Andrews Dehumidification HD 500 DV Product information sheet

andrews-sykes.com
HD 500 DV
Dehumidier
Operating Instructions
& Safety Guide
Getting started and operation
General Safety
Electrical Safety
0800 211 611
Dehumidiers are for internal use only.
This equipment should only be used by a competent
person who has read and understood these instructions.
Check condition of equipment before use. If unit is
showing any signs of damage contact your supplier
immediately.
Never operate this equipment if you are ill, feeling tired or
under the inuence of alcohol or drugs.
Keep all vents and grills clear of obstructions.
Keep children and animals away from the dehumidifer.
Never leave them alone in a room where the units are in
use.
Make sure equipment is switched o and unplugged after
use.
This unit is dual voltage and can be used via a standard
domestic 13 amp 230 volt socket or 110 volt power supply.
ENSURE THE VOLTAGE SELECTOR SWITCH IS IN THE CORRECT
POSITION BEFORE CONNECTING TO ANY ELECTRICAL SUPPLY.
Always inspect plugs and power cables for damage before
plugging into power supply.
DO NOT USE IF ANY DAMAGE IS FOUND.
Ensure cables are installed to prevent hazards.
If an extension lead is used, ensure it is of the correct standard
and fully uncoiled before use.
Cables must not be laid in wet or damp areas.
Do not move equipment while operating.
Do not pull equipment by the power lead.
It is recommended that the electrical supply to this equipment
is protected by an RCD.
Fit correct plug top to power input
lead to suit operating voltage
selected.
13 amp BS1363 230volt or 16 amp
BS4343 Blue plug
16 amp BS4343 110 volt Yellow plug.
Connect plug to selected power
supply outlet socket and switch on.
Fig 1
Position equipment on level ground,
position centrally in the area
allowing free air ow.
Remove selector locking plate,
select operating voltage required,
re-t locking plate.
Fig 1
230 V 110 V
Fig 1

Fig 2
Connect condensate drain hose to suitable
container or gravity drain.
Which automatically starts and stops the machines
compressor when pre-set humidity levels are reached.
Many dehumidifying applications require humidity to
be controlled at set relative humidity levels (RH) to
avoid shrinkage of materials, cracking plaster, furniture
etc.
The HD 500 DV has been designed taking this into
account and can be supplied with a remote humidistat
which automatically starts and stops the machines
compressor when pre-set humidity levels are reached.
Switch on machine via rotary switch.
Position 0 : O
Position 1 : 230 volt.
Position 2 : 110 volt.
ENSURE THE VOLTAGE SELECTOR SWITCH LOCKING
PLATE IS IN THE CORRECT POSITION.
If the Dehumidier is to be used in an unoccupied building
where a gravity drain is not practical and to avoid the need
to regularly empty a container. (Time scales can vary
depending on humidity levels). The HD 500 DV can be
supplied with a separate condensate pump. Up to 20 metres
of exible drain hose can then be routed to a suitable drain
point.
Fig 2
Fig 3
The HD 500 DV can be transported and stored in a
vertical or horizontal position only.
The operating position requires the folding support leg
to be folded down and secured into position by the
locking rings.
Fig 3
Humidity Control
Transport and Storage