Amerihome SSUSK1816 User manual

Stainless Steel Utility Sink
Assembly Instructions
READ ALL INSTRUCTIONS AND WARNINGS BEFORE USING THIS PRODUCT.
This manual provides important information on proper assembly. Every effort has been
made to ensure the accuracy of this manual. These instructions are not meant to cover every possible
condition and situation that may occur. We reserve the right to change this product at anytime without
prior notice.
IF THERE IS ANY QUESTION ABOUT A CONDITION BEING SAFE OR UNSAFE, DO
NOT OPERATE THIS PRODUCT!
HAVE QUESTIONS OR PROBLEMS? CONTACT CUSTOMER SERVICE.
If you experience a problem or need partsfor this product, visit our website http://www.buffalotools.com
or call our customer help line at 1-636-532-9888, Monday-Friday, 8 AM - 4 PM Central Time. A copy of the
sales receipt is required.
FOR CONSUMER USE ONLY – NOT FOR PROFESSIONAL USE.
KEEP THIS MANUAL, SALES RECEIPT & APPLICABLE WARRANTY FOR FUTURE
REFERENCE.
ITEM # SSUSK1816

ABCD
A
B
B
B
B
C
C
D
D
1
E F G H
2
E
E
H
F
G
3 4
1 piece sink body
1 piece drainer
Place the sink (A) upside down on the floor.
Use the hex wrench (D) to remove 8 pcs hex screws (C) from
four corner support of sink (A).
Insert each leg (B) into each corner support of sink (A).
Use the hex wrench (D) to tighten the hex set screws (C) into
the corner support. Each corner support requires two hex screws.
Separate the whole drainer (E).
Then reassemble the drainer on the sink as shown above.
Put sink (A) on the hanging bar (F).
Rotate the leg feet pads to compensate for differences in
floor surface.
According to the height of the baffle plate of the sink (A), drill holes in
the wall.
Then put each plastic tubbing (H) into each hole.
Insert each screw (G) through the hanging bar (F) into the
plastic tubbing (H).
1 piece hanging bar
2 pieces screws
for hanging bar
2 pieces plastic tubbing
for hanging bar
4 pieces leg w/feet 8 pieces hex screws 1 piece hex wrench
ITEM # SSUSK1816 STAINLESS STEEL UTILITY SINK