American Standard PEKOE 4332.350 User manual

Installation
Instructions
Certified to comply with ANSI A112.18.1M
4332.350
4332.350F15
4332.358 Series
PEKOE®
CAUTION
1INSTALL FITTING
Turn off hot and cold water
supplies before beginning.
Plumbers' Putty or Caulking
Adjustable Wrench
Phillips Screwdriver
Channel Locks
Recommended Tools
Make certain the SEAL (1) is properly seated in recess
of faucet body.
Insert supply HOSES (2) and SHANK (3) through center
hole of sink or mounting surface.
Assemble RUBBER WASHER (4), PLASTIC WASHER (5),
METAL WASHER (6) and threaded LOCKNUT (7) onto
SHANK (3) from underside of sink or mounting surface.
Hand tighten LOCKNUT (7) and check that faucet is centered.
Use a screwdriver to tighten SCREWS (8) on LOCKNUT (7).
Work your way around LOCKNUT (7), tightening the screws
slightly each time until all are snug to ensure even pressure.
Tubing Cutter
1
2
5
RECESS
Thank you for selecting American-Standard...the benchmark
of fine quality for over 100 years.
To ensure that your installation proceeds smoothly--please
read these instructions carefully before you begin.
4
3
6
7
8
Single Lever Semi-Professional
Kitchen Faucet
M968577 Rev.1.7

RED
STRIPE
BLUE
STRIPE
2MAKE WATER SUPPLY CONNECTIONS
Turn off hot and cold water supplies before beginning.
Connect FLEXIBLE SUPPLIES (1, 2) directly to wall supplies. Connection
on fitting supplies are 3/8" compression. Connect left supply
(Marked with a Red Stripe) to Hot and right supply (Marked with
Blue Stripe) to Cold wall supply. Use adjustable wrench to
tighten connections. Do not over tighten.
Faucet supplies are 27-1/2" long from faucet base.
Note: If additional supply length
is required, installer must
purchase additional parts
separately.
Important: If SUPPLY HOSES
(1, 2) are too long, loop as
illustrated to avoid kinking.
1
2
COLD
HOT
3
3TEST INSTALLED FAUCET
1
2
3
HOT & COLD SUPPLIES
Unthread SPRAY END (2) from HOSE END (3).
Turn on water supplies and check connections for leaks.
Operate HANDLE (1) on and off, hot and cold to flush water
lines thoroughly. Replace SPRAY END (2).
Check all drain connections for leaks.
Move HANDLE (1) to "off" position.
Move HANDLE (1) into "off" position.
M968577 Rev.1.7

3
1
1
4
SERVICE
5
Loosen and remove LEVER HANDLE (1). Loosen
HANDLE SCREW (2) with 2.5mm Hex Wrench and
then pull HANDLE BASE (3) off.
Unscrew ESCUTCHEON CAP (4). Unscrew the
CARTRIDGE NUT (5).
Remove CARTRIDGE (6). Clean inlets of
CARTRIDGE (6) and MANIFOLD (7).
Reassemble CARTRIDGE (6). Replace CARTRIDGE
NUT (5), CAP (4) and HANDLE assembly,
check flow.
SERVICE
Clogged CARTRIDGE outlets or inlets may cause reduced
flow. To clean, first turn off water supply then:
If SPOUT (3) leaks at swivel point the O-RINGS (2) need
to be replaced. To remove SPOUT (3):
Loosen the SPOUT SET SCREW (1) with a 3mm Hex wrench.
Rotate the SPOUT (3) side to side while pulling upward to
remove SPOUT (3) from faucet body.
Replace all defective parts, grease O-RINGS (2).
Important: Make sure small PLASTIC EYELET (4)
is installed. Center hole in EYELET (4) must align
with SET SCREW (1). (See Figure A). Push SPOUT (3)
back into position. Tighten SET SCREW (1).
Check that SPOUT (3) rotates freely and does not leak
at the swivel point.
4
6
REMOVE
INSTALL
CARE INSTRUCTIONS:
DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.
DO NOT: DO NOT CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH, ABRASIVES, HARSH CLEANERS, OR A
CLOTH WITH A COARSE SURFACE.
2
3
1
4
5
6
7
CLEAN
3mm HEX
WRENCH
2
Figure A
M968577 Rev.1.7

MODEL NUMBER
CHROME
STAINLESS STEEL
002
075
Replace the "YYY" with
appropriate finish code
PEKOE®
HOT LINE FOR HELP
For toll-free information and answers to your questions, call:
1 [phone]
Weekdays 8:00 a.m. to 6:00 p.m. EST
IN CANADA 1-800-387-0369 (TORONTO 1-905-306-1093)
Weekdays 8:00 a.m. to 7:00 p.m. EST
Product names listed herein are trademarks of American Standard Inc.
© AS America, Inc. 2008
IN MEXICO 01-800-839-1200
M962686-0070A
SEAL
M962704-YYY0A
PEDESTAL
M962690 -0070A
CARTRIDGE NUT
M962712-0070A
SPOUT SET SCREW M962691-YYY0A
CARTRIDGE COVER
M962672-0070A
MOUNTING KIT
M906667-0070A
FIXATION RING
Single Lever Semi-Professional
Kitchen Faucet
M964407-0070A
CARTRIDGE
M962701-0070A
O-RING
M964341.0070A
SPOUT BUSHING
& O-RING KIT
M962695-YYY0A
SPRAY HOSE
AND SEALS
M962696-0070A
CHECK VALVE
M962697-YYY0A
SPRAY HOSE ADAPTER
M962694-YYY0A
SPOUT SPRING
M962702-YYYOA
SPOUT PIPE
M923825-YYY0A (2.2 GPM)
AERATOR
M922881-YYY0A (1.5 GPM)
AERATOR
M962698-0070A
SEAL
M962699-YYY0A
SPRAY ARM
M962700-0070A
SPRAY ARM BUSHING
M962688-YYY0A
HANDLE KIT
(Before June 2009)
M962755-YYY0A
HANDLE KIT
(After June 2009)
M968577 Rev.1.7
4332.350
4332.350F15
4332.358 Series
M962683-YYY220A
(2.2 GPM) PULL-OUT SPRAY
WITH CHECK VALVE
M962683-YYY150A
(1.5 GPM) PULL-OUT SPRAY
WITH CHECK VALVE