Andersen Sterilizers Anprolene AN74i Instruction sheet

Installation Guidelines
Quick
release
connector
2" PVC pipe
Ceiling
Adapter (1)
Quick
release
connector
Quick
release
connector
Exterior*
Roof
Exterior*
Exterior*
Recommended Installation
Alternate Option 1 Roof installation with vent boot
2" PVC pipes
When possible, the Anprolene Sterilizer
should be located near an outside wall,
and exhaust directly to the outside by
means of ¾" (1.9cm) I.D. tubing.
Through wall mounting kits are available
from Andersen. Note: Sterilizer must be
placed in an area that can maintain 68°F
or above room temperature.
Through the roof applications are best accomplished by installing 2" SCH
40 PVC using a roof vent boot and stabilizing the PVC to extend just below
the ceiling. The ¾" I.D. to 2" adapter cap is available from Andersen.
Note: 2” SCH 40 PVC exhaust can run up to 800' depending on path -
bends/90° turns will reduce distance.
Anprolene sterilizer installation options
Hose

IN THE USA
MADE WITH PRIDE
Distributed in Europe by: H.W. Andersen SARL
Distributed in UK, Australia, Africa & Middle East by:
H.W. Andersen Products, Ltd.
anderseneurope.com
Health Science Park • 3202 Caroline Drive
Haw River, NC 27258-9564 USA
800.523.1276
REGISTERED
#3004634710
Join Us: Follow, Like, Share
sterility.com
IN THE
U
S
A
M
A
D
E WITH
PR
I
D
E
D
istributed in Europe b
y
:H.W. Andersen SARL
D
istributed in UK, Australia, Africa & Middle East by:
H.W. Andersen Products, Ltd
.
an
d
erseneuro
p
e.co
m
Hea
l
t
h
Science Par
k
• 3202 Caro
l
ine Driv
e
Haw River
,
NC 27258-9564 USA
80
0
.
5
2
3
.
127
6
REGISTERE
D
#
300
4
63
471
0
J
oin Us: Follow, Like, Shar
e
s
terilit
y
.co
m
Installation Guidelines
Exterior*
Quick
release
connector
Straight
quick release
connector
Exterior*
Wall
Roof
Alternate Option 2 Remote location installation
Alternate Option 3 Sot or eve termination
The through wall mounting kit can also be
used as a ceiling mount to allow eve or
soffit termination. Straight quick
disconnect fittings and vent screens are
available from Andersen.
The ¾" (1.9cm) I.D. braided tubing may be up
to 200' (60.96m) in length allowing for sterilizer
placement in remote locations. (Choose a path
that will provide exhaust tubing protection from
obstruction or damage.)
Note: Installation in plenum designated areas
require use of plenum rated materials.
For further installation assistance please call your Andersen representative or 1.800.523.1276
* Please note: AAMI guidelines recommend all EO sterilizers be vented through a dedicated exhaust line to the outside atmosphere directly or through
an emission control system. The vent should not terminate within 25 feet of any building air intake source or near pedestrian or animal traffic, nor should
it allow EO release into or to reenter the building.
PN1712_031121
Vent screen
(optional)
Hose