anko Hollywood Mirror User manual

Hollywood Mirror
Small
For Household Use Only
Model No.: SM279A-SL
Rev 2
*Brushes not included

Page 2 of 12

Page 3 of 12
1Warnings.................................................................................. 4
2Safety Directions..................................................................... 4
3Components ............................................................................ 6
4Assembly Method ................................................................... 7
5Power Supply .......................................................................... 8
6Using the Mirror Lights........................................................... 9
6.1 On / Off .....................................................................................9
6.2 Dimmer.....................................................................................9
6.3 Light Type ..............................................................................10
7User Maintenance ................................................................. 10
7.1 Cleaning the Mirror................................................................11
8Storage................................................................................... 11
9Warranty Against Defect ...................................................... 12

Page 4 of 12
1 Warnings
Before using this appliance, read and follow all warnings and instructions in this
manual, even if you are familiar with this product.
This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction concerning use of the
appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
2 Safety Directions
Please read this instruction manual carefully before first use. It is advisable to keep
this instruction manual for future reference.
DO NOT use in a moist or humid area.
DO NOT use the mirror if any of the LED globes are damaged.
DO NOT store or use the appliance near high temperature areas.
DO NOT run over the power supply cable with a vacuum cleaner.
DO NOT use if the appliance malfunctions, abnormal noise, smell, smoke, is
dropped or damaged in any manner or any breakage is found during operation.
For electrical safety, any repairs to the product must be performed by a qualified
electrical person only, or the product must be disposed of.
DO NOT misuse the power supply cable. Never pull the appliance by the cable or
pull to disconnect it from the outlet. Instead, grasp the power supply body and pull
to disconnect.
DO NOT use with damaged power supply cable or power supply body.
DO NOT handle the power supply or mirror with wet hands.
DO Keep power supply cable away from heated surfaces
DO disconnect the power supply from the power supply when not in use,
DO NOT hang items off the LED light globes.
DO NOT attempt to modify this product in any way.

Page 5 of 12
Ensure the mirror is dry before adjusting the settings.
Use only on dry, level, indoor surfaces.
Use only as described in this manual.
Always store your appliance indoors in a cool dry area.
Ensure children and babies cannot play with plastic bags or any packaging
materials.
Ensure to operate the power supply from a power source of the same voltage,
frequency and rating as indicated on the product identification plate.
If this appliance is used by a third party, ensure to supply the instruction manual
with it.
No liability can be accepted for any damage caused by non-compliance with these
instructions or any other improper use or mishandling of the appliance.
This product has not been designed for any uses other than those specified in this
manual.
ONLY for domestic use. Industrial or commercial use invalidates the warranty.
Read and Save These Instructions

Page 6 of 12
3 Components
Note: Brushes are not included
Note: The specifications and/or components of this appliance are subject to change without prior notice
1 Mirror Frame 5 Base Stand
2 Mirror 6 Mirror Stand Neck. Tiltable
3 Light Type Selector 7 On / Off Switch & Brightness Adjustment
4 Power Supply 8 LED Lights
8
3
1
4
5
6
7
2

Page 7 of 12
4 Assembly Method
Please Note: a small amount of assembly is required.
The base needs to be fitted to the mirror.
To fit the base, place the base panel on a flat level surface.
Position the neck of the mirror over the post protruding from the base and
then lower onto the post as shown below.
Firmly press down until it clips into place.

Page 8 of 12
5 Power Supply
Important: Only use with Power Supply Model: WJA-Y 121201000W
(Output: 12Vd.c. 1A)
Unravel the power supply cable.
Plug in the small plug on the end of the power supply cable into the power jack
located in the back of the mirror.
Plug the power supply into the power point and switch on.
IMPORTANT! Switch off and remove the power supply from the power point
when not in use.

Page 9 of 12
6 Using the Mirror Lights
6.1 On / Off
With the power supply plugged into the power point and switched on, and the
power supply cable plugged into the back of the mirror, press the On / Off
Switch button on the mirror front.
The lights will turn on at full brightness.
6.2 Dimmer
To adjust the brightness, press and hold the On / Off Switch Button to adjust
the brightness to your requirement. Release the On / Off Switch Button when
your desired brightness is reached.

Page 10 of 12
6.3 Light Type
There are three types of light you can choose from being Natural, Warm and
Cool.
With the lights switched on, press the Light Type Selector button on the front
of the mirror.
Each press will cycle the light type from Natural to Warm to Cool and back
around to Natural etc.
7 User Maintenance
WARNING: Switch off and unplug the power supply before any maintenance
or cleaning.
Note: the LED lights are not removable or replaceable. They are designed to
last for the life of the product.

Page 11 of 12
7.1 Cleaning the Mirror
Do not clean the mirror or other parts with petrol, solvents or any other
flammable liquid.
Do not clean with scouring pads, rough cloths or the like as the surface will
be damaged.
Use only a very soft dry cloth to gently wipe the mirror and other parts.
Do Not submerge the mirror or other parts in liquid.
8 Storage
If you are to store the mirror, store it away in a dry cool place preferably in its
box.
Do not wind the power supply cable tightly. Loop it loosely.

Page 12 of 12
9 Warranty Against Defect
12 Month Warranty
Thank you for your purchase from Kmart.
Kmart Australia Ltd warrants your new product to be free from defects
in materials and workmanship for the period stated above, from the
date of purchase, provided that the product is used in accordance
with accompanying recommendations or instructions where
provided. This warranty is in addition to your rights under the
Australian Consumer Law.
Kmart will provide you with your choice of a refund, repair or
exchange (where possible) for this product if it becomes defective
within the warranty period. Kmart will bear the reasonable expense
of claiming the warranty. This warranty will no longer apply where
the defect is a result of alteration, accident, misuse, abuse or neglect.
Please retain your receipt as proof of purchase and contact our
Customer Service Centre 1800 124 125 (Australia) or 0800 945 995
(New Zealand) or alternatively, via Customer Help at Kmart.com.au
for any difficulties with your product. Warranty claims and claims for
expense incurred in returning this product can be addressed to our
Customer Service Centre at 690 Springvale Rd, Mulgrave Vic 3170.
Our goods come with guarantees that cannot be excluded under the
Australian Consumer Law. You are entitled to a replacement or
refund for a major failure and compensation for any other reasonably
foreseeable loss or damage. You are also entitled to have the goods
repaired or replaced if the goods fail to be of acceptable quality and
the failure does not amount to a major failure.
For New Zealand customers, this warranty is in addition to statutory
rights observed under New Zealand legislation.
IMPORTANT!
For all technical queries or difficulties in operating the product
and for spare parts, contact H.E. Group customer service 1300
105 888 (Australia) and 09 8870 447 (New Zealand).