Antec Micro ATX2.01 User manual

This Antec ATX Power supply is equipped with an intelligent electronic circuit that senses the temperature
of the power supply and the ambient temperature and regulates the speed of the fan. The speed of the power
supply fan increase as temperature rises. It is perfectly normal when fan turns off at a low temperature.
CAUTION! Be sure to disconnect the power cord from power supply before installing
or replacing a new power supply.
To install the ATX power supply to your computer:
1. Disconnect power cord from your power supply unit.
2. Disconnect the ATX 20-pin connector from power supply to system board and peripheral devices such
as hard drives, flopply drive, etc.
3. Remove the existing power supply from your computer and replace it with the Antec ATX power supply.
4. Connect the 20-pin connector power leads from power supply to system board.
5. Connect other leads to peripheral devices such as hard drives and floppy drives.
6. Connect power cord to the Antec power supply.
The ATX Power Supply Connector:
Figure 1 shows the connector pinout for the main ATX power connector.
Antec Micro ATX2.01 Power Supply User's Manual
Note: The ATX power supply package includes the following items:
1. Power supply
2. Power cord
3. Four screws to attach the power supply to the computer case.