Apeks 427106 User manual

© 2014 Apeks
Apeks Black Ice Twin Cylinder Kit
PN 427106
Installation of Black Ice Twin Cylinder Kit
Read all instructions prior to assembly
Contents:
• (1) Valve Strap
• (2) Removable Buckles
• (1) Twin Cylinder Block
• (1) GripLock™ Cylinder Band
1. Unbuckle the valve strap and locate valve strap
loops. These are sewn into the harness on both
sides of the valve strap slot (Fig. 1).
Valve Strap
Loops
2. Insert open end of removable buckle through the valve strap loop. Lock the end of the removable buckle.
Repeat the process for other side (Figs. 2 & 3).
Lock Ends
Figure 2 Figure 3
Figure 1

© 2014 Apeks
3. Connect one end of the valve strap with two
male buckles to the outer female buckle on left
side of the BC (Fig. 4).
1 2 3 4
Outer
Buckle
4. Remove both GripLock™ buckles from the
cylinder bands (Fig. 5).
5. There are four cylinder band slots (1-4) in the
Wrapture Harness, each GripLock™ band will
use two of the slots (Fig. 6).
CAUTION: It is essential to weave the GripLock™ cylinder bands through the slots in
the correct order and direction. Failure to do so will result in improper set up of the
Black Ice twin cylinder kit.
Figure 4
Figure 5
Figure 6

© 2014 Apeks
6. Lay the cylinder band with the hook and loop side face-up. Insert the square end of the cylinder
band into slot (2) (Fig. 7). Turn the BC over and lift up the back pad. Place the twin cylinder block
directly over slots (2 & 3) under the back pad. Insert the strap through the metal slide of the cylinder
block and out slot (1) (Fig. 8). Feed enough webbing through to reattach the GripLock™ buckle.
7. Position the GripLock™ buckle so the black cylinder pad (with Apeks logo) is facing up. Insert the
cylinder band through the slot in the GripLock™ buckle, secure hook and loop material (Figs. 9 & 10).
Cylinder Pad
Figure 7 Figure 8
Figure 9 Figure 10
8. Lay the cylinder band with the hook and loop side face-up. Insert the square end of the cylinder
band into slot (3) (Fig. 11). Turn the BC over and lift up the back pad. Insert the strap through the
metal slide of the cylinder block and out slot (4) (Fig. 12). Feed enough webbing through to reattach
the GripLock™ buckle.
Figure 11 Figure 12

© 2014 Apeks
9. Position the GripLock™ buckle so the black cylinder pad (with Apeks logo) is facing up. Insert the cylinder
band through the slot in the GripLock™ buckle, secure hook and loop material (Figs. 13 & 14).
Cylinder Pad
CONSULT THE BLACK ICE OWNER’S MANUAL THAT CAME WITH YOUR BC FOR INFORMATION
ON MAXIMUM CYLINDER CAPACITY, ADJUSTING / SECURING THE GRIPLOCK™ CYLINDER
BANDS AND VALVE STRAPS.
BLACK ICE TWIN CYLINDER SETUP COMPLETE
If you have any questions regarding the information found in this manual, please contact your regional Apeks
Dealer or Distributor. Distributor contact information is available on the Apeks website at: www.apeks.co.uk
Figure 13 Figure 14