AMX PS-POE-AF User manual

Installation Guide
PS-POE-AF PoE Injector
Overview
The PS-POE-AF (FG423-80) is a Power-over-Ethernet (PoE) power supply
with integral DC Injector (FIG. 1). It provides DC power for one PoE-
equipped device by "Injecting" DC power through the CAT5 ethernet cable.
The PS-POE-AF supports the IEEE standard PoE pinout:
Pins 4&5 Power (+) / Pins 7&8 Power (-). See Pin Connections (on reverse)
for details.
Key features include:
• Power over Ethernet (PoE)
• 10/100/1000 (MbPS) Data Rates
• Self-contained Injector
• 100-240VAC Universal Input
• Desktop Style / Non-vented Case
• IEEE802.3af Compliant Detection, Disconnect, Overload and Over
Voltage Control Function
• Load Diagnostic LED
• UNH IOL Test Report
• Over Load Shutdown and Short Circuit Protection
• Regulated Output With Low Ripple
• Meets Safety Agency Requirements
• Complies with EMI/RFI Regulations
Product Specifications
FIG. 1 PS-POE-AF Power-Over-Ethernet Power Supply
PS-POE-AF Specifications
Input Specifications
AC Input Voltage Range 100-240VAC -10%, +6%
Line Frequency 47-63Hz
AC Input Current 0.6A MAX at 90 VAC + Full Load
Protection • Internal Primary Current Fuse
• Inrush Limiting
Input Power Cord 50 mm IEC power cord terminated with a
grounded Edison plug for AC input
PS-POE-AF Specifications (Cont.)
Output Specifications
Output Voltage 48 VDC Nominal
Output Current 0.3125 A Max
Combined Line and
Load Voltage Regulation Excluding Cord ±1%
Ripple and Noise 1% Vp-p Max
Transient Response • 0.5ms for 50%
• Load Change Typical
Protection • Foldback Overcurrent Protection
• Short Circuit Protection
Power Indicator LED indicates the presence of DC on the
output
General Specifications
Topology • Switching-Fixed
• Frequency Flyback
Dielectric Withstand • Primary-Secondary 3000VAC, 4250VDC
• Secondary-Ground 500VDC
Spacing 5mm Primary-Secondary
Leakage Current Less than 250 uA
Efficiency • 65% Typical @ Max. Load
• 120VAC/60 Hz
Weight (excluding cord) 7 oz (200 g)
Dimension (HWD) • 5 1/4" x 2 1/8" x 1 7/16"
• 13.3 cm x 5.4 cm x 3.6 cm
Case Material Black 94V0 Polycarbonate
Cord and Connectors Dual RJ45 jacks built into the enclosure
EMC Information
FCC • Part 15 Class B
• EN55022 Class B
Immunity ESD: EN61000-4-2
RS EN61000-4-3
EFT EN61000-4-4
Surge EN61000-4-5
CS EN61000-4-6
Voltage Dip EN61000-4-11
Harmonic EN61000-3-2
CE CE Compliant
Hold-up Time • @120VAC 10ms min. typ.
• @240VAC 40ms min. typ.
Storage Temp -30° C to +85° C
Approvals and
Standards - Safety • cULus: UL/CSA60950
• TUV: EN60950
• CE: LVD, EMCD
MTBF 100,000 Calculated Hours
Environmental Specifications
Thermal Performance • 32°F to 104°F (0°C to 40°C)
• No Derating
• Convectional Cooling
• Non Vented Case
Relative Humidity Non-Condensing 5% to 95%
Altitude 0-10,000 feet

For full warranty information, refer to the AMX Instruction Manual(s) associated with your Product(s).
5/12
©2012 AMX. All rights reserved. AMX and the AMX logo are registered trademarks of AMX.
AMX reserves the right to alter specifications without notice at any time.
3000 RESEARCH DRIVE, RICHARDSON, TX 75082 • 800.222.0193 • fax [phone] • technical support 800.932.6993 • www.amx.com
93-0423-80 REV: C
Pin Connections
FIG. 2 describes the PoE Gigabit pin-out connections for the IN and OUT
Ports on the rear panel of the PS-POE-AF:
FIG. 2 PoE Gigabit pin-out connections
J2 J1
(Data IN)(Power and Data OUT)
(rear of unit)
POWER (+)
DATA Pins 4/5 (DATA + PWR)
DATA Pins 1/2 (DATA only)
DATA Pins 3/6 (DATA only)
POWER (-)
DATA Pins 7/8 (DATA + PWR)
Note: = Transformer