manuals.online logo
Brands
  1. Home
  2. •
  3. Brands
  4. •
  5. Ammeraal Beltech
  6. •
  7. Industrial Equipment
  8. •
  9. Ammeraal Beltech uni AMB Series Guide

Ammeraal Beltech uni AMB Series Guide

1 2
1 2
Assembly | Verbinden | Assemblaggio | Montaje | Assemblage
Disassembly | Trennen | Smontaggio | Desmontaje | Ouverture
3
Instructions and installation
Anweisungen und Installation
Istruzioni di assemblaggio
Instrucciones e instalación
Instructions de montage
Plastic Modular
Belt Series
uni AMB
with Endlock | mit Endlock | con Endlock | con Endlock | avec Endlock
©2021 Ammeraal Beltech Modular
Endlocks are single use items.
Always use new endlocks in assembly.
Endlocks sind Einwegartikel.
Verwenden Sie bei der Montage immer neue Endlocks.
Ogni endlock può essere usato solo una volta.
Usare sempre endolck nuovi in fase di assemblaggio.
Los cierres Endlock no son reutilizables.
Siempre deben ser reemplazados una vez retirados.
Les Endlocks sont à utilisation unique.
Toujours utiliser des endlocks neufs lors de l’assemblage.
eptool.online
www.ammeraalbeltech.com
Please note that sprockets should not be placed at the joints between two links.
Bitte beachten Sie, dass Kettenräder nicht auf den Verbindungsstellen zwischen zwei
Modulen platziert werden sollten.
Nota: i pignoni non devono essere posizionati in corrispondenza dei punti di contatto
di 2 moduli.
Las ruedas dentadas no deben ubicarse en la zona de unión entre módulos.
Attention de ne pas placer de pignon sur un raccord entre deux modules.
Please do not place a sprocket on the very outer hinge.
Bitte platzieren Sie die Kettenräder nicht am äußersten Scharnier.
Nota: i pignoni non devono essere posizionati in corrispondenza della cerniera più esterna.
Las ruedas dentadas no deben ubicarse en los módulos exteriores.
Attention de ne pas placer de pignon sur les charnières aux extrémités.
Sprocket installation | Kettenrad-Installation | Installazione pignoni | Instalación ruedas | Installation des pignons
Engagement between belt and sprocket.
Verbindung zwischen Band und Kettenrad.
Ingranamento tra nastro e pignone.
Engranaje entre banda y rueda.
Engrènement entre la bande et le pignon.
Idler end
Umlenkseite
Ritorno
Retorno
Axe de renvoi
Drive end
Antriebsseite
Motorizzazione
Tracción
Axe moteur
Placement of sprockets | Platzierung der Kettenräder | Emplacement des pignons | Colocación de las ruedas |
Position des pignons
Place the sprockets with the marks in the same position to ensure alignment on the
shaft and correct engagement of the belt.
Montieren Sie die Kettenräder mit Hilfe der Markierungen in die gleiche Position,
um sicherzustellen, dass sie einheitlich auf der Welle sitzen und dadurch gleichmäßig
in die Kette greifen können.
Posizionare i pignoni con i riferimenti allineati per assicurare la corretta fasatura tra i
denti dei diversi pignoni e quindi il corretto ingranamento con il nastro.
Coloque las ruedas con las marcas en la misma posición, para asegurar su correcta
alineación en el eje y un correcto engranaje de la banda.
Positionner les pignons avec les marquages au même endroit, afin de garantir
l’alignement des dentures et un bon engrènement.
In general sprockets are placed evenly spread across the width of the belt. Please check with
your Ammeraal Beltech representative if application specific instructions apply.
Im Allgemeinen werden die Kettenräder gleichmäßig über die Breite des Bandes verteilt
angebracht. Bitte wenden Sie sich an Ihren Ammeraal Beltech-Ansprechpartner, wenn
anwendungsspezifische Anweisungen gelten.
Generalmente, i pignoni sono disposti uniformemente per tutta la larghezza del nastro.
Verificare con l’Ufficio Tecnico di Ammeraal Beltech se il nastro o l’applicazione in questione
necessita uno specifico posizionamento dei pignoni.
Como norma general, los piñones deben ser dispuestos de modo equidistante sobre el eje.
Por favor contacte con nuestro representante local si precisan de información detallada.
En général, les pignons sont uniforméments répartis sur la largeur de bande.
Veuillez vérifier auprès de votre représentant Ammeraal Beltech si des instructions spéci-
fiques à l’application s’appliquent.
Caution | Achtung |Attenzione |Atención | Precautions
RISK OF TRAPPING FINGERS
NEVER STICK
FINGERS THROUGH
BELT OPENINGS
WARNING
FIRE-
SUSTAINING
D
D
ANGER
ANGER


Storage/Lagerung/Stockage/Almacenamiento/Stockage
Caution: Do not expose to direct sunlight.
Warnung: Die Produkte keinem direkten Sonnenlicht aussetzen.
Attention: Ne pas exposer á la lumière directe.
Precaución: No exponer el producto a la luz solar directa.
Attention : ne pas exposer au rayon du soleil.
Caution: Do not expose product to extreme temperatures.
Warnung: Die Module nicht extremen Temperaturen aussetzen.
Attention: Ne pas exposer le produit à d’extrêmes températures.
Precaución: No exponer el producto a temperatuas extremas.
Attention : ne pas exposer aux températures extrêmes.
Danger: Fire-sustaining
Gefahr: Brandfördernd
Danger: Comburant
Peligro: Producto combustible
Attention : Comburant
Danger: Ignited plastic may generate poisonous smoke.
Gefahr: Beim Verbrennen von Kunststoff entsteht giftiger Rauch.
Danger: Le plastique enflammable peut générer de la fumée toxique.
Peligro: Plástico inflamable puede generar humo tóxico.
Attention : le plastique enflammé peut générer des fumées toxiques.
Chemicals
Chemikalien
Produits chimique
Químicos
Produits chimiques
Installation/Installation/Installation/Instalación/Installation
Be careful: Safety shoes required.
Vorsicht: Arbeitsschutzschuhe tragen.
Attention: Utiliser des chaussures de sécurité.
Cuidado: Calzado de seguridad preciso.
Attention : utiliser des chaussures de sécurité.
Danger: Eye protection required.
Gefahr: Schutzbrille tragen.
Danger: Se protéger les yeux.
Peligro: Se precisa protección en los ojos.
Attention : se protéger les yeux.
Caution: Gloves required.
Warnung: Schutzhandschuhe tragen.
Attention: Mettre des gants.
Precaución: Se precisan guantes.
Attention : porter des gants.
Be careful: Prevent accidents.
Vorsicht: Unfällen vorbeugen.
Attention: Éviter les accidents.
Cuidado: Prevenga accidentes.
Attention : prévenir les accidents.
Note: Use proper tools in good condition.
Achtung: Nur geeignetes Werkzeug in gutem Zustand verwenden.
À noter: Utiliser le bo outil en bon état.
Nota: Emplear instrumentos adecuados en buenas condiciones.
Attention : Utiliser l’outil approprié et en bon état.
Caution: Risk of trapping fingers. Never stick fingers through belt openings.
Warnung: Klemmgefahr für die Finger. Stecken sie niemals Finger durch die Bandöffnungen.
Attenzione: Rischio di impigliamento delle dita. Non infilare mai le dita con organi in movimento.
Precaución: Riesgo de atrapamiento de los dedos. Nunca introduzca los dedos por las aberturas de la banda.
Attention : Risque de coincement des doigts. Ne mettez jamais les doigts dans les ouvertures de la bande.

Other Ammeraal Beltech Industrial Equipment manuals

Ammeraal Beltech uni chains uni M-QNB Series Guide

Ammeraal Beltech

Ammeraal Beltech uni chains uni M-QNB Series Guide

Ammeraal Beltech uni chains uni X-MPB Series Guide

Ammeraal Beltech

Ammeraal Beltech uni chains uni X-MPB Series Guide

Ammeraal Beltech uni chains uni NTB Series Guide

Ammeraal Beltech

Ammeraal Beltech uni chains uni NTB Series Guide

Ammeraal Beltech uni chains uni M-TTB Series Guide

Ammeraal Beltech

Ammeraal Beltech uni chains uni M-TTB Series Guide

Ammeraal Beltech uni chains uni M-OWL Series Guide

Ammeraal Beltech

Ammeraal Beltech uni chains uni M-OWL Series Guide

Ammeraal Beltech uni ACB K800 Manual

Ammeraal Beltech

Ammeraal Beltech uni ACB K800 Manual

Ammeraal Beltech Plastic Modular Belt Series Manual

Ammeraal Beltech

Ammeraal Beltech Plastic Modular Belt Series Manual

Popular Industrial Equipment manuals by other brands

HRS FX2BR-GPA Series instruction manual

HRS

HRS FX2BR-GPA Series instruction manual

ABB HT612190 Operation manual

ABB

ABB HT612190 Operation manual

Logosol TRAILER KIT G2:1 user manual

Logosol

Logosol TRAILER KIT G2:1 user manual

Eaton SLN018 Instruction booklet

Eaton

Eaton SLN018 Instruction booklet

Eteros TRIMINATOR XL user guide

Eteros

Eteros TRIMINATOR XL user guide

TREND CRT/MK3 Original instructions

TREND

TREND CRT/MK3 Original instructions

IMEON ENERGY 3.6 installation guide

IMEON ENERGY

IMEON ENERGY 3.6 installation guide

OTT-JAKOB HSK A63-D Product information

OTT-JAKOB

OTT-JAKOB HSK A63-D Product information

Enerpac L2058 instruction sheet

Enerpac

Enerpac L2058 instruction sheet

Sumitomo Drive Technologies PARAMAX SFC Series quick start guide

Sumitomo Drive Technologies

Sumitomo Drive Technologies PARAMAX SFC Series quick start guide

Graco Power-Lock Instructions - parts

Graco

Graco Power-Lock Instructions - parts

Cognex In-Sight 3800 Series Reference manual

Cognex

Cognex In-Sight 3800 Series Reference manual

MHM SP5000 Wiring diagram

MHM

MHM SP5000 Wiring diagram

Epiroc LPHB-M Safety and operating instructions

Epiroc

Epiroc LPHB-M Safety and operating instructions

SUHNER ABRASIVE TAM Technical document

SUHNER ABRASIVE

SUHNER ABRASIVE TAM Technical document

ABB HT607553 Operation manual

ABB

ABB HT607553 Operation manual

Eaton BZM3 - XTVD Instruction leaflet

Eaton

Eaton BZM3 - XTVD Instruction leaflet

GEDA 500Z operating instructions

GEDA

GEDA 500Z operating instructions

manuals.online logo
manuals.online logoBrands
  • About & Mission
  • Contact us
  • Privacy Policy
  • Terms and Conditions

Copyright 2025 Manuals.Online. All Rights Reserved.