4
. Make sure that all wires and cables are facing front
and not twisted; install handlebar into handlebar stem
tightening the two bolts on handlebar stem using an
allen wrench. Tighten the handlebar as tight as
possible.
5
. Caution – When installing pedals there are two
separate pedals for the left and right sides of the bike.
They have different tread patterns and it is important
to be sure each is installed on the correct side of the
bike to avoid stripping the threads. The following
procedure is performed so that when the bike is
pedaled it tightens the pedals.
6
. Right Pedal – Facing the bike from the chain side,
place pedal with R on the end of its bolt-on chain side
of the bike and tighten by turning clockwise (top of
wrench turning towards the front of the bike as noted
in the picture below.) Tighten pedal very tight.
AmericanElectric
®
suggests taking your electric bike to a
professional bike technician for assembly.
If you are comfortable assembling it on your own then
please refer to the directions below.
Warning – When removing packaging and zip ties do
not use box cutters or knives as you may damage paint
or tires.
We suggest a pair of scissors.
1
. Carefully remove the packing from around the
bicycle.
2
. Carefully cut the zip ties holding the front wheel and
handlebars to the frame.
3
. Mount the front tire to the front forks using a
15
mm
wrench to tighten outside nuts.
ASSEMBLY
ASSEMBLY
9/10
