Amptweaker TIGHT ROCK User manual

amptweaker
TIGHT ROCK
Congratulations on the purchase of your TIGHT ROCK
On behalf of the amptweaker team I would like to thank you
for your support of our company, products, and vision.
At amptweaker, we are only as good as our interaction with
you, the customer. Our product development is based on your
calls, emails, and comments on social media as we continue to
provide and create products players want and need.
TheTIGHT ROCK currently in your possession is capable of an
amazing range of tones and it is our sincere hope you take some
time to dig in and see what works best for you.
This manual will provide a starting point for your sonic journey
but do not hesitate to experiment. Remember, as our
founder,legendary amp guru James Brown, has always said…..
”Good tone comes from tweaking……”
Sincerely,
JackThompson
President - amptweaker
amptweaker, LLC warrants this product against defects due to faulty
materials or workmanship for five years from the date of original retail
purchase.This warranty is non-transferable, so please keep your receipt
for proof of purchase.
If the product becomes defective within the warranty period,
amptweaker, LLC will repair or replace at its discretion. Please
contact amptweaker, LLC to attain an authorization number (RMA#)
and instructions to return it freight prepaid by the purchaser.
ThisWarranty is void if the product has been repaired or altered by
anyone other than the manufacturer, or if damage to the product
resulted from accident or misuse.There are no warranties which extend
beyond the terms described herein.
www.amptweaker.com
amptweaker
Tips &Tricks
The TIGHT ROCK can be used as a distortion pedal either in
front of a clean channel or as a preamp. If the gain is set lower and
volume higher, it can also be used to overdrive a lead channel.
Plexi EQ setting cuts mids and extends the highs. For more bass, try
turning the Tone down andVolume up.
Try connecting the output of theTIGHT ROCK into the effect
return of the amp, bypassing the preamp for the most headroom.
When using extremely high settings on theTight control, it may be
necessary to increase your amp’s bass control.
Remember-There is no right or wrong. If it sounds good, it is good!
FiveYear LimitedWarranty

Volume – Master volume
Tone - Adjusts highs up and down to balance with
lows. 12 o’clock is neutral.
Gain - Adjusts distortion. Set lower for vintage rock
tones, higher for modern, heavier tones.
EQ Switch – Select tone stack. Smooth warms high
end.
Noise Gate –Turn up to reduce hum and/or noise.
Tight Switch –Tight for aggressive, chunky attack.
Fat for a thicker “singing” distortion tone.
DC Jack – 9-18V, for 50W to 100W amp tone. Use
(-) center negative pin. (Power adapter not included)
Tight Rock Controls
www.amptweaker.com
Specifications
Input Impedance: 250K Ohm (with effect on)
Output Impedance: 1K Ohm (with effect on)
Current Draw: 13mA at 9V, 15mA at 18V
Adapter: 9-18VDC adapter w/5.5mm X 2.1
mm positive barrel, center ground negative (-)
Dimensions: 1.5” H, 2.5”W, 4.5” D
Made in USA