Philips beauty Airstylist quattro 600 User manual

Airstylist quattro 600
HP4664

ENGLISH 4
POLSKI 10
ROMÂNĂ 16
РУССКИЙ 21
ČESKY 27
MAGYAR 32
SLOVENSKY 37
УКРАЇНСЬКІЙ 43
HRVATSKI 49
EESTI 54
LATVISKI 59
LIETUVIŠKAI 64
SLOVENŠČINA 69
БЪЛГАРСКИ 74
SRPSKI 80
HP4664

Introduction
This new Philips beauty Airstylist Quattro 600 has been specially
designed to give beautiful styling results in a quick and easy way.
Important
◗Read these instructions for use carefully before using the
appliance and save them for future reference.
◗Check if the voltage indicated on the appliance corresponds to
the local mains voltage before you connect the appliance.
◗Keep this appliance away from water! Do not use this product
near or over water contained in baths, washbasins, sinks etc. If
you use it in a bathroom, unplug the appliance after use, since the
proximity of water presents a risk, even when the appliance is
switched off.
◗For additional protection we advise you to install a residual
current device (RCD) with a rated residual operating current not
exceeding 30mA in the electrical circuit supplying the bathroom.
Ask your installer for advice.
◗If the appliance overheats, it will switch off automatically. Unplug
the appliance and let it cool down for a few minutes. Before you
switch the appliance on again, check the grille to make sure it is
not blocked by fluff, hair, etc.
◗Check the condition of the mains cord regularly. Do not wind the
mains cord round the appliance.
◗If the mains cord is damaged, the appliance must be discarded.
◗Always make sure that the attachments are completely dry - on
the inside as well as on the outside - before you connect them to
the styler.
◗The attachments will become hot during use. Prevent contact
with the skin.
◗Never block the air grille.
◗Keep the appliance out of the reach of children.
◗Always unplug the appliance after use.
◗Wait until the appliance has cooled down before storing it.
◗Noise level: L= 83 dB(A) re 1pW
ENGLISH4

Before using the appliance
◗Before you start using the Airstylist, comb or brush the hair so
that it is untangled and smooth.
◗The Airstylist is most effective when the hair is slightly damp.
When your hair is dry, slightly dampen it. Never use the appliance
on wet hair!
Do not insert the mains plug into the wall socket until after you have
connected the attachment.
Using the appliance
Drying
1Make sure the appliance is unplugged. Connect the concentrator
to the styler by aligning the arrows on the concentrator with the
arrows on the styler and pressing the concentrator home.You
will hear a click (fig. 1).
The concentrator allows you to dry your hair easily.
2Switch the appliance on by selecting setting ~ for a gentle, warm
airflow or setting 6for a stronger and warmer airflow (fig. 2).
3When you have finished drying, switch the appliance off.Then
remove the concentrator by pressing the release button and
pulling the concentrator in the direction of the arrow (fig. 3).
Follow this procedure for all attachments.
Making curls in short to medium-length hair
We advise you to perform a curl test to determine how long the brush
should be held in your hair to achieve a good result. Start with 8 to 10
seconds.You may have to hold the brush in your hair longer for tighter
curls. Less tight curls will require less than 8 seconds.
1Make sure the appliance is unplugged. Connect the retractable
bristle brush to the styler by aligning the arrows on the brush
with the arrows on the styler and pressing the brush home.You
will hear a click.
ENGLISH 5

2Divide the hair into locks.
3Take a lock of hair and wind it round the brush. Make sure the
end of the lock is wound in the required direction.
- Do not wind too much hair around the brush at a time.
- The thinner the lock of hair, the tighter the curl will be.
- Do not wind a lock of hair more than twice round the brush.
- Make sure the lock of hair is in contact with the barrel of the brush.
◗If you wind the hair at right angles to the scalp, you will give your
hair optimum lift and volume.
4Switch the appliance on by selecting setting ~ or 6.
5Keep the brush in your hair until the hair is warm to the touch.
6Switch the appliance off and remove the brush from your hair by
pushing and turning the bristle retraction knob in the direction of
the arrows (fig. 4).
◗As soon as the hair feels dry, you can fix your style by means of
the cool airflow. Set the slide to setting 6(blue) to cool down
and fix the curls (fig. 5).
7If you have not used the cool airflow, let the curls cool down
before combing, brushing or finger-combing the hair to finish your
style (fig. 6).
Making waves in long hair
1Take the ends of a lock of hair and wind them round the
retractable bristle brush in the desired direction.
2Switch the appliance on by selecting setting ~ or 6.
3As soon as the hair is warm to the touch, switch the appliance off
and carefully remove the brush from your hair by pushing and
turning the bristle retraction knob.
◗You can finish off by directing a cool airflow at the hair to cool
down and fix the waves.
ENGLISH6

4Let the waves cool down before combing, brushing or finger-
combing the hair to finish your style (fig. 7).
Volume
1Use the shape & volume brush to add maximum volume and
body to your hair.
The shape & volume brush is suitable for straight and wavy hair of any
length, but especially for long hair.
◗For longer-lasting results, you can apply some mousse before
styling your hair.
2Place the brush in the hair.
3Switch the appliance on by selecting setting ~ or 6.
4Brush against the direction of hair growth while touching your
scalp with the brush pins (fig. 8).
5Move the brush away from your head while turning the brush.
This will cause the hair to be lifted and to fall lightly back onto the head,
creating maximum volume.
◗You can finish off by directing a cool airflow at the hair.
Polishing and shaping
1Use the large cushion brush to polish and shape your hair (fig. 8).
Root lift
1Place the brush in your hair in such a way that the brush pins
touch your scalp.
2Switch the appliance on by selecting setting ~ or 6.
3Starting at the front, brush backwards and forwards along the
centre parting (fig. 9).
◗You can finish off by directing a cool airflow at the hair.
ENGLISH 7

Soft flowing hair
1Lift the hair on the sides of your head at the roots and follow the
length of the hair with the styler.
This technique will tame stray ends and helps promote shine and
softness.
◗You can finish off by directing a cool airflow at the hair.
Cleaning
1Unplug the appliance.
2Put the appliance in a safe place and let it cool down.
3Clean the appliance with a small brush or a dry cloth.
Storage
1Unplug the appliance.
2Make sure the appliance has cooled down sufficiently before
storing it.
3Do not wind the mains cord round the appliance.
4The appliance can be stored by hanging it from its hanging loop
(fig. 10).
Replacement
Always return the appliance to a service centre authorised by Philips
for examination or repair. Repair by unqualified people could cause an
extremely hazardous situation for the user.
ENGLISH8

Guarantee & service
If you need information or if you have a problem, please visit the Philips
Web site at www.philips.com or contact the Philips Customer Care
Centre in your country (you will find its phone number in the
worldwide guarantee leaflet). If there is no Customer Care Centre in
your country, turn to your local Philips dealer or contact the Service
Department of Philips Domestic Appliances and Personal Care BV.
ENGLISH 9

Wprowadzenie
Nowa lokówka Philips Beauty Airstylist Quattro 600 zaprojektowana
została specjalnie po to, aby mo na było w krótkim czasie i łatwo
uzyskiwać piękne rezultaty układania włosów.
Wa ne
◗Przed pierwszym użyciem urządzenia przeczytaj dokładnie tę
instrukcję obsługi i zachowaj ją na przyszłość, do ewentualnej
konsultacji
◗Przed podłączeniem urządzenia upewnij się, czy napięcie podane
na urządzeniu jest zgodne z napięciem w sieci elektrycznej
◗Trzymaj urządzenie z dala od wody! Nie używaj tego urządzenia
w pobliżu wody ani nad wodą znajdującą się w wannie, umywalce,
zlewie, itd Jeżeli korzystasz z niego w łazience, po użyciu zawsze
odłączaj je z sieci, ponieważ bliskość wody stanowi zagrożenie,
nawet wtedy, gdy urządzenie jest wyłączone
◗W formie dodatkowego zabezpieczenia radzimy zainstalować w
obwodzie elektrycznym, zasilającym gniazda, bezpiecznik RCD o
znamionowym prądzie zerowym nie przekraczającym 30 mA
Porozum się w tej sprawie z wykwalifikowanym elektrykiem
◗Jeśli urządzenie przegrzeje się, wtedy automatycznie wyłączy się
Odłącz urządzenie od zasilania, wyjmując wtyczkę z gniazdka i
poczekaj kilka minut aby się ochłodziło Przed ponownym
włączeniem urządzenia sprawdź kratkę wentylacyjną by upewnić
się, że nie jest zatkana przez puch, włosy, itd
◗Sprawdzaj regularnie stan kabla zasilającego Nie zawijaj kabla
zasilającego wokół urządzenia
◗Jeśli kabel zasilający jest uszkodzony, nie należy korzystać z
urządzenia
◗Przed założeniem na lokówkę nasadek należy zawsze upewnić się,
że są one zupełnie suche - zarówno wewnątrz, jak i z zewnątrz
◗Końcówki nagrzewają się podczas używania Uważaj, by nie
dotknąć nimi skóry
◗Nigdy nie zatykaj kratki wentylacyjnej
◗Przechowuj urządzenie w miejscu niedostępnym dla małych
dzieci
POLSKI10