anko Mini Waver CS-622 User manual

Mini Waver
CS-622
User Manual
PLEASE READ AND SAVE THESE
INSTRUCTIONS FOR FUTURE REFERENCE

2 | P a g e
IMPORTANT SAFEGUARDS
When using any electrical product, always follow these basic safety precautions:
READ ALL INSTRUCTIONS BEFORE USE.
Please read this instruction manual before using your product and keep it in a safe
place for future reference. If you pass the appliance on to anyone else, please include
this manual.
SAFETY PRECAUTIONS
• Carefully read all instructions before operation and retain for future reference.
• Do not place near the edge of a bench or table during operation .
• Always place the appliance on a heat-resistant stable flat surface.
• Ensure the surface is dry, level, clean and free of liquid and other substances.
• Do not leave the appliance unattended when the appliance is connected to mains
power. Always ensure the appliance is turned off by switching off and then
disconnecting the appliance from mains power when not in use.
•Always keep the appliance clean.
• Fully unwind the cord before use.
•To protect against electric shock, do not immerse the power cord, plug or appliance in
water or any other liquid.
• Do not allow the cord to hang over the edge of the table or bench, touch hot surfaces
or become knotted.
• This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instructions concerning use of the appliance by a
person responsible for their safety.
• Children should be supervised to ensure that they do not play with this appliance.
• If the supply cord is damaged do not use. Any repairs to the product must be carried
out by qualified electrical person only or the product must be disposed.
•This product is intended for household use only. Do not use it outdoors or for
commercial industrial purposes.
• NEVER grasp the appliance, power cable or power plug with wet hands.
• Always remove the power cable from the socket by pulling on the plug; do not pull on
the cable itself. Do not hold or carry the appliance by the power cord.
• Do not fold or crush the power cable. Ensure that the power cable does not run over
sharp edges.
• Please do not attempt to dismantle the appliance. This appliance has no user-
serviceable parts inside.
• When the appliance is used in a bathroom, disconnect from mains power after use.
Using the product proximity of water presents a hazard even when the appliance is
switched off.
• Do not use outdoors or operate where aerosol (spray) products are being used or
where oxygen is being administered.

2 | P a g e
• For additional electrical protection, the installation of a residual current device (RCD/
Safety switch) having a rated residual operating current not exceeding 30mA is
advisable in the electrical circuit supplying the bathroom. If unsure, check with your
electrician.
• For cleaning and maintenance, please refer to “CLEANING AND MAINTENANCE” section.
• Burn hazard. Keep appliance out of reach from young children, particularly during use
and cool down.
RISK OF FIRE
• Do not leave the appliance unattended when in use.
• To avoid a build-up of heat, NEVER cover the appliance. Do not use the appliance
under a blanket or at other poorly ventilated locations
• Avoid the addition of heat from other sources, e.g., from direct sunlight, heating
appliances, other devices, etc.
• Do not use an extension cable. In the event of danger, the supply cord plug must be
quickly and easily accessible.
ELECTRICAL REQUIREMENT
• Check that the voltage on the rating plate of your appliance corresponds with your
house electricity supply .
IMPORTANT!
•The plug removed from the mains lead, if severed, must be destroyed as a plug with
bared flexible cord is hazardous if engaged into a live power outlet socket.
•If the supply cord is damaged, DO NOT USE. Any repairs to the product must be
carried out by qualified electrical person only or the product must be disposed.
Danger of suffocation! Keep all packaging material away from children.
Dispose of the packaging materials in an appropriate way. Contact your
local authorities about collection points or waste separation.
Caution Risk of Burning! The appliance gets very hot!
Take care to avoid contact between the hot surfaces of the unit and the
skin, paying particular attention to the face, neck and hands
WARNING: Do not use this appliance near bathtubs, showers, basins or
other vessels containing water.
Class II Appliance.
SAVE THESE INSTRUCTIONS
FOR FUTURE REFERENCE.

INTRODUCTION
Use this appliance to wave human hair only. Do not use this appliance on artificial
hair or animals.
IMPORTANT! The appliance may have different results depending on the hair type.
Therefore, we recommend to do a trial at a hidden spot before first use. The hair
waver is not recommended for damaged or bleached hair.
BEFORE FIRST USE
•After unpacking the appliance, check for transport damage and that all the parts
mentioned in this manual are present. In the event of damaged or missing parts,
return the product to respective Customer Service Centre.
•Do not discard the original box. It can be used for storage and dispatch to avoid
transport damage.
•Clean the appliance as described in Cleaning and Maintenance. For your safety
make particular attention to the safety instructions in the manual.
OPERATION
WARNING! Never touch the hot curling barrels and wave plate.
WARNING! Always use the handle to hold the hair waver.
ATTENTION! The hair waver cools down slower than they heat up.
•Fully unwind the supply cord before turned on the appliance.
•Place the appliance on a smooth, flat, dry and heat resistant surface.
•Connect the power cord plug into a mains power outlet socket.
•Push the ON/OFF switch to ON position, the power indicator will light up.
ATTENTION! The hair waver heats up very fast. It takes approx. 3 minutes to
each max. temperature.
•When the appliance is ready, you may start hair styling.
•Comb through hair to prevent knots and tangles and then divide hair into equal
sections.
•Take a section of hair with no more then 3cm wide. Place the hair strand
between the top barrels and wave plate , then close the handles.
PARTS
v
1. On/Off switch
4. Top barrels
2. Power indicator
5. Bottom wave plate
3. Thumb rest
6. Cool tip
1
2
3
4
5
6

•Hold the hair waver in position for 10-15 seconds to create gentle hair waves.
•Release the handles and gently pull the hair waver away from head.
•CAUTION! Do not hold the hair between the plates for more than acouple of
seconds as this may damage/burn your hair.
•To allow the curl to set, do not comb or brush the hair until it cools.
•Repeat the process around the head until you have the amount for curls desired.
•Turn off the appliance after use, make sure the power indicator has gone off.
•Unplug the appliance from mains power socket and allow it to cool before
storage.
IMPORTANT! The appliance may provide different results depending on the hair type.
Therefore, we recommend carrying out a trial on a hidden inconspicuous area of your hair
before first use.
This hair styler is not recommended for use on damaged or bleached hair.
CLEANING AND MAINTENANCE
ATTENTION! Turn off the appliance and disconnect the plug from mains power outlet,
allow the appliance completely cool down before cleaning.
ATTENTION! Do not use any alcohol, acetone, gasoline, abrasive cleaning agents,
etc. to clean the plastic components. Do not use hard brushes or metal objects for
cleaning.
Risk of burning! Do not clean the appliance while still hot.
•Wipe the appliance with a dry cloth.
•Never submerge the appliance in water or let water run over the heating plates
or the appliance.
•The heating plate and barrels can be cleaned with a slightly damp cloth and a
little detergent if necessary.
•Dry thoroughly after cleaning.
STORAGE
•Store the appliance in a cool, dry location, away from children and pets.
•After use do not wrap the cord around the appliance as this may cause the cord
to fracture. Coil cord loosely by the side of the appliance after use and when
storing.
•If the appliance is not used for an extended period, store it preferably in its
original packaging.
DISPOSAL
Do not dispose this product with normal household waste collection. If unsure, contact the
local council waste management service for proper disposal facilities available for your
area.
TECHNICAL DATA
Voltage: 100-240V~ 50-60Hz
Power: 27W

Table of contents
Other anko Hair Styler manuals