
P. 3
| Tecshow Ale Mini Spot 3
English version
Unpacking instructions
Once receiving a xture, carefully unpack the
carton, check the contents to ensure that all parts
are presented, and have been received in a good
condition. Notify the shipper immediately and
retain packing material for inspection if any parts
appear damaged from shipping or the carton itself
shows, sign of mishandling. Save the carton and all
packing materials. In the event that a xture must
be returned to the factory, it is important that the
xture be returned in the original factory box and
packing.
AC Power
To determine the power requirements for a
particular xture, see the label aixed to the
back plate of the xture or refer to the xtures
specications chart. A xture listed current
rating is its average current draw under normal
conditions. All xtures must be directly powered
o a switched circuit and cannot be run o a
rheostat (variable resistor) or dimmer circuit, even
if the rheostat or dimmer source voltage matches
the xtures requirement. Check the xture or
device carefully to make sure that if a voltage
selection switch exists that it sets to the correct
line voltage you will use.
Warning
Verify that the voltage select switch on your unit
matches the line voltage applied. Damage to your
xture may result if the line voltage applied does
not match the voltage indicated on the voltage
selector switch. All xtures must be connected to
circuits with a suitable Earth ground.
2. INTRODUCTION
3. DISPLAY MENU
Menu Button (from le to right) ”menu”, ”up”,
”down”, ”OK”
System Menu When making adjustments press
ENTER to conrm your setup .
MENU Sub-MENU Instruction
Addr A001-A512 DMX Address
CHHY
(X Y) Pan & Tilt forward moving
(-X Y) Pan reverse moving, Tilt forward moving
(X -Y) Pan forward moving, Tilt reverse moving
(-X -Y) Pan & Tilt reverse moving
SLnd
Sound Sound Control
SLAVE Slave Mode
Auto Fast Auto Fast Running
Auto Low Auto Slow Running