AMIGOPOD PowerConnect W Clearpass 100 Software User manual

Copyright © 2010 amigopod. All rights reserved.
Adding a Hard Drive to Increase
Available Disk Space
Unified Visitor Management
amigopod Technical Note
Revision 1.0
4 October 2010
United States of America
[phone]
Europe, Middle East & Asia
[phone]
Australia & Pacific
[phone]
http://www.amigopod.com

Adding a Hard Drive to Increase Available Disk Space Version 1.0
CONFIDENTIAL 2
Table of Contents
Introduction ..............................................................................................................................3!
Audience ............................................................................................................................. 3!
Document Overview ............................................................................................................ 3!
Disclaimer............................................................................................................................ 3!
Adding a Hard Drive.................................................................................................................4!
Safely Power Off the VMA................................................................................................... 4!
Snapshot Virtual Machine ................................................................................................... 4!
Add the Hard Drive.............................................................................................................. 4!
Allocating the New Hard Disk ..................................................................................................8!
Check Plugin Versions ........................................................................................................ 8!
Backup Configuration.......................................................................................................... 8!
Confirm New Disk Detection ............................................................................................... 8!
Allocate Space .................................................................................................................... 8!

Adding a Hard Drive to Increase Available Disk Space Version 1.0
CONFIDENTIAL 3
Introduction
This technical note explains how to increase available disk space in a
VMWare based appliance. Our default virtual machines ship with an 8 GB
disk, which is suitable for most deployments. For a deployment requiring
enhanced logging, or disk usage, this guide will step you through the required
actions.
Note that the rack mount VMA appliances cannot have hard drives added.
This guide is for virtual machines only.
Audience
This document is intended for network administrators and system integrators
deploying an amigopod-based visitor management solution.
Basic familiarity with the amigopod Visitor Management Appliance is
assumed. For in-depth information about the features and functions of the
amigopod appliance, refer to the amigopod Deployment Guide.
Document Overview
The first section of the document explains adding a hard drive within
VMWare.
The next section contains the steps within the Amigopod interface to detect
and allocate the new disk.
Disclaimer
The topics of network design, security architectures and visitor access are
complex subjects, and no single document can hope to cover all of the
possible combinations of network equipment, network design, deployment
requirements, and device configurations, nor can all the possible security
implications for a particular recommendation be covered.
Therefore, while you read this document, it is best to consider it as a guide to
developing your own understanding of the network design topics covered,
and as a basis for further investigation.

Adding a Hard Drive to Increase Available Disk Space Version 1.0
CONFIDENTIAL 4
Adding a Hard Drive
Please refer to your VMWare documentation for changes specific to your
version and platform. This example uses Server 2.0.
Safely Power Off the VMA
Make sure the virtual machine is powered off. If VMWare is configured to
send the soft reset signal to the operating system, this can be dine within
VMWare. To be safe, the Amigopod UI has a Shutdown action under
Administrator > System Control.
Snapshot Virtual Machine
It is highly recommended to back up your virtual machine. This is best done
by performing a snapshot. Some versions of VMWare may not allow
hardware configuration changes while a snapshot is in place. If that is the
case in your environment, you can safely perform a snapshot after the
hardware wizard below.
Add the Hard Drive
Log into the VMWare UI and select the virtual machine. You should see a
single hard drive. Under commands, select Add.

Adding a Hard Drive to Increase Available Disk Space Version 1.0
CONFIDENTIAL 5
Run through the Add wizard and select the options that suit your deployment.
In this example we will add a second 8 GB disk utilizing all the VMWare
defaults.
Select Hard.
Select Create a New Virtual.

Adding a Hard Drive to Increase Available Disk Space Version 1.0
CONFIDENTIAL 6
Select the hard drive options.
Finish the add hardware wizard and power on the server.

Adding a Hard Drive to Increase Available Disk Space Version 1.0
CONFIDENTIAL 7
The VMA should power up and you should see two hard drives in its setup.

Adding a Hard Drive to Increase Available Disk Space Version 1.0
CONFIDENTIAL 8
Allocating the New Hard Disk
Check Plugin Versions
Allocating extra disk space requires the following plugin versions:
!amigopod Administrator 3.0.2 or later
To verify you have the correct plugin versions installed, navigate to
Administrator > Plugin Manager > Manage Plugins and check the version
number in the list.
Use the Update Plugins link to download and install updated plugins.
Backup Configuration
It is important to take a full backup of your configuration under Administrator
> Backup & Restore > Configuration Backup.
Confirm New Disk Detection
Navigate to Administrator > System Information and expand the Storage
section. It should summarize two disks. The new disk (probably /dev/sdb)
will display a warning regarding the disk “doesn’t contain a valid partition
table”.
Allocate Space
This advanced feature is currently not available within the system navigation.
Please manually type in the file admin_sys_add_hd.php.
The page should load and give a summary of the current status.
Confirm your desire to add the disk, and click Allocate Space.

Adding a Hard Drive to Increase Available Disk Space Version 1.0
CONFIDENTIAL 9
NOTE Though we support adding multiple partitions, it is highly recommended to
leave the Last Cylinder selection blank.
Depending on your disk size, Allocate Space should take about 10 seconds.
If the action takes longer than 60 seconds, refresh the page (do not re-
submit).

Adding a Hard Drive to Increase Available Disk Space Version 1.0
CONFIDENTIAL 10
If you return to the System Information page, you will see the new allocation.
The space is now ready for use.