Andersen 400 Series User manual

Product Series: 400 Series
Product Type: Tilt-Wash Double-Hung Windows
Half Insect Screen
Installation and Removal Guide
Screen will not stop child
from falling out window.
Keep child away from open
window.
Half insect screen can move up and
down in the frame channel when
latches are engaged. Slide insect
screen down to sill.
Parts Included:
Position bug seal to top side
of insect screen, as shown.
Flip pull tab down.
12
Read these instructions before starting procedure. For additional information visit www.andersenwindows.com. For questions call 1-888-888-7020.
Tools and Supplies Needed:
Safety
Glasses
Phillips
Screwdriver
WARNING
Use caution when working at elevated heights
and around window and door openings.
Follow the manufacturers’ instructions for
ladders and scaffolding. Failure to do so
could result in injury or death.
“Andersen” and all other marks where denoted are trademarks of Andersen Corporation. ©2018 Andersen Corporation. All rights reserved. 0005475 BB-00 05/22/18
NOTICE
WARNING
(1) Half Insect Screen
For non-white colors, fasten
through the pre-drilled holes
with screws provided.
Non-white Insect Screens Only
(Pile faces
interior)
(1) Bug Seal
White
OR
Non-White
with
(2) #6 x 3/8" Screws

2
0005475
3
Close top and bottom
latches on one side only.
Push side with closed
latches into the insect screen
channel. Position latch points
into insect screen channel,
as shown, creating a hinge
point.
Do not close latches
on opposite side.
5
78
▶Procedure is complete.
Pull tab must face
interior.
Close latches.
4
6
Slide insect screen
down to sill.
Unlock and fully open
bottom sash.
Hold insect screen sides,
near bottom, and pass
through window opening.
Pull insect screen in.