Light
Ambient light
Press the button once to turn on the ambient light, and press again up to 2 times to switch between brightness levels.
SOS Mode
Hold the button for 2 seconds to activate SOS mode.
FAQ
Q1: What is the maximum power output of the AC output ports?
The AC output ports can deliver a maximum of 1800W rated power to connected devices.
Q2: What should I do when using a solar charger to charge my power station?
The solar input supports an 11-60V solar charger with an XT-60 connector. If you use an 11-32V solar charger, the current supports 10A max. When you
use a 32-60V solar charger, the current supports 12.5A max. We recommend using Anker solar panels (200W or 400W) for the best compatibility.
Q3: Can the USB-C ports charge the power station (input only) , or are they output only?
The USB-C ports support output only.
Q4: What should I do when AC recharging fails?
If AC recharging does not work, check if the overload protection switch is turned on. If it is on, press down to reset and then continue recharging.
Q5: How do I reset my power station?
If your power station is not working correctly, insert a paper clip or pin into the reset hole for 1 second for a factory reset. If the power station still doesn't
work, please contact support@anker.com.
Q6: Why is the power station not working after it hasn't been used for a long time?
If the power station is stored at a low capacity for a long time, lithium batteries will self-consume power which may lead to a quick discharge. This often
leads to poor conductivity and a reduced battery lifespan that causes the battery not to work.
Q7: How should I store and maintain the power station?
When storing your power station, please make sure that you:
1) Turn o the main power button.
2) Store the power station in a dry and cool environment.
3) Check the remaining battery capacity each week. If the battery level is below 30%, fully charge the power station. Charge it to 100% once every 3
months.
