Antec Leyden DECADE II User manual

Edition 1, 2003 250.7004
Installation of
manual injector
on DECADE II

Edition 1, 2003
Contents
1. Contents of the manual injector kit................................................. ................... 2
2. Removal protective plastic covers ................................................. ................... 3
3. Mounting bracket on DECADE II........................................................................ 4
4. Mounting valve on bracket................................................................................. 5
5. Insertion of valve switch and mounting the needle port.................................... 6
6. Mounting sample loop and other HPLC connections......................................... 7
7. Completed valve configuration....................................................... ................... 8
8. Configuration of hand valve in DECADE II software.......................................... 9
9. Valve in load position......................................................................................... 10
10. Valve in inject position.................................................................... ................... 11
11. Flow diagram model C1................................................................. ................... 12
Copyright ©2003. All rights reserved. Contents of this publication may not be reproduced in any form or by any means
(including electronic storage and retrieval or translation into a foreign language) without prior agreement and written consent
from the copyright of the owner.
The information contained in this document is subject to change without notice. Manufacturer and its affiliated companies
shall not be liable for errors contained herein or for incidental or consequential damages in connection with the furnishing,
performance, or use of this material.

Edition 1, 2003 page 2
Contents of the manual injector kit, Antec P/N’s 250.0012 or 250.0013 (micro).

Edition 1, 2003 page 3
Use no screw
driver or knife
Remove protective plastic covers.

Edition 1, 2003 page 4
Mount special valve bracket on DECADE II.

Edition 1, 2003 page 5
Mount manual valve in DECADE II bracket. Make sure that ports 4 + 5 are pointing upwards.

Edition 1, 2003 page 6
Insert valve switch and mount the needle port .

Edition 1, 2003 page 7
Mount sample loop and other HPLC connections, see connection schematics in flow diagram of C1 6-port valve
(drawing 4-KU-5051.00). Note: port 5 and 6 shown both be connected to waste (port 5 not connected in picture).

Edition 1, 2003 page 8
Completed valve configuration, front view.

Edition 1, 2003 page 9
Configuration of hand valve in DECADE II software: Go to CONFIG menu and set Valve to present (toggle by ‘+’ or ‘-‘).

Edition 1, 2003 page 10
Valve in LOAD position.

Edition 1, 2003 page 11
Valve in INJECT position.