American Standard Affinity Countertop Sink 3420.001 User manual

J56
© 2008 AS America Inc.
AFFINITY™
COUNTERTOP SINK
AMERICAST® BRAND ENGINEERED MATERIAL
AFFINITY™ COUNTERTOP SINK
Americast® Brand Engineered Material
• Acid-resistant porcelain nish
• Large bowl area
• Self-rimming with cutout template supplied
• Chrome overow trim ring
• Shown with 8871.802 Lexington spread faucet
with Fabian handles (not included)
❏ 3420.001 Center hole only
❏ 3420.403 Faucet holes on 4" (102mm) centers
❏ 3420.803 Faucet holes on 8" (203mm) centers
(illustrated)
Nominal Dimensions:
527 x 445mm
(20-3/4" x 17-1/2")
Bowl sizes:
483mm (19") wide
292mm (11-1/2") front to back
178mm (7") deep
Americast® Brand engineered material is a
composition of porcelain bonded to enameling grade
metal, bonded to a patented structural composite.
Compliance Certications -
Meets or Exceeds the Following Specications:
• ASME A112.19.4M for Americast Plumbing Fixtures
• ASTM E162 for Flammability
• NFPA 258 for Smoke Density
To Be Specied:
❏ Color: ❏ White ❏ Bone ❏ Linen
❏ Silver ❏ Fawn Beige ❏ Black
❏ Faucet*:
❏ Faucet Finish:
❏ Optional Trim Ring for Overow:
790730-101 Polished Brass
❏ Supplies:
❏ Trap:
* See faucet section for additional models available
NOTES:
* DIMENSIONS SHOWN FOR LOCATION OF SUPPLIES AND “P" TRAP ARE
SUGGESTED.
FOR COUNTERTOP CUTOUT AND INSTALLATION INSTRUCTIONS USE
TEMPLATE SUPPLIED WITH SINK.
FITTINGS NOT INCLUDED WITH FIXTURE AND MUST BE ORDERED
SEPARATELY.
SEALING COMPOUND SUPPLIED BY OTHERS.
IMPORTANT: Dimensions of xtures are nominal and may vary within the range of
tolerances established by ANSI Standard A112.19.4.
These measurements are subject to change or cancellation. No responsibility is
assumed for use of superseded or voided leaet.
10mm
(3/8)
FINISHED WALL
OR SPLASHBACK
OPTIONAL
197mm
(7-3/4)
70mm
(2-3/4)
445mm
(17-1/2)
527mm
(20-3/4)
203mm
(8)
210mm
(8-1/4)
*356mm
(14) 203mm
(8)
1-1/4 O.D. WASTE
SUPPLIES
AS REQ'D
*276mm
(10-7/8)
COUNTERTOP
(BY OTHERS)
787mm
(31) TO
FINISHED
FLOOR
FINISHED FLOOR
178mm
(7) 1-1/4 O.D. TAILPIECE
SEALING
COMPOUND
Revised 2/08