AMX netlinx NXC-REL10 User manual

Installation Guide
NXC-REL10 Relay Card, 10 Channels
For full warranty information, refer to the AMX Instruction Manual(s) associated with your Product(s).
12/07
©2007 AMX. All rights reserved. AMX and the AMX logo are registered trademarks of AMX.
AMX reserves the right to alter specifications without notice at any time.
3000 RESEARCH DRIVE, RICHARDSON, TX 75082 • 800.222.0193 • fax [phone] • technical support 800.932.6993 • www.amx.com
93-2020 REV: C
NetLinx Control Cards and NetModules
NetLinx Control Cards can be installed in either the NXF CardFrame, NI-4000, or
NetModules. This document provides basic specifications and wiring information
for the NetLinx Control cards.
For detailed information on the cards, refer to the NetLinx CardFrame, Control
Cards, and NetModules Instruction Manual. available on-line via www.amx.com.
NXC-REL10 Specifications
The NXC-REL10 Relay Control Card provides ten relays supporting devices that
employ simple momentary or latching contact-closure control, with LED
feedback.
Pinouts and Functions:
NXC-REL10 Channel Assignments:
Channels 1-10 represent relays 1-10.
NXC-REL10 Connections/Wiring:
The NXC-REL10 Control Card has 10 relays that are independently controlled
and electrically isolated.
The relay contacts are rated for a maximum of 1A @ 0-24VAC or 0-28VDC
(resistive).
Jumpers located on the Card allow you to select Normally Open (NO) or
Normally Closed (NC) contact settings:
FIG. 1 NXC-REL10 Relay 10 Control Card
NXC-REL10 (FG2020) Specifications
Power Requirements: 260 mA @ 12 VDC (maximum)
Operation: Relays 1-10: ten relays, 1A @, 24VAC / 28VDC
LEDs: 10 red LEDs light to show ON status activity for each
relay.
Wiring: • Two 10-pin 3.5 mm captive-screw terminals
• Commoning strip (metal)
DEVICE_ID: $010a
NO and NC 3-pin jumpers J6 - J10
NO and NC 3-pin jumpers J1 - J5
NXC-REL10 Pinouts and Functions
Pin Function Pin Function
1 Relay 1A 11 Relay 6A
2 Relay 1B 12 Relay 6B
3 Relay 2A 13 Relay 7A
4 Relay 2B 14 Relay 7B
5 Relay 3A 15 Relay 8A
6 Relay 3B 16 Relay 8B
7 Relay 4A 17 Relay 9A
8 Relay 4B 18 Relay 9B
9 Relay 5A 19 Relay 10A
10 Relay 5B 20 Relay 10B
Normally open (NO) mode setting on jumper pins 1 and 2 (default).
Normally closed (NC) mode setting on jumper pins 2 and 3.