The top
lever of the cartridge will be exposed.
3. Unscrew the cap and rings, making sure not to damage the threads.
4. Pull out the cartridge and replace it with a new 35 mm (1.4 in.)
ceramic cartridge.
5. Replace the rings and the cap.
6. Place the handle body on the cartridge. Lock the screw back onto the
handle body and tighten it with the Allen key. Do not over tighten.
7. Put the plastic water temperature sign back into the hole, make sure
that the red is on the left and blue is on the right.
8. Slowly open the water feed to the faucet to test.

9 CONGLOMKB.COM
Please contact [e-mail] or 1-855-629-3992 for further assistance.
Care and Cleaning
UTILITY SINK
Your sink is manufactured with the highest grade stainless steel and will provide you many years of enjoyment with the proper care.
Do Do not
- After use, always rinse your sink with tap
water to dilute and remove deposits.
- Towel dry after use whenever possible to
prevent water spots. Should water spots occur,
clean with a mild solution of vinegar and water
followed by a thorough rinse.
- Use liquid soap, a general household cleaner,
or a weak solution of vinegar and water for
regular cleaning.
- Only use plastic scouring pads recommended
for use in stainless steel sinks, and only use
them in the bowl of the sink. Scrub in the
direction of the satin nish lines.
- Do not allow any food, detergent, soap or
grease to dry or sit for extended periods of
time on the surface of the sink.
- Never use abrasive cleaning products, as they
will dull and scratch the nish.
- Do not use scouting pads on the deck, as they
will dull the mirror nish.
- Never use steel wool pads, as they will leave
iron particles on the sink, which will cause
corrosion.
- Never leave steel or cast iron pans in your sink
for extended periods of time, as this can cause
corrosion.
CABINET
To maintain the surface of your cabinet, follow these tips.
Do Do not
- Remove dust and dry dirt with a soft, damp
cloth.
- Clean grease, oil, paint and ink stains with
isopropyl (rubbing alcohol). Immediately rinse
with water after stain removal.
- Do not allow your cabinet surface to come
into contact with products such as acetone
(nail polish remover), nail polish, dry cleaning
solution, lacquer thinners, gasoline, pine oil,
etc.
- Use caution when using sharp instruments
that may fall and scratch the surface.

10
Service Parts
If you are missing parts or if you require replacement parts, please contact our customer service team at [e-mail] or
1-855-629-3992, 8:30 am – 5 pm, EST, Monday–Friday. Identify the required part(s) and have the part number(s) ready.
GE F
AA BB
AB
C
D
Part Description Code Quantity
A Door Handles QHL100 2
B Leveling Legs QHL114 4
C Strainer Basket QHS101 1
DStrainer Assembly QHS150 1
E Ceramic Cartridge QHS121 1
F Sprayer Head QHS135 1
G Cabinet Hinges QHL102 4
AA Door Handle Screws QHL104 4
BB Base Screws QHL106 16

Questions, problems, missing parts?
Before returning to the store, please contact Customer Service
at [e-mail] or 1-855-629-3992
from 8:30 am - 5 pm, EST, Monday - Friday
CONGLOMKB.COM
Retain this manual for future use.
Made in China