Apeks Black Ice Twin Cylinder Kit User manual

Valve Strap
Loops
Lock Ends
Cylinder Pad Apeks Black Ice Twin Cylinder Kit
PN 427106
Installation of Black Ice Twin Cylinder Kit
READ ALL INSTRUCTIONS PRIOR TO ASSEMBLY
Figure 1
Contents:
• (1) Valve Strap
• (2) Removable Buckles
• (1) Twin Cylinder Block
• (1) GripLock™ Cylinder Band
1Unbuckle the valve strap and locate valve strap loops.
These are sewn into the harness
on both sides of the valve strap
slot (Fig. 1).
Literature PN 18318 Rev. 10/12
If you have any questions regarding the information found in this manual, please
contact your regional Apeks Dealer or Distributor. Distributor contact information
is available on the Apeks website at www.apeks.co.uk
CONSULT THE BLACK ICE OWNER’S MANUAL THAT CAME WITH YOUR
BC FOR INFORMATION ON MAXIMUM CYLINDER CAPACITY, ADJUSTING /
SECURING THE GRIPLOCK™ CYLINDER BANDS AND VALVE STRAPS.
BLACK ICE TWIN CYLINDER SETUP COMPLETE
9Position the GripLock™ buckle so the black cylinder pad (with Apeks logo) is facing up. Insert the cylinder band through the slot in the GripLock™
buckle, secure hook and loop material (Figs. 13 & 14).
Figure 13 Figure 14
Figure 2
2Insert open end of removable buckle through the valve strap loop. Lock the end of the removable buckle. Repeat the process for other side (Figs. 2 & 3).
Figure 3

1 2 3 4
Outer
Buckle
7Position the GripLock™ buckle so the black cylinder pad (with Apeks logo) is facing up. Insert the cylinder band through the slot in the GripLock™
buckle, secure hook and loop material (Figs. 9 & 10).
Figure 9 Figure 10
8Lay the cylinder band with the hook and loop side face-up. Insert the square end of the cylinder band into slot (3) (Fig. 11). Turn the BC over
and lift up the back pad. Insert the strap through the metal slide of the cylinder
block and out slot (4) (Fig. 12). Feed enough webbing through to reattach the
GripLock™ buckle.
Figure 11 Figure 12
CAUTION: It is essential to weave the GripLock™ cylinder bands
through the slots in the correct order and direction. Failure to do so
will result in improper set up of the Black Ice twin cylinder kit.
3Connect one end of the valve strap with two male buckles
to the outer female buckle on left
side of the BC (Fig. 4).
5There are four cylinder band slots (1-4) in the Wrapture Harness,
each GripLock™ cylinder band will
use two of the slots (Fig. 6).
Figure 4
Figure 5
Figure 6
6Lay the cylinder band with the hook and loop side face-up. Insert the square end of the cylinder band into slot (2) (Fig. 7). Turn the BC over
and lift up the back pad. Place the twin cylinder block directly over slots (2 &
3) under the back pad. Insert the strap through the metal slide of the cylinder
block and out slot (1) (Fig. 8). Feed enough webbing through to reattach the
GripLock™ buckle.
Figure 7 Figure 8
4Remove both GripLock™ buckles from the cylinder bands (Fig. 5).
Cylinder Pad