APARIAN A-HRIO User manual

Revision 1.0
10/2017
Document No. D133-011 Page 1 of 2
HTC Gateway
Quick Start Guide
A-HRIO
REQUIRED SOFTWARE
The HTC Gateway requires Aparian Slate software to setup and configure. The
software installation can be found at www.aparian.com/software/slate.
MODULE INSTALLATION
The HTC Gateway requires input power of 18-28Vdc. The wiring of the power
connector can be found in the wiring diagram below. The HTC Gateway communicates
on both Ethernet and Hitachi RIOH and ROW. The wiring of the Hitachi connector can
be found in the wiring diagram below. The Ethernet connector should be wired
according to industry standards which can be found in the additional information
section.

Revision 1.0
10/2017
Document No. D133-011 Page 2 of 2
NETWORK SETUP
The HTC Gateway will have DHCP enabled as factory default. This the user must use a
DHCP server to assign an Ethernet network address to the module. Refer to the
additional information section for DHCP servers. Once the module has been assigned
an Ethernet address the user can configure the module with Aparian Slate.
ADDITIONAL INFORMATION
The following resources contain additional information that can assist the user with
the module installation and operation.
Resource Link
Slate Installation www.aparian.com/software/slate
HTC Gateway User Manual
HTC Gateway Datasheet
Example Code & UDTs
http://www.aparian.com/products/htcgateway
Ethernet wiring standard
www.cisco.com/c/en/us/td/docs/video/cds/cde/cde20
5_220_420/installation/guide/cde205_220_420_hig/Co
nnectors.html
SUPPORT
Technical support will be provided via the Web (in the form of user manuals, FAQ,
datasheets etc.) to assist with installation, operation, and diagnostics.
For additional support the user can use either of the following:
Contact Us web link www.aparian.com/contact-us
Support email [e-mail]